초록
본 연구에서는 중금속으로 오염된 토양이나 자갈을 댐 축조 재료로 사용할 경우 주변 환경에 미치는 영향을 파악하기 위하여 댐 침투수와 오염물 거동에 대한 수치 모의를 실시하였다 두 가지 상용 프로그램(SEEP2D 와 FEMWATER)을 이용하여 침투수 분석을 수행하였으며, 결과를 상호 비교 분석함으로써 수치 모의의 신뢰성을 획득하였다. 특히 오염된 댐 축조재료로 인한 환경적 안정성을 검토하기 위하여 세 가지 시나리오, 즉 댐체에 균열이 없는 경우(시나리오 1), 댐의 차수벽 역할을 하는 표면 콘크리트 슬래브 상부에 균열이 발생하는 경우(시나리오 2), 댐체 하부 즉 프린스와 콘크리트 슬래브와 접촉부에 균열이 발생하는 경우(시나리오 3)에 대하여 각각 수치 모의를 실시하였다. 침투수 해석 결과, 슬래브 상부에 균열이 있는 경우, 즉 시나리오 2에서 계산된 단위폭당 침투수량은 $14.311\sim14.924m^3/day$으로 다른 경우에 비해 약 1,000배 큰 값을 보였다. 또한 FEMWATER프로그램을 사용하여 오염물 거동을 수치모의하였다. 오염물질이 지속적으로 침출되어 나오는 상황을 고려하여 주축조구역은 농도 13ppb가 지속적으로 유지되도록 초기조건을 설정하였다. 오염물 거동분석 결과 시나리오 1에서 2ppb 정도의 오염물이 댐체 하류 부분에 도달하는데 걸리는 시간은 최소 55,000년이었으며, 시나리오 2의 경우 약 50년 정도, 마지막으로 시나리오 3의 경우 27,000년이였다. 댐체 상부에 균열이 발생한 경우는 댐에 균열이 발생하지 않은 경우보다 약 500배 이상 빠른 유속이 나타나기 때문에 오염물도 균열이 발생하지 않은 경우에 비해 상당히 빠르게 퍼져나가는 것을 확인할 수 있었다. 결론적으로 슬래브 상부에 균열이 발생한 경우 100년 이내에 댐체 하부천 2ppb 이상의 오염물이 전달될 가능성이 있음을 확인하였지만, 균열이 없거나 슬래브 하부에 균열이 발생한 경우에는 오염물이 외부로 이동될 가능성이 거의 없었다. 따라서 콘크리트 슬래브에 대한 지속적인 유지 관리로 균열 발생을 적절히 제어할 수 있다면, 본 연구에서 제안한 오염된 사력재의 CFRD 내부 축조재료로의 활용은 고려 가능한 대안이 될 수 있을 것으로 판단된다.
Numerical analysis was performed to investigate the effect of heavy metal contamination on neighboring environment in case a dam is constructed by using rockfill materials contaminated by heavy metals. The numerical simulation carried out in this research includes both subsurface flow and contaminant transport in the inside of the CFRD(Concrete Faced Rockfill Dam), using two commercial programs, SEEP2D and FEMWATER. The three representative cases of scenarios were chosen to consider a variety of cases occurring in a dam site; (1) Scenario 1 : no crack in the concrete face slab, (2) Scenario 2 : a crack In the upper part of face slab, and (3) Scenario 3 : a crack between plinth and face slab in the lower part of face slab. As a result of seepage analysis, the amount of seepage in scenario 2 was calculated as $14.31\sim14.924m^3/day$ per unit width, corresponding to the 1,000 times higher value than that in other scenarios. Also, in the simulation of contaminant transport by using FEMWATER, specified contaminant concentration of 13 ppb in main rockfill zone was set to consider continuous leakage from the rock materials. Through the analysis of contaminant transport, we found that elapsed times to take for the contaminant concentration of about 2 ppb to arrive at the end of a dam are as follows. Scenario 1 has the elapsed time of 55,000 years. In Scenario 2. it is 50 years. Finally, scenario 3 has 27,000 years. The rapid transport of the contaminant in scenario 2 was attributed to greater seepage flow by 500 times than other scenarios. Although, in case of upper crack in the face slab, it was identified that the contaminant might transport to the end of a dam within 100 years with about 2 ppb concentration, however, it happened that the contaminant was hardly transported out of the dam in other scenarios, which correspond to either no crack or a crack between plinth and face slab. In conclusion, the numerical analysis showed that the alternative usage of the contaminated sand and gravel as the dam embankment material can be one of the feasible methods with the assumption that the cracks in a face slab could be controlled adequately.