Miniaturized Development of Microwave Power Divider Using High-Tc Superconductors

고온초전도체를 이용한 마이크로파 전력분배기의 소형화 개발

  • 정동철 (우석대학교 전기전자공학과) ;
  • 유병화 (우석대학교 전기공학과) ;
  • 곽민환 (전자통신연구원 테라전자팀) ;
  • 강광용 (전자통신연구원 테라전자팀) ;
  • 한병성 (전북대학교 전기공학과)
  • Published : 2009.09.01

Abstract

In this paper, We report the miniaturization of superconducting microwave power dividers based on lumped element equivalent circuits. To do this, we analyzed a conventional branch-type power divider by using an ABCD matrix under even and odd mode excitation. Then, we calculated each lumped element impedance throughout this analysis of a transmission line matrix. Also we simulated our equivalent circuits made of lumped elements by using a full wave analysis, em Sonnet. Our deign of microwave power divider based on simulated results was fabricated on high-$T_c$ superconducting thin films deposited on MgO substrate. Experimental results were reported in terms of bandwidth, center frequency, and phase difference between $S_{21}$ and $S_{31}$. We confirm that our design will be useful in the future microwave power systum.

Keywords

References

  1. M. J. Lancater, Passive Microwave Device Application of hign temperature superconductors, Cambridge University Press. Cambridge UK, 1997
  2. 김향곤, 최충석, 김동욱, 최효상, " 비닐절연선의 산화물 성장특성과 화재조사에의 적용", 전기학회 논문지 P권, vol. 56, no. 1, pp. 37-44, 2007
  3. 조용선, 박형민, 정수복, 최효상, "2차권선의 연결방법에 따른 변압기형 초전도 한류기 특성", 전기학회 논문지 P권, vol. 52, no. 12, pp.2078~3083, 2007
  4. M. A. Richard, K. B. Bashin, and P. C. Claspy, "Superconducting microstrip antennas: an experimental comparison of two feeding methods," IEEE Trans. Antennas Propagat., Vol.41, No.7, pp.967-974, 1993 https://doi.org/10.1109/8.237630
  5. Dong Chul. Chung et. al., "Comparison Between High-Tc Superconducting Microstip Filters and Normal Conducting Counterparts", IEEE Trans on Applied supercond., vol. 9 no. 2 pp.3882-3885, 1999 https://doi.org/10.1109/77.783875
  6. David M. Pozer, Microwave Engineering, John Wiley & Sons, NewYork, USA, 1998