DOI QR코드

DOI QR Code

Effect of pH Level on the Characteristics of a Landfill Clay Liner Material

pH에 따른 점토차수재의 특성

  • Jung, Soo-Jung (Korea Infrastructure Safety & Technology Corporation) ;
  • Lee, Yong-Su (Dept. of Civil Engrg., Korea Maritime Univ.) ;
  • Kim, Tae-Hyung (Division of Civil and Environmental Engrg., Korea Maritime Univ.)
  • 정수정 (한국시설안전기술공단 연구원) ;
  • 이용수 (한국해양대학교 토목공학과) ;
  • 김태형 (한국해양대학교 건설환경공학부)
  • Published : 2007.08.31

Abstract

In this study, experiments are conducted to find out the effect of waste leachate on landfill clay liner system. Tensile test, hydrometer analysis and crack pattern test were conducted on sand-bentonite mixtures with different pH values of water. The tensile strength of specimen compacted with pH 9 of water is smaller than that of specimen compacted with for pH 3 and 6 of water. That is, the higher the pH value, the smaller the tensile strength, because a higher pH solution decreases flocculation phenomenon. The percent finer also increased with high pH value in particle size distribution of fine grained soil (<0.075 mm), because the velocity of particles settling decreases. This trend becomes the clearer as the content of bentonite, becomes the larger, because the higher pH value decreases flocculation structure of fine soils. The results of the crack pattern tests also showed the effect of pH values of water.

본 연구에서는 폐기물 매립지에서 점토차수재에 대한 폐기물 침출수의 영향에 대해 알아보고자 모래-벤토나이트 혼합토를 사용하여 인장시험, 비중계분석, 균열패턴 관찰을 실시하였다. 인장시험 결과, pH 9의 혼합수를 사용하여 다짐한 공시체의 인장강도는 pH 3, pH6의 혼합수로 다짐한 공시체의 인장강도보다 작게 나타났다. 다시 말해, 인장강도는 높은 pH에서 감소하며 이것은 pH가 증가할수록 면모화현상이 감소하기 때문이다. 또한 비중계분석에서는 pH가 증가할수록 토립자의 침강속도가 느려져 세립자의 함유량이 높게 나타났다. 이것은 pH가 증가함에 따라 점토 입자의 면모구조가 감소하기 때문이며 이러한 경향은 벤토나이트의 함유량이 증가할수록 더욱 뚜렷하게 나타났다. 균열패턴 관찰 결과에서도 pH의 영향을 확인할 수 있었다.

Keywords

References

  1. 김찬기, 김태형,군영선, 국현숙 (2005), '개량된 일축관입시험에 의한 다짐된 화강풍화토의 인장강도 특성', 2005 대한토목학회 학술발표회
  2. 정수정, 김찬기, 김태형 (2006), '다짐된 모래- 벤토나이트 혼합토 의 인장강도와 산성도에 따른 혼합토의 균열패턴에 관한 연구', 2006 한국지반공학회 춘계학술발표회
  3. 장연수, 이광열 (2006), '지반환경공학', 구미서관, pp.3-7, 107-122, 144-152
  4. 한국지반공학회 (2004), '지반환경[폐기물 매립 및 토양환경]', 구미서관, pp.14-19
  5. 환경부 (1999, 2001), 폐기물 관리법
  6. Allen, A. (2001), 'Contaminant landfills: The myth of sustainability', Engineering Geology, Vol.60, pp.3-19 https://doi.org/10.1016/S0013-7952(00)00084-3
  7. Desai, C. S. and Ahn, T. B. (1995), 'Effect of chemical transport on seepage, stress-deformation and stability analysis of soil embankment', to be submitted
  8. Evans, J. C. and Fang, H. Y. (1986), 'Triaxial equipment for permeability testing with hazardous and toxic permeates', ASTM Geotechnical Testing Journal, 9(3), pp.126-132 https://doi.org/10.1520/GTJ10618J
  9. Fang, H. Y. (1997), 'Introduction to environmental geotechnology', CRC Press LLC, pp.169-173
  10. Fang, H. Y., Daniels, J. L. and Kim, T. H. (2004), 'Pollution intrusion on soil-pavement system', ASCE Journal of Transportation Engineering, Vol.130, No.4, pp.526-534 https://doi.org/10.1061/(ASCE)0733-947X(2004)130:4(526)
  11. Fernandez, F. and Quigley, R. M. (1988), 'Viscosity and dielectric constant controls on the hydraulic conductivity of clayey soils permeated with water soluble organics', Canadian Geotechnical Journal, 25, pp.582-589 https://doi.org/10.1139/t88-063
  12. Meegoda, J. N. and Rajapakse, R. A. (1993), 'Long-term hydraulic conductivities of contaminated clays', ASCE Env. Engineering Journal, 119(4), pp.725-743 https://doi.org/10.1061/(ASCE)0733-9372(1993)119:4(725)
  13. Naik, D. (1986), 'Effect of temperature and pore fluid on shear characteristics of clay', Proc. 1st international Symposium Environmental Geotechnology, 1, pp.382-390
  14. Naylor, J. A., Rowland, C. D., Young, C. P., and Barger, C. (1978), 'The investigation of land fill sites', Water Research Center, Herts, England, pp. 6
  15. Ogata, N., Yasuda, M. and Kataoka, T. (1982), 'Salt concentration effects of strength of frozen soils', Proc., 3th. Int. Symp. on Groudn Freezing, pp.3-10
  16. Philipp, J. A., Endell, R., Raguin, J. and Dechelette, W. (1986), 'Leaching test characterization of iron and steel industry waste', Hazadous and Industrial SolidWaste Testing Disposal, Vol. 6, ASTM STP 933, pp.7-27