DOI QR코드

DOI QR Code

Investigation of the Hydraulic Stability of Agricultural Drainage Channels Installed Water Purification Materials by using Flow-3D

Flow-3D를 활용한 수질정화체가 설치된 농업용 배수로의 안정성 조사

  • 김선주 (건국대학교 생명환경과학대학 사회환경시스템공학) ;
  • 박기춘 (한국건설기술연구원 수자원연구부 수자원연구실, 건국대학교 대학원 사회환경시스템공학과)
  • Published : 2007.09.30

Abstract

In this study, the effect of the purification materials is analyzed and tested by Flow 3D and Hydraulic model test. Three dimension numerical analysis led from the research that sees abnormal form and the size back of the water purification material conferred the flowing water conduct inside the test channel against the test condition. Comparison it analyzed the flux distribution, a water depth of the channel which establishes the water purification materials the cross section, an interval of the water purification material, a conference with general channel, it change executed. As a result, the cross section ratio of the purification materials against and a flux change from the test which it sees. The interval of the purification materials in order to prevent three dimension that follows in decrease of increase and flux must decide an interval.

Keywords

References

  1. Ko, 2004, Safety Analysis on the Environment Friendly Consolidated Canals and Small Streams, Konkuk University
  2. Park, 2007, Hydraulic Stability Investigation of Drainage Channels Installed Water Purification Materials, Konkuk University
  3. Kim, 2004, Numerical analysis of flow around bridge pier using FLOW-3D
  4. Lee, 2003, Development and application of porous hydraulic structure to improve water quality in small and middle streams, Kyunghee University
  5. Kim, 2005, Development of Multi-functional River Restoration Techniques, Korea Institute of Construction Technology
  6. Korea Rural Community & Agriculture Corporation, 2000, Agricultural land and water developmen
  7. Kim, 2005, Analysis of flow structure over agee-spillway in consideration of scale and roughness effects by using CFD model, KSCE journal of civil engineering. vol.9 no.2 (2005. 3), pp.161-169 https://doi.org/10.1007/BF02829067
  8. Park, 2002, 'Investigation on the Three-Dimensional Finite Element Analysis for Injection Molding using MPI/FLOW3D', International Moldflow User Group Conference, Boston, USA