Design & Manufacturing
- Volume 2 Issue 4
- /
- Pages.37-43
- /
- 2008
- /
- 2800-0323(pISSN)
- /
- 2733-452X(eISSN)
A Study on Sink Marks in Injection Molding of Boss Parts
보스부분 사출성형의 싱크마크 발생에 관한 연구
- Kim, Hyun-Pil (School of Computer Added Mold & Die Engineering, Korea Polytechnic VII College) ;
-
Kim, Yong-Jo
(School of Mechanical Engineering and Automation KYUNGNAM University)
- Received : 2008.05.19
- Accepted : 2008.07.25
- Published : 2008.08.01
Abstract
Supplementary features in injection molded products, which are boss, rib and snap fit, are mainly located in the products. These features might make molding flow improper in injection processing and consequently give rise to some of molding troubles such as short shot and hesitation. The sink mark on boss parts is generated by the volumetric shrinkage that is caused by both the molding thickness and the closed boss height. The volumetric shrinkage is affected by packing pressure and its amount tends to decrease by increasing the packing pressure. The packing pressure can therefore increase flow rate to a boss part and causes the sink mark depth to increase. As the molding thickness and the closed boss height in the boss part can increase the part volume, these may yield bad solidifying and also extend the molding cycle. In this paper, both the injection molding test and the flow analysis were carried out to investigate the effect of sink marks generated in the boss part of injection molded products.