DOI QR코드

DOI QR Code

A methodology to estimate earthquake induced worst failure probability of inelastic systems

  • Akbas, Bulent (Department of Earthquake and Structural Science, Gebze Institute of Technology) ;
  • Nadar, Mustafa (Department of Mathematics, Gebze Institute of Technology) ;
  • Shen, Jay (Department of Civil and Architectural Engineering, Illinois Institute of Technology)
  • 투고 : 2005.07.29
  • 심사 : 2007.12.05
  • 발행 : 2008.05.30

초록

Earthquake induced hysteretic energy demand for a structure can be used as a limiting value of a certain performance level in seismic design of structures. In cases where it is larger than the hysteretic energy dissipation capacity of the structure, failure will occur. To be able to select the limiting value of hysteretic energy for a particular earthquake hazard level, it is required to define the variation of hysteretic energy in terms of probabilistic terms. This study focuses on the probabilistic evaluation of earthquake induced worst failure probability and approximate confidence intervals for inelastic single-degree-of-freedom (SDOF) systems with a typical steel moment connection based on hysteretic energy. For this purpose, hysteretic energy demand is predicted for a set of SDOF systems subject to an ensemble of moderate and severe EQGMs, while the hysteretic energy dissipation capacity is evaluated through the previously published cyclic test data on full-scale steel beam-to-column connections. The failure probability corresponding to the worst possible case is determined based on the hysteretic energy demand and dissipation capacity. The results show that as the capacity to demand ratio increases, the failure probability decreases dramatically. If this ratio is too small, then the failure is inevitable.

키워드

참고문헌

  1. Akbas, B., Shen, J. and Hao, H. (2001), "Energy approach in performance-based seismic design of steel moment resisting frames for basic safety objective", The Struct. Design of Tall Buildings, 10, 193-317 https://doi.org/10.1002/tal.172
  2. ATC 40 (1996), Seismic Evaluation and Retrofit of Concrete Buildings. Volume 1, Applied Technology Council
  3. Bertero, V.V. (2005), "Performance-based earthquake hazard reduction - its application to performance-based seismic design of rc buildings", Earthquake Engineering: Essentials and Application Seminar Series, Middle East Technical University, July 18-20, Turkey
  4. Bertero, R.D. and Bertero, V.V. (1999), "Redundancy in earthquake resistant design", J. Struct. Eng., 125(1), 81-88 https://doi.org/10.1061/(ASCE)0733-9445(1999)125:1(81)
  5. Chai, Y.H. and Fajfar, P. (2000), "A procedure for estimating input energy spectra for seismic design", J. Earthq. Eng., 4(4), 539-561 https://doi.org/10.1142/S1363246900000242
  6. Choi, B.J. and Shen, J. (2001), "Empirical hysteretic energy with strength, strength and drift, and SCWB designs using steel moment-resisting frames", Struct. Design Tall Build., 10, 93-106 https://doi.org/10.1002/tal.167
  7. Chou, C. and Uang, C. (2000), "Establishing absorbed energy spectra - an attenuation approach", Earthq. Eng. Struct. D., 29, 1441-1455 https://doi.org/10.1002/1096-9845(200010)29:10<1441::AID-EQE967>3.0.CO;2-E
  8. Chou, C. and Uang, C. (2003), "A procedure for evaluating seismic energy demand of framed structures", Earthq. Eng. Struct. D., 32, 229-244 https://doi.org/10.1002/eqe.221
  9. Chou, C. and Uang, C. (2004) "Evaluating distribution of seismic energy in multistory frames", 13th World Conf. on Earthquake Engineering, Vancouver, B.C., Canada, August 1-6, Paper No. 24
  10. Cruz, A.M.F. and Lopez, O.A. (2000), "Plastic energy during an earthquake as a fraction of structural properties and ground motion characteristics", Eng. Struct., 22, 784-792 https://doi.org/10.1016/S0141-0296(98)00139-4
  11. FEMA-273 (1997), BSSC Commentary to the NEHRP Recommended Provisions for Seismic Regulation of New Buildings and Other Structures, Federal Emergency Management Agency
  12. Hamburger, R.O. (1997), "A framework for performance-based earthquake resistant design", EERC-CUREs Symposium in Honor of V.V. Bertero, Berkeley, California. January 31-February 1
  13. Leger, P. and Dussault, S. (1992), "Seismic energy dissipation in MDOF structures", J. Struct. Eng., ASCE, 118(5), 1251-1269 https://doi.org/10.1061/(ASCE)0733-9445(1992)118:5(1251)
  14. Manfredi, G., Polese, M. and Cosenza, E. (2003), "Cumulative demand of the earthquake ground motions in the near source", Earthq. Eng. Struct. D., 32, 1853-1865 https://doi.org/10.1002/eqe.305
  15. Mollaioli, F., Bruno, S., Decanini, L. and Saragoni, R. (2004), "On the correlation between energy and displacement", 13th World Conf. on Earthquake Engineering, Vancouver, B.C., Canada, August 1-6, Paper No. 161
  16. Ordaz, M., Huerta, M. and Reinoso, E. (2003), "Exact computation of input-energy spectra from Fourier amplitude spectra", Earthq. Eng. Struct. D., 32, 597-605 https://doi.org/10.1002/eqe.240
  17. Ott, R.L. (1993), An Introduction to Statistical Methods and Data Analysis, PWS-Kent Publishing, Belmont, California
  18. Prakash, V., Powell, G.H. and Campbell, S. (1993), "DRAIN-2DX: Base program description and user guide, Version 1.10", Rep. No. UCB/SEMM-93/17, University of California, Berkeley
  19. Sari, A. (2003), "Energy consideration in groun motion attenuation & probabilistic seismic hazard studies", Ph.D. Thesis, Department of Civil Engineering, University of Texas at Austin
  20. Shen, J. and Akbas, B. (1999), "Seismic energy demand in steel moment frames", J. Earthq. Eng., 3(4), 519-559 https://doi.org/10.1142/S1363246999000223
  21. Tso, W.K., Zhu, T.J. and Heidebracht, A.C. (1993), "Seismic energy demands on reinforced concrete momentresisting frames", Earthq. Eng. Struct. D., 22, 533-545 https://doi.org/10.1002/eqe.4290220605
  22. Uang, C.M. and Bertero, V.V. (1990), "Evaluation of seismic energy in structures", Earthq. Eng. Struct. D., 19, 77-90 https://doi.org/10.1002/eqe.4290190108
  23. Uang, C.M. and Bertero, V.V. (1988), "Use of energy as a design criterion in earthquake-resistant design", Earthquake Engineering Research Center, Report No. UCB/EERC-88/18, University of California at Berkeley
  24. Vision 2000 Committee (1995), Structural Engineering Association of California (SEAOC)
  25. Yamaguchi, H. and El-Abd, A. (2003), "Effect of earthquake energy input characteristics on hysteretic damper effciency", Earthq. Eng. Struct. D., 32, 827-843 https://doi.org/10.1002/eqe.250
  26. Wadsworth, H.M. (1997), Handbook of Statistical Methods for Engineers and Scientists, McGrawHill Inc, NewYork

피인용 문헌

  1. An evaluation of energy response and cumulative plastic rotation demand in steel moment-resisting frames through dynamic/static pushover analyses vol.18, pp.4, 2009, https://doi.org/10.1002/tal.442
  2. Seismic performance of concrete moment resisting frame buildings in Canada vol.37, pp.2, 2011, https://doi.org/10.12989/sem.2011.37.2.233