DOI QR코드

DOI QR Code

Flexural ductility of reinforced HSC beams strengthened with CFRP sheets

  • 투고 : 2006.09.12
  • 심사 : 2008.09.10
  • 발행 : 2008.11.10

초록

Externally bonding fiber reinforced polymer (FRP) sheets with an epoxy resin is an effective technique for strengthening and repairing reinforced concrete (RC) beams under flexural loads. Their resistance to electro-chemical corrosion, high strength-to-weight ratio, larger creep strain, fatigue resistance, and nonmagnetic and nonmetallic properties make carbon fiber reinforced polymer (CFRP) composites a viable alternative to bonding of steel plates in repair and rehabilitation of RC structures. The objective of this investigation is to study the effectiveness of CFRP sheets on ductility and flexural strength of reinforced high strength concrete (HSC) beams. This objective is achieved by conducting the following tasks: (1) flexural four-point testing of reinforced HSC beams strengthened with different amounts of cross-ply of CFRP sheets with different amount of tensile reinforcement up to failure; (2) calculating the effect of different layouts of CFRP sheets on the flexural strength; (3) Evaluating the failure modes; (4) developing an analytical procedure based on compatibility of deformations and equilibrium of forces to calculate the flexural strength of reinforced HSC beams strengthened with CFRP composites; and (5) comparing the analytical calculations with experimental results.

키워드

참고문헌

  1. ACI Committee 318 (1989), "Building code requirements for reinforced concrete", American Concrete Institute, Detroit
  2. ACI (1992), "State-of-the-art report on high-strength concrete", ACI 363R, Detroit
  3. An, W., Saadatmanesh, H. and Ehsani, M.R. (1991), "RC beams strengthened with FRP plates II: Analysis and parametric study", J. Struct. Eng., 117(11), 3434-3455 https://doi.org/10.1061/(ASCE)0733-9445(1991)117:11(3434)
  4. Balaguru, P. and Kurtz, S. (1997), "Use of inorganic polymer-fiber composites for repair and rehabilitation of infrastructures", Proceeding of the International Conference on Repair and Rehabilitation of Reinforced Concrete Structures, 155-168
  5. Burg, R.G. and Ost, B.W. (1992), "Engineering properties of commercially available high-strength concretes", PCA Research & Development Bull, RD104T, Portland Cement Association, Skokie, Ill
  6. Buyukozturk, O. and Hearing, B. (1998), "Failure behavior of precracked concrete beams retrofitted with FRP", J. Compos. Constr., 2(3), 138-144 https://doi.org/10.1061/(ASCE)1090-0268(1998)2:3(138)
  7. Carrasquillo, R.L., Nilson, A.H. and Slate, F.O. (1981), "Properties of high strength concrete subject to shortterm loads", J. Am. Concr. Inst., 78(3), 171-178
  8. Fanning, P.J. and Kelly, O. (2001), "Ultimate response of RC beams strengthened with CFRP plates", J. Compos. Constr., 5(2), 122-127 https://doi.org/10.1061/(ASCE)1090-0268(2001)5:2(122)
  9. Federation Internationale de la Precontrainte/Comite Euro-International du Beton (FIP/CEB), (1990), "High strength concrete: State of the art report", Bull. d'Information No. 197, London
  10. GangaRao, H.V.S. and Vijay, P.V. (1998), "Bending behavior of concrete beams wrapped with carbon fabric", J. Struct. Eng., 124(1), 3-10 https://doi.org/10.1061/(ASCE)0733-9445(1998)124:1(3)
  11. Grace, N.F., Sayed, G.A., Soliman, A.K. and Saleh, K.R. (1999), "Strengthening reinforced concrete beams using fiber reinforced polymer (FRP) laminates", ACI Struct. J., 96(5), 865-874
  12. Hognestad, E., Hanson, N.W. and McHenry, D. (1955), "Concrete stress distribution in ultimate strength design", ACI J., Proceedings, 52(12), 455-479
  13. Maghsoudi, A.A. and Akbarzadeh, H. (2006), "Flexural ductility of HSC members", Struct. Eng. Mech., 24(2),195-213 https://doi.org/10.12989/sem.2006.24.2.195
  14. Maghsoudi, A.A. (1996), "Design for ductility of structures", Shaheed Bahonar University Publications, Kerman, Iran
  15. Malek, A.M., Saadatmanesh, H. and Ehsani, M.R. (1998), "Prediction of failure load of R/C beams strengthened with FRP plate due to stress concentration at the plate end", ACI Struct. J., 95(2), 142-152
  16. Mansur, M.A., Wee, T.H. and Chin, M.S. (1994), "Some engineering properties of locally produced high-strength concrete", Proc., 19th Conf. on our World in Concrete and Structures, CI-Premier Pte. Ltd., Singapore, 97- 106
  17. Mukhopadhyaya, P., Swamy, N. and Lynsdale, C. (1998), "Optimizing structural response of beams strengthened with GFRP plates", J. Compos. Constr., 2(2), 87-95 https://doi.org/10.1061/(ASCE)1090-0268(1998)2:2(87)
  18. Naaman, A. and Joeng, S. (1995), "Structural ductility of concrete prestressed beams with FRP tendons", Proceeding of the Second International RILEM Symposium - Non Metallic (FRP) Reinforcment for Concrete Structures, Ghent, Belgium, 379-386
  19. Oztekin, E., Pul, S. and Husem, M. (2003), "Determination of rectangular stress block parameters for high performance concrete", J. Eng. Struct., 25, 371-376 https://doi.org/10.1016/S0141-0296(02)00172-4
  20. Park, R. and Paulay, T. (1975), "Reinforced concrete structures", Wiley, New York. Paster, J.A., Nilson, A.H. and Slate, F.O., "Behavior of high-strength concrete beams", Report No. 84-3, Department of Structural Engineering, Cornell University, Ithaca, NY, Feb, 1984, 311
  21. Rabinovitch, O. and Frostig, Y. (2000), "Closed-form high-order analysis of RC beams strengthened with FRP strips", J. Compos. Constr., 4(2), 65-74 https://doi.org/10.1061/(ASCE)1090-0268(2000)4:2(65)
  22. Rahimi, H. and Hutchinson, A. (2001), "Concrete beams strengthened with externally bonded FRP plates", J. Compos. Constr., 5(1), 44-56 https://doi.org/10.1061/(ASCE)1090-0268(2001)5:1(44)
  23. Rashid, M.A., Mansur, M.A. and Paramasivam, P. (2002), "Correlations between mechanical properties of highstrength concrete", J. Mater. Civil Eng., 14(3), 230-238 https://doi.org/10.1061/(ASCE)0899-1561(2002)14:3(230)
  24. Ross, C.A., Jerome, D.M., Tedesco, J.W. and Hughes, M.L. (1999), "Strengthening of reinforced concrete beams with externally bonded composite laminates", ACI Struct. J., 96(2), 212-220
  25. Saadatmanesh, H. and Ehsani, M.R. (1991), "RC beams strengthened with GFRP plates, I: Experimental study", J. Struct. Eng., 117(11), 3417-3433 https://doi.org/10.1061/(ASCE)0733-9445(1991)117:11(3417)
  26. Sharif, A., Al-Sulaimani, G.J., Basunbul, I.A., Baluch, M.H. and Ghaleb, B.N. (1994), "Strengthening of initially loaded reinforced concrete beams using FRP plates", ACI Struct. J., 91(2), 160-168
  27. Sonobe, Y. et al. (1997), "Design guidelines of FRP reinforced concrete building structures", J. Compos. Constr., 1(3), 90-115 https://doi.org/10.1061/(ASCE)1090-0268(1997)1:3(90)
  28. Spadea, G., Bencardino, F. and Swamy, R.N. (1998), "Structural behavior of composite RC beams with externally bonded CFRP", J. Compos. Constr., 2(3), 132-137 https://doi.org/10.1061/(ASCE)1090-0268(1998)2:3(132)
  29. Toutanji, H., Zhao, L. and Zhang, Y. (2006), "Flexural behavior of reinforced concrete beams externally strengthened with CFRP sheets bonded with an inorganic and inorganic matrix", J. Eng. Struct., 28, 557-566 https://doi.org/10.1016/j.engstruct.2005.09.011

