Development of selectable observation point test architecture in the Boundry Scan

경계면스캔에서의 선택가능한 관측점 시험구조의 개발

  • 이창희 (계명문화대학 컴퓨터학부) ;
  • 장영식 (계명문화대학 컴퓨터학부)
  • Published : 2008.07.31

Abstract

In this paper, we developed a selectable observation Point test architecture and test procedure for clocked 4-bit synchronous counter circuit based on boundary scan architecture. To develope, we analyze the operation of Sample/Preload instruction on boundary scan architecture. The Sample/Preload instruction make Possible to snapshot of outputs of CUT(circuit under test) at the specific time. But the changes of output of CUT during normal operation are not possible to observe using Sample/Preload in typical scan architecture. We suggested a selectable observation point test architecture that allows to select output of CUT and to observe of the changes of selected output of CUT during normal operation. The suggested a selectable observation point test architecture and test procedure is simulated by Altera Max 10.0. The simulation results of 4-bit counter shows the accurate operation and effectiveness of the proposed test architecture and procedure.

경계면 스캔 구조는 시험대상회로의 출력 값들을 캡쳐하여 스캔경로를 이용하여 TDO로 직렬출력하여 출력 값을 관찰할 수 있는 시험구조이며, Sample/preload명령어를 이용하여 시험대상회로의 특정한 한 순간의 출력만을 캡쳐하여 직렬출력하여 분석할 수 있다. 본 논문에서는 4비트 비동기 카운터회로를 시험대상회로로 선정하고, 정상동작중인 카운터의 특정 출력을 지정하여 특정한 순간의 정적인 출력이 아닌, 연속적인 동적인 출력 값들을 다른 출력결과의 영향 없이 지속적으로 TDO로 출력하여 관찰할 수 있는 선택 가능한 관측점을 가진 시험구조와 시험절차를 개발하였다. 본 논문에서 제안하는 선택 가능한 관측점을 가진 시험구조는 표준에서 정한 시험동작을 정상적으로 수행하며, 관측점의 설정을 위한 명령어가 추가되었다. 4비트 카운터회로에 제안된 선택 가능한 관측점 시험구조를 적용 설계하고, 관측점 설정 명령어를 사용한 시험절차를 Altera의 Max 10.0을 이용한 시뮬레이션을 통해 동작의 정확성을 확인하였다.

Keywords