DOI QR코드

DOI QR Code

Evaluation of base shield plates effectiveness in reducing the drag of a rough circular cylinder in a cross flow

  • EL-Khairy, Nabil A.H. (Department of Civil Engineering, University of Jordan)
  • 투고 : 2008.02.03
  • 심사 : 2008.07.15
  • 발행 : 2008.10.25

초록

An experimental investigation has been conducted to determine the effectiveness of base shield plates in reducing the drag of a rough circular cylinder in a cross flow at Reynolds numbers in the range $3{\times}10^4{\leq}Re{\leq}10.5{\times}10^4$. Three model configurations were investigated and compared: a plane cylinder (PC), a cylinder with a splitter plate (MC1) and a cylinder fitted with base shield plates (MC2). Each configuration was studied in the sub and supercritical flow regimes. The chord of the plates, L, ranged from 0.22 to 1.50D and the cavity width, G, between the plates was in the range from 0 to 0.93D. It is recognized that base shield plates can be employed more effectively than splitter plates to reduce the aerodynamic drag of circular cylinders in both the sub- and supercritical flow regimes. For subcritical flow regime, one can get 53% and 24% drag reductions for the MC2 and MC1 models with L/D=1.0, respectively, compared with the PC model. For supercritical flow regime however, the corresponding drag reductions are 38% and 7%.

