DOI QR코드

DOI QR Code

Evaluation of dynamic properties of extra light weight concrete sandwich beams reinforced with CFRP

  • Naghipour, M. (Department of Civil Engineering, Mazandaran University) ;
  • Mehrzadi, M. (Department of Civil Engineering, Islamic Azad University (IAU))
  • 투고 : 2006.10.17
  • 심사 : 2007.11.07
  • 발행 : 2007.12.25

초록

Analytical and experimental investigation on dynamic properties of extra lightweight concrete sandwich beams reinforced with various lay ups of carbon reinforced epoxy polymer composites (CFRP) are discussed. The lightweight concrete used in the core of the sandwich beams was made up of extra lightweight aggregate, Lica. The density of concrete was half of that of the ordinary concrete and its compressive strength was about $100Kg/cm^2$. Two extra lightweight unreinforced (control) beams and six extra lightweight sandwich beams with various lay ups of CFRP were clamped in one end and tested under an impact load. The dimension of the beams without considering any reinforcement was 20 cm ${\times}$ 10 cm ${\times}$ 1.4 m. These were selected to ensure that the effect of shear during the bending test would be minimized. Three other beams, made up of ordinary concrete reinforced with steel bars, were tested in the same conditions. For measuring the damping capacity of sandwich beams three methods, Logarithmic Decrement Analysis (LDA), Hilbert Transform Analysis (HTA) and Moving Block Analysis (MBA) were applied. The first two methods are in time domain and the last one is in frequency domain. A comparison between the damping capacity of the beams obtained from all three methods, shows that the damping capacity of the extra lightweight concrete decreases by adding the composite reinforced layers to the upper and lower sides of the beams, and becomes most similar to the damping of the ordinary beams. Also the results show that the stiffness of the extra lightweight concrete beams increases by adding the composite reinforced layer to their both sides and become similar to the ordinary beams.

키워드

참고문헌

  1. Adams, R. D. and Bacon, D. G. C. (1973),"Effect of fiber orientation and laminate geometry on the dynamic properties of CFRP", Compos. Mater., 7, October, 402-428. https://doi.org/10.1177/002199837300700401
  2. Daniel, I. M. and Ishai, O. (1994), Engineering Mechanics of Composite Materials, New York, Oxford.
  3. Naghipour, M., Taheri, F. and Zou, G. (2005),"Evaluation of vibration damping of glass-reinforced-polymerreinforced glulam composite beams", J. Struct. Eng., ASCE, 131,(7).
  4. Maalej, M., Tanwongsval, S. and Paramasivam, P. (2003),"Modelling of rectangular RC columns strengthened with FRP", Cement Concrete Compos., 25(2), February, 263-276. https://doi.org/10.1016/S0958-9465(02)00017-3
  5. Mallic, P. K. (1993), Fiber-Reinforced Composites; Material, Manufacturing and Design, New York, NY, Marcel Dekker, Inc., 301.
  6. Smith, C. B. and Werely, N. M. (1997),"Composite rotorcraft flexbeams with viscoelastic damping layers for aeromechanical stability augmentation", M3D : Mechanics and Mechanisms of Material Damping, ASTM STP 1304, Wolfenden, A. and Kinra, V.K., Eds., 62-67.
  7. Stoll, F., E. Saliba, J. and E. Casper, L. (2000),"Experimental study of CFRP-prestressed high-strength concrete bridge beams", Compos. Struct, 49 (2), June, 191-200. https://doi.org/10.1016/S0263-8223(99)00134-8
  8. SAE Recommended Practice (1993),"Laboratory measurement of the composite vibration damping properties of materials on a supporting steel bar", SAE J1637 FEB93.
  9. Taheri, F., Shahin, K. and Widiarsa, I. (2002),"On the parameters influencing the performance of reinforced concrete beams strengthened with FRP plates", Compos. Struct., 58(2), November, 217-226. https://doi.org/10.1016/S0263-8223(02)00120-4
  10. Toutanji, H. and Ortiz, G. (2001)"The effect of surface preparation on the bond interface between FRP sheets and concrete members", Compos. Struct., 53(4), September, 457-462. https://doi.org/10.1016/S0263-8223(01)00057-5
  11. Yang, Q. S., Qin, Q. H. and Zheng, D. H. (2002),"Analytical and numerical investigation of interfacial stresses of FRP-concrete hybrid structure", Compos. Struct, 57(1-4), July, 221-226. https://doi.org/10.1016/S0263-8223(02)00088-0
  12. Yang, Z. J., Chen, J. F. and Proverbs, D. (2003),"Finite element modelling of concrete cover separation failure in FRP plated RC beams", Constr. Build. Mater., 17(1), February, 3-13. https://doi.org/10.1016/S0950-0618(02)00090-9
  13. Yim, J. H., Cho, S. Y., Seo, Y. J. and Jang, B. Z. (2003),"A study on material damping of 0o laminated composite sandwich cantilever beams with a viscoelastic layer", Compos. Struct., 367-374.
  14. Zou, G., Naghipour, M. and Taheri, F. (2003),"A nondestructive method for evaluating natural frequency of glued-laminated beams reinforced with GFRP", Nondestructive Testing and Evaluation, 19(1-2), 53-65. https://doi.org/10.1080/10589750310001596839

피인용 문헌

  1. Polynomial correction function for half-power bandwidth (HPB) method of damping of glulam beams reinforced with e-glass reinforced epoxy polymer (GRP) vol.36, pp.2, 2009, https://doi.org/10.1139/L08-097
  2. A study on natural frequencies and damping ratios of composite beams with holes vol.21, pp.6, 2016, https://doi.org/10.12989/scs.2016.21.6.1211
  3. Periodic Solutions and Nonlinear Analysis Used for Evaluating of Dynamic Properties of Glued-Laminated Beams Reinforced With GRP vol.78, pp.1, 2011, https://doi.org/10.1115/1.4002013
  4. Iterative neural network strategy for static model identification of an FRP deck vol.9, pp.5, 2009, https://doi.org/10.12989/scs.2009.9.5.445