DOI QR코드

DOI QR Code

확률.신뢰도 기법을 적용한 CFRP 플레이트 표면매립보강 콘크리트 철도교의 임계보강비 산정

Critical Strengthening Ratio of CFRP Plate Using Probability and Reliability Analysis for Concrete Railroad Bridge Strengthened by NSM

  • 발행 : 2009.12.31

초록

철도교량은 일반적으로 공용기간동안 진동과 충격에 의한 구조적 영향을 받는다. 이와 같은 이유로 내하력 증진을 위한 보강성능 검토 시 철도교에 작용하는 외부하중에 효율적으로 저항할 수 있는 보강성능이 요구된다. 이 연구에서는 철도교의 공용 중 진동 및 충격하중에 효율적으로 저항할 수 있는 보강공법으로써 NSM 보강공법을 제안하였다. 이는 기존 탄소섬유외부부착 공법에 비해 부착성능 및 보강성능이 우수한 공법이다. NSM 보강공법은 현재 다양한 실험적 연구들이 진행되고 있으나, 실교량으로의 범용적인 적용을 위해서는 보강설계에 필요한 합리적인 보강비 산정이 필수적이다. 이를 위해, 이 연구에서는 재료적 및 기하학적 불확실성이 반영된 확률 신뢰도기반 NSM 보강비 산정방법을 제안하여 임계보강비를 산정하고자 한다. 이를 위해, Monte Carlo Simulation(MCS) 기법으로 도출된 재료 및 단면치수에 대한 불확실성 특성을 내부저항모멘트 설계식에 반영하여, 외부활하중의 불확실성 특성이 반영된 외부하중모멘트에 대한 안전도 평가를 수행하였으며, 목표신뢰성지수 3.5를 만족할 수 있도록 하는 CFRP 플레이트의 임계보강비를 산출하였다.

The railroad bridges have been usually experienced by vibration and impact in service state. With this reason, it is important that the effective strengthening capacity should be considered to resist the kind of service loading. In this study, NSM strengthening technique is recommended for the concrete railroad bridge because of its better effective resistance for dynamic loading condition and strengthening cost than the conventional externally bonded strengthening using fiber sheet. However, to widely apply NSM method for the concrete railroad bridge, it needs that the strengthening ratio has to be reasonably evaluated with geometrical and material uncertainties, especially for the concrete bridge under long-term service state without the apparent design history and detail information such as concrete compressive strength, reinforcing ratio, railroad characteristics. The purpose of this study is to propose the critical strengthening ratio of CFRP plate for the targeted concrete railroad bridge with uncertainties of deterioration of the structures. To do this, Monte Carlo Simulation (MCS) for geometrical and material uncertainties have been applied so that this approach may bring the reasonable strengthening ratio of CFRP plate considering probabilistic uncertainties for the targeted concrete railroad bridge. Finally, the critical strengthening ratio of NSM strengthened by CFRP plate is calculated by using the limit state function based on the target reliability index of 3.5.

