초록
4종류 토목섬유 조합으로 구성된 4가지 토목섬유 접촉면의 정적 및 동적 하중 상태에서의 전단거동을 평가하였다. 정적하중 조건에서 경사판 시험과 직접전단 시험을 수행하였으며, 두가지 시험 결과를 상호 비교하였다. 비교 결과 직접전단 시험의 경우, 직접전단 시험이 수행되지 아니한 낮은 응력 단계에서의 접촉면 전단강도를 실제보다 크게 예측할 가능성이 높은 것으로 나타났다. 또한 정적상태에서 수행된 두 종류 시험을 통해 산정된 전단강도를 이용하여 곡선형태의 파괴 포락선식을 구할 수 있었다. 한편 정적 전단강도와 진동대시험을 통해 동적 하중 상태에서 구한 접촉면 전단강도를 비교하여, 하중 특성과 가해진 응력 크기에 따라 각기 다른 마찰 특성을 보임을 확인하였다. 따라서 토목섬유 사이의 접촉면 전단강도를 정확히 평가하기 위해서는 실제 현장에 설치되는 재료를 대상으로 예상되는 응력의 크기와 하중 유형을 고려하여 시험이 수행되어야 할 것이다.
The shear behavior of four different interfaces consisting of four types of geosynthetics was investigated, and both static and dynamic test for the geosynthetic interfaces were conducted. The monotonic shear experiments were performed by using an inclined board apparatus and large direct shear device. The interface shear strength obtained from the inclined board test was compared with calculated values from large direct shear tests. The comparison results indicated that direct shear tests show high possibility to over-predict the shear strength in the low normal stress range where direct shear tests are not performed. Curved failure envelopes were also obtained for interface cases where two static shear tests were conducted. By comparing the friction angles measured from three tests, i.e. direct shear, inclined board, and shaking table test, it was found that the friction angle might be different depending on the test method and normal stresses applied in the research. Therefore, it was concluded that the testing method should be determined carefully by considering the type of loads and the normal stress expected in the field with using the geosynthetic materials installed in the site.