키워드

참고문헌

  1. Achenbach, E. (1971), "Influence of surface roughness on the cross - flow around a circular cylinder", J. Fluid Mech., 46, 321-335. https://doi.org/10.1017/S0022112071000569
  2. Achenbach, E. (1975), "Total and local heat transfer from a smooth circular cylinder in cross - flow at high Reynolds number", Int. J. Heat Mass Transfer, 18, 1387-1396. https://doi.org/10.1016/0017-9310(75)90252-5
  3. Akilli, H., Sahin, B. and Tumen, F. (2005), "Suppression of vortex shedding of circular cylinder in shallow water by a splitter plate", Flow Measurement and Instrumentation, 16, 211-219. https://doi.org/10.1016/j.flowmeasinst.2005.04.004
  4. Alam, M., Sakamoto, H. and Moriya, M. (2003), "Reduction of fluid forces acting on a single circular cylinder and two circular cylinders by using tripping rods", J. Fluids Struct, 18, 347-366. https://doi.org/10.1016/j.jfluidstructs.2003.07.011
  5. Anderson, E. and Szewczyk, A. (1997), "Effects of a splitter plate on the near wake of a circular cylinder in 2 and 3 - dimensional flow configurations", Exp. in Fluids, 23, 161-174. https://doi.org/10.1007/s003480050098
  6. Apelt, C.J., West, G.S. and Szewczyk, A.A. (1973), "The effects of wake splitter plates on the flow past a circular cylinder in the range 104 < R < 5'104", J. Fluid Mech., 61, 187-198. https://doi.org/10.1017/S0022112073000649
  7. Bearman, P.W. (1965), "Investigation of the flow behind a two-dimensional model with a blunt trailing edge and fitted with splitter plates", J. Fluid Mech., 21, 241-255. https://doi.org/10.1017/S0022112065000162
  8. Bouak, F. and Lemay, J. (1998), "Passive control of the aerodynamic forces acting on a circular cylinder", Experimental Thermal and Fluid Science, 16, 112-121. https://doi.org/10.1016/S0894-1777(97)10010-3
  9. Choi, B. and Choi, H. (2000), "Drag reduction with a sliding wall in a flow over a circular cylinder", AIAA J., 38(4), 715-717. https://doi.org/10.2514/2.1017
  10. Dalton, C., Xu, Y. and Owen, J.C. (2001), "The suppression of lift on a circular cylinder due to vortex shedding at moderate Reynolds numbers", J. Fluids Struct, 15, 617-628. https://doi.org/10.1006/jfls.2000.0361
  11. El-Khairy, N. (2003), "Drag reduction of a circular cylinder at subcritical flow regime using base shield plates" Wind Struct., An Int. J., 6(5), 347-356 .
  12. Hwang, J., Yang, k. and Sun, S. (2003), "Reduction of flow - induced forces on a circular cylinder using a detached splitter plate", Phys Fluids, 15(8), 2433-2436. https://doi.org/10.1063/1.1583733
  13. Hwang, J. and Yang, K. (2007), "Drag reduction on a circular cylinder using dual detached splitter plates", J. Wind Eng. Ind. Aerodyn., 95, 551-564. https://doi.org/10.1016/j.jweia.2006.11.003
  14. Kim, S. and Sakamoto, H. (2006), "Characteristics of fluctuating lift forces of a circular cylinder during generation of vortex excitation", Wind Struct., An Int. J., 9(2), 109-124. https://doi.org/10.12989/was.2006.9.2.109
  15. Igarashi, T., Tsutsui, T. and Kanbe, H. (1994), "Drag reduction of a circular cylinder (1st Report, Flow control using a small rod)", Trans. JSME, 60(573), 1554-1560. https://doi.org/10.1299/kikaib.60.1554
  16. Igarashi, T. (1986), "Effect of tripping - wires on the flow around a circular cylinder normal to an airstream", Bull. JSME, 29(255), 2917-2924. https://doi.org/10.1299/jsme1958.29.2917
  17. Isaev, A., Zhdanov, L. and Niemann, J. (2002), "Numerical study of the bleeding effect on the aerodynamics coefficients of circular cylinder", J. Wind Eng. Ind. Aerodyn., 90(11), p. 1217. https://doi.org/10.1016/S0167-6105(02)00253-2
  18. Kruiswyk, R. and Dutton, J.(1990), "Effects of a base cavity on subsonic near-wake flow", AIAA J., 28(11), 1885-1893. https://doi.org/10.2514/3.10495
  19. Kwon, S.H., Cho, J.W., Park, J.S. and Choi, H.S. (2002), "The effects of drag reduction by ribbons attached to cylindrical pipes", Ocean Eng., 29, 1945-1958. https://doi.org/10.1016/S0029-8018(02)00010-0
  20. Leea, J., Leea, I. and Parkb, W. (2004), "Reducing the drag on a circular cylinder by upstream installation of a small control rod", Fluid Dyn. Res., 34, 233-250. https://doi.org/10.1016/j.fluiddyn.2004.01.001
  21. Lesage, F. and Gartshore, I. (1987), "A method of reducing drag and fluctuating side force on bluff bodies", J. Wind Eng. Ind. Aerodyn., 25, 229-245. https://doi.org/10.1016/0167-6105(87)90019-5
  22. Nash, J.F., Quincey, V.G. and Callinan, J. (1963), "Experiments on two dimensional base flow at sub-sonic and transonic speeds". Aeronautical Research Council, R&M No. 3427.
  23. Nakamura, Y. (1996), "Vortex shedding from bluff bodies and a universal strouhal number", J. Fluids Struct., 10, 159-171. https://doi.org/10.1006/jfls.1996.0011
  24. Nakamura, Y. and Tomonari, Y. (1982), "The effects of surface roughness on the flow past circular cylinders at high Reynolds numbers", J. Fluid Mech., 123, 363-378. https://doi.org/10.1017/S0022112082003103
  25. Ozono S. (1999), "Flow control of vortex shedding by a short splitter plate asymmetrically arranged downstream of a cylinder", Phys Fluids, 11(10), 1070-6631
  26. Ozono, S. (2003), "Vortex suppression of the cylinder wake by deflectors", J. Wind Eng. Ind. Aerodyn., 91, 91-99. https://doi.org/10.1016/S0167-6105(02)00337-9
  27. Peil, U. and Behrens, M. (2002), "Fatigue of tubular steel lighting columns under wind load", Wind Struct., An Int. J., 5(5), 463-478. https://doi.org/10.12989/was.2002.5.5.463
  28. Rathakrishnan, E. (1999), "Effects of a splitter plate on bluff body drag", AIAA J., 37(9), 1125. https://doi.org/10.2514/2.823
  29. Ribeiro, J.D. (1991), "Effects of surface roughness on the two-dimensional flow past circular cylinders I: mean forces and pressures", J. Wind Eng. Ind. Aerodyn., 37(3), 299-309. https://doi.org/10.1016/0167-6105(91)90014-N
  30. Robertson, A.P., Hoxey, R.P., Short, J.L., Burgess, L.R., Smith, B.W. and Ko, R.H.Y. (2001), "Wind-induced fatigue loading of tubular steel lighting columns", Wind Struct., An Int. J., 4(2), 163-176. https://doi.org/10.12989/was.2001.4.2.163
  31. Stansby, P.K. (1974), "The effects of end plates on the base pressure coefficient of a circular cylinder", Aero. J., 87, 36-37.
  32. Szechenyi, E. (1975), "Supercritical Reynolds number simulation for two-dimensional flow over circular cylinders", J. Fluid Mech., 70, 529- 542. https://doi.org/10.1017/S0022112075002170
  33. Tanner, M. (1972), "A method for reducing the base drag of wings with blunt trailing edge", Aeronautical Quarterly, Vol. XXIII, 15-22.
  34. Tsutsui, T. and Igarashi, T. (2002), "Drag reduction of a circular cylinder in an air-stream", J. Wind Eng. Ind. Aerodyn., 90, 527-541. https://doi.org/10.1016/S0167-6105(01)00199-4
  35. Uematsu, Y., Tsujiguchi, N. and Yamada, M. (2001), "Mechanism of ovalling vibrations of cylindrical shells in cross flow", Wind Struct., An Int. J., 4(2), 85-100. https://doi.org/10.12989/was.2001.4.2.085
  36. Unal M.F. and Rockwell, D. (1987), "On vortex formation from a cylinder. Part 2. Control by splitter-plate interference", J. Fluid Mech., 190, 513-529.
  37. West, G.S. and Apelt, C.J. (1982), "The effects of tunnel blockage and aspect ratio on the mean flow past a circular cylinder with Reynolds numbers between 104 and 105", J. Fluid Mech., 114, 361-377. https://doi.org/10.1017/S0022112082000202
  38. Yajima, Y. and Samo, O. (1996), "A note on the drag reduction of a circular cylinder due to double rows of holes", Fluid Dyn. Res., 18, 237-243. https://doi.org/10.1016/0169-5983(96)00015-9
  39. Zdravkovich, M. (1997), Flow Around Circular Cylinders, Vol. 1: Fundamentals, Oxford University Press, Chap. 6.
  40. Zhang, P., Gao, L. and Wang, J. (2006), "Drag reduction of a disk with an upstream rod", Wind Struct., An Int. J., 9(3), 245-254. https://doi.org/10.12989/was.2006.9.3.245