키워드

참고문헌

  1. El-Hacha, R. and Rizkalla, S. H., “Near-surface-mounted Fiber-reinforced Polymer Reinforcements for Flexural Strengthening of Concrete Structures,” ACI Structural Journal, Vol. 101, No. 5, 2004, pp. 717-726
  2. El-Hacha, R., Green, M., and Wright, G., “Retrofitting of Severely Damaged Concrete Beams Using Prestressed CFRP Sheets,” Advanced Composite Materials in Bridge and Structures(ACMBS), Vol. 3, 2000, pp. 529-536
  3. Saadatmanesh, H. and Ehsani, M. R., “Fibre Composite Bar for Reinforced Concrete Construction,” Journal Composite Materials, Vol. 251, 1991, pp. 188-203 https://doi.org/10.1177/002199839102500204
  4. Sharif, A., Al-Sulaimani, G. J., Basunbul, I. A., Baluch, M. H., and Ghaleb, B. N., “Strengthening of Initially Loaded Reinforced Concrete Beams Using FRP Plates,” ACI Structural Journal, Vol. 91, No. 2, 1994, pp. 160-168
  5. Barros, J. A. O. and Fortes, A. S., “Flexural Strengthening of Concrete Beams with CFRP Laminates Bonded into Slits,” Cement and Concrete Composites, Vol. 27, Issue 4, 2005, pp. 471-480 https://doi.org/10.1016/j.cemconcomp.2004.07.004
  6. Cruz, J. M. S., Barros J. A. O., Gettu, R., and Azevedo, A. F. M., “Bond Behavior of Near-surface Mounted CFRP Laminate Strips under Monotonic and Cyclic Loading,” Journal of Composites for Construction, ASCE, Vol. 10, No. 4, 2006, pp. 295-303 https://doi.org/10.1061/(ASCE)1090-0268(2006)10:4(295)
  7. Joshua, B. and Quattlebaum, et al., “Comparison of Three Flexural Retrofit Systems under Monotonic and Fatigue Loads,” Journal of Composites for Construction, ASCE, Vol. 10, No. 6, 2005, pp. 731-740 https://doi.org/10.1061/(ASCE)1084-0702(2005)10:6(731)
  8. Lorenzis, L. De. and Teng, J. G., “Near-surface Mounted FRP Reinforcement: An Emerging Technique for Strengthening Structures,” Composites Part B: Engineering, Vol. 38, 2007, pp. 119-143 https://doi.org/10.1016/j.compositesb.2006.08.003
  9. Parretti, R. and Nanni, A., “Strengthening of RC Members Using Near Surface Mounted FRP Composites: Design Overview,” Adv. Struct. Eng., Vol. 7, Issue 4, 2004, pp. 469-483 https://doi.org/10.1260/1369433042863198
  10. 강재윤, 박영환, 박종섭, 유영준, 정우태, “NSM 보강 RC 보의 보강 상세에 대한 매개변수 해석,” 대한토목학회 정기 학술대회 논문집, 2005, pp. 2286-2289
  11. 한국도로공사, 유지보수 공종별 단가집, 한국도로공사, 2007
  12. (주)일육시스템, 한상훈, 탄소판을 이용한 구조물 내하력 보강을 위한 홈 삽입공법 및 보강량 설계기법, 신기술보고서, 2001, pp.1-184
  13. 황선근, 오지택, 이준석, 이희업, 최진유, 방춘석, 최일윤, 김현민, “철도시스템 성능향상 핵심기술개발-궤도토목분야,” 한국철도기술연구원, 2003, pp. 1-228
  14. 오병환, 고재군, 백신원, 이형준, 한승환, “철근콘크리트구조물의 합리적인 신뢰성해석 연구,” 대한토목학회논문집, 13권, 2호, 1993, pp. 121-133
  15. U. S. Department of Commrece/National Bureau of Standards, “Development of a Probability Based Load Criteria for American National Standard A58,” NBS Special Publication 577, 1980, pp. 1-222
  16. 조효남, 최현호, 이상윤, 선종완, “상시 계측 데이터를 이용한 신뢰성에 기초한 판형 철도교의 내하력 평가법,” 한국강구조학회 논문집, 15권, 2호, 2003, pp. 187-196
  17. Ellingwood, B., “Reliability Bases of Load and Resistance Factors for Reinforced Concrete Design,” National Bureau of Standards Building Science Series 110, Washington, D.C., 1978
  18. Mirza, S. A., “Monte Carlo Simulation of Dispersions in Composite Steel-concrete Column Strength Interaction,” Engineering Structures, Vol. 20, No. 1-2, 1997, pp. 97-104 https://doi.org/10.1016/S0141-0296(97)00049-7
  19. 김상효, 조형근, 배규웅, 박홍석, “구조물의 신뢰성에 관한 연구,” 한국건설기술연구원, 1989, pp. 1-180
  20. American Concrete Institute Technical Committee 440, “Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures,” American Concrete Institute, ACI 440.2R-08, 2008, 24 pp
  21. AASHTO, “AASHTO LRFD Bridge Design Specifications,” American Association of Highway and Transportation Officials, 2004