피인용 문헌

  1. Experimental and analytical investigation of reinforced high strength concrete continuous beams strengthened with fiber reinforced polymer vol.31, pp.3, 2010, https://doi.org/10.1016/j.matdes.2009.09.041
  2. Performance of HSC columns under severe cyclic loading vol.13, pp.2, 2015, https://doi.org/10.1007/s10518-014-9617-x
  3. Moment redistribution and ductility of CFRP strengthened and non-strengthened unbonded post-tensioned indeterminate I-beams composed of UHSSCC vol.174, 2017, https://doi.org/10.1016/j.compstruct.2017.04.057
  4. New hybrid cement-based composite material externally bonded to control RC beam cracking vol.36, 2012, https://doi.org/10.1016/j.conbuildmat.2012.04.104
  5. Experimental investigations and verification of debonding strain of RHSC continuous beams strengthened in flexure with externally bonded FRPs vol.43, pp.6, 2008, https://doi.org/10.1617/s11527-009-9550-7
  6. Normalised rotation capacity for deformability evaluation of high-performance concrete beams vol.1, pp.3, 2008, https://doi.org/10.12989/eas.2010.1.3.269
  7. Minimum deformability design of high-strength concrete beams in non-seismic regions vol.8, pp.4, 2008, https://doi.org/10.12989/cac.2011.8.4.445
  8. Design for moment redistribution in FRP plated RC beams vol.38, pp.6, 2008, https://doi.org/10.12989/sem.2011.38.6.697
  9. Design for moment redistribution in FRP plated RC beams vol.38, pp.6, 2008, https://doi.org/10.12989/sem.2011.38.6.697
  10. Inelastic design of high-axially loaded concrete columns in moderate seismicity regions vol.39, pp.4, 2008, https://doi.org/10.12989/sem.2011.39.4.559
  11. Concurrent flexural strength and deformability design of high-performance concrete beams vol.40, pp.4, 2008, https://doi.org/10.12989/sem.2011.40.4.541
  12. A stress-function variational approach toward CFRP -concrete interfacial stresses in bonded joints vol.9, pp.1, 2008, https://doi.org/10.12989/acc.2020.9.1.043
  13. Identification of Fracture Mechanic Properties of Concrete and Analysis of Shear Capacity of Reinforced Concrete Beams without Transverse Reinforcement vol.13, pp.12, 2008, https://doi.org/10.3390/ma13122788
  14. Performance of an innovative anchorage system for strengthening RC beams in adjacency of columns with FRP laminates vol.28, pp.None, 2008, https://doi.org/10.1016/j.istruc.2020.08.075
  15. An innovative technique of anchoring lacing bars with CFS sections for shear strengthening of RC beams vol.7, pp.1, 2008, https://doi.org/10.1007/s41062-021-00722-7