Antenna Factor Characteristics of EMI Dipole Antennas with Coaxial Cable Balun for Frequencies between 30 and 1,000 MHz

동축 케이블 밸런이 부착된 30~1,000 MHz 대역용 EMI 다이폴 안테나의 안테나 인자 특성

  • Ju Chang-Hyun (Department of Electrical Engineering, Yeungnam University) ;
  • Kim Ki-Chai (Department of Electrical Engineering, Yeungnam University)
  • Published : 2006.07.01

Abstract

This paper presents the characteristics of an antenna factor of two kinds of EMI dipole antennas with a coaxial cable balun used in the frequency range between 30 and 1,000 MHz. The integral equation for unknown current distribution is solved by the Galerkin's method of moments with piecewise sinusoidal functions. An antenna factor for EMI dipole antennas with the coaxial cable balun is derived by using the power loss concepts. We can realize two kinds of EMI dipole antennas with appropriate antenna factors in the frequency range from 30 to 1,000 MHz: 150-cm dipole length($30{\sim}300 MHz$) and 30cm dipole length($300{\sim}1,000 MHz$). To check th ε validity of the theoretical analysis, the complex antenna factor was measured using by reference antenna methods. It is shown that the calculated complex antenna factor is good agreement with experimental results.

본 논문은 두 개의 다이폴 안테나로 $30{\sim}1,000 MHz$ 대역에서 사용할 수 있는 동축케이블 밸런이 부착된 EMI 다이폴 안테나의 안테나 인자 특성을 검토하고 있다. 이론 해석으로는 안테나에 흐르는 전류 분포에 관한 적분 방정식을 구분 정현 함수를 사용한 Galerkin 의 모멘트 법으로 그 해를 구하여 계산하고 있다. 동축 케이블 밸런이 부착된 EMI 다이폴 안테나의 안테나 인자 표현식은 전력 손실의 개념을 적용하여 유도하였다. 안테나 인자의 검토 결과 2 개의 안테나로 $30{\sim}1,000 MHz$ 대역을 커버할 경우 적절한 안테나 인자를 가지는 EMI 다이폴 안테나를 실현할 수 있는데, 다이폴의 길이를 150 cm로 선택하면 $30{\sim}300 MHz$ 대역에서, 다이폴의 길이를 30 cm로 선택하면 $300{\sim}1,000 MHz$ 대역에서 적절한 안테나 인자를 가지는 EMI 다이폴 안테나를 구성할 수 있음을 확인할 수 있었다. 참조 안테나 법으로 측정한 안테나 인자의 측정치를 이론치와 비교하여 이론 해석의 타당성도 확인하였다.

Keywords

References

  1. CISPR-16 part 1, 'Specification for radio disturbance and immunity measuring apparatus and methods-Part 1, Radio disturbance and immunity measuring apparatus', 1993
  2. ANSI C63.4-1991, 'American national standard methods of measurement of radio-noise emissions from low-voltage electrical and electronic equipment in the range of 9 kHz to 1 GHz', 1991
  3. K. C. Kim, 'EMI dipole antennas with forced resonance by reactance loading for frequencies below 80 MHz', IEICE Trans. on Commun., vol. E85-B, no. 11, pp. 2489-2494, Nov. 2002
  4. I. Sanchez Garcia, A. Rubio Bretones, and R. Gomez Martin, 'Pulse-receiving characteristics of Vdipole antennas with resistive loading', IEEE Trans. on Electromagnetic Compatibility, vol. 40, no. 2, pp. 174-176, May 1998 https://doi.org/10.1109/15.673624
  5. S. Ishigami, R. Gokita, I. Yokishima, and T. Iwasaki, 'Measurement of fast transient fields in the vicinity of short gap discharge', IEICE Trans. on Commun., vol. E78-B, no. 2, pp. 199-206, Feb. 1995
  6. H. Hosoyama, T. Iwasaki, and S. Ishigami, 'Complex antenna factor of a V-dipole antenna with two coaxial feeders for field measurements', IEEE Trans. on Electromagnetic Compatibility, vol. 41, no. 2, pp. 154-158, May 1999 https://doi.org/10.1109/15.765107
  7. W. S. Bennett, 'Properly applied antenna factors', IEEE Trans. Electromag. Compat., vol. EMC-28, no. 1, pp. 2-6, Feb. 1986
  8. C. H. Ju, D. H. Jun, and K. C. Kim, 'Complex antenna factors of emi antenna with coaxial cable balun for measuring electromagnetic fields', JKEES, vol. 5, no. 2, pp. 66-71, Jun. 2005
  9. ANSI C63.5-1988, 'American national standard for radiated emission measurements in electromagnetic interference(EMI) control', 1988