DOI QR코드

DOI QR Code

Effect of introducing RC infill on seismic performance of damaged RC frames

  • Turk, Ahmet Murat (Department of Civil Engineering, Istanbul Kultur University) ;
  • Ersoy, Ugur (Department of Civil Engineering, Middle East Technical University) ;
  • Ozcebe, Guney (Department of Civil Engineering, Middle East Technical University)
  • 투고 : 2005.05.20
  • 심사 : 2006.03.29
  • 발행 : 2006.07.30

초록

The main objective of this study was to investigate the seismic behavior of damaged reinforced concrete frames rehabilitated by introducing cast in place reinforced concrete infills. Four bare and five infilled frames were constructed and tested. Each specimen consisted of two (twin) 1/3-scale, one-bay and two-story reinforced concrete frames. Test specimens were tested under reversed-cyclic lateral loading until considerable damage occurred. RC infills were then introduced to the damaged specimens. One bare specimen was infilled without being subjected to any damage. All infilled frames were then tested under reversed-cyclic lateral loading until failure. While some of the test frames were detailed properly according to the current Turkish seismic code, others were built with the common deficiencies observed in existing residential buildings. The variables investigated were the effects of the damage level and deficiencies in the bare frame on the seismic behavior of the infilled frame. The deficiencies in the frame were; low concrete strength, inadequate confinement at member ends, 90 degree hooks in column and beam ties and inadequate length of lapped splices in column longitudinal bars made above the floor levels. Test results revealed that both the lateral strength and lateral stiffness increased significantly with the introduction of reinforced concrete infills even when the frame had the deficiencies mentioned above. The deficiency which affected the behavior of infilled frames most adversely was the presence of lap splices in column longitudinal reinforcement.

키워드

참고문헌

  1. Aboutaha, R.S., Engelhardt, M.D., Jirsa, J.O. and Kreger, M.E. (1999), 'Rehabilitation of shear critical concrete columns by use of rectangular steel jackets', ACI Struct. J, 96(1), 68-78
  2. Altin, S., Ersoy, U. and Tankut, T. (1992), 'Hysteretic response of reinforced concrete infilled frames', J. Struct. Div., ASCE, 118(8), 2133-2150 https://doi.org/10.1061/(ASCE)0733-9445(1992)118:8(2133)
  3. Aoyama, H., Kato, D., Katsumata, H. and Hosokawa, Y. (1984), 'Strength and behavior of postcast shear walls for strengthening of existing R/C buildings', Proc. of the Eighth World Con! on Earthquake Engineering, San Francisco, Calif., 1, 485-492
  4. Badoux, M. and Jirsa, J.O. (1990), 'Steel bracing of RC frame for seismic retrofitting', J. Struct. Eng., ASCE, 116(1),55-74 https://doi.org/10.1061/(ASCE)0733-9445(1990)116:1(55)
  5. Bertero, V.V. and Brokken, S.T. (1983), 'Infills in seismic resistant building', J. Struct. Div., ASCE, 109(6), 1337-1361 https://doi.org/10.1061/(ASCE)0733-9445(1983)109:6(1337)
  6. Bush, T.D., Jones, E.A. and Jirsa, J.O. (1990), 'Behavior of RC frame strengthened using structural steel bracing', J. Struct. Eng., ASCE, 117(4),115-1126
  7. Canbay, E., Ersoy, U. and Ozcebe, G (2003), 'Contribution of reinforced concrete infills to the seismic behavior of structural systems', ACI Struct. J, 100(5), 637-643
  8. Endo, T., Adachi, H. and Nakanishi, M. (1980), 'Force-deformation hysteresis curves of reinforced concrete shear walls', Proc. of the Seventh World Conf. on Earthquake Engineering, 6, Istanbul, 315-322
  9. Ersoy, U. (1996), 'Seismic rehabilitation-applications, research and current needs', Proc. of the Eleventh WCEE, Paper No. 2099, Mexico
  10. Ersoy, U. and Uzsoy, S. (1971), 'The behavior and strength of infilled frames', Report No. MAG-205 TUBITAK, Ankara, Turkey (in Turkish)
  11. Frosch, R.J., Li, w., Jirsa, J.O. and Kreger, M.E. (1996), 'Retrofit of non-ductile moment-resisting frames using precast infill wall panels', Earthquake Spectra, 12(4), 741-760 https://doi.org/10.1193/1.1585908
  12. Hayashi, Y., Niwa, H. and Fukuhara, M. (1980), 'The strengthening method of the existing R/C buildings', Proc. of the Seventh World Conf. on Earthquake Engineering, Istanbul, Turkey, 4, 89-96
  13. Higashi, Y. and Kokusho, S. (1975), 'The strengthening method of existing reinforced concrete buildings', U.S.-Japan Cooperative Research Program in Earthquake Engineering, Hawaii
  14. Higashi, Y., Endo, T. and Shimizu, Y. (1982), 'Effects on behaviors of reinforced concrete frames by adding shear walls', Proc. of the Third Seminar on Repair and Retrofit of Structures, Ann Arbor, Michigan
  15. Higashi, Y., Endo, T. and Shimizu, Y. (1984), 'Experimental studies on retrofitting of reinforced concrete building frames', Proc. of the Eighth World Conf. on Earthquake Engineering, San Francisco, 1,477-484
  16. Higashi, Y., Endo, T., Okhubo, M. and Shimizu, Y. (1980), 'Experimental study on strengthening reinforced concrete structure by adding shear wall', Proc. of the Seventh WCEE, Istanbul, Turkey, 7, 173-180
  17. Inukai, M. and Kaminosono, T. (2000), 'Seismic performance of an existing RC frame retrofitted by precast prestressed concrete shear walls', 12th World Conf. on Earthquake Engineering, Paper No. 2246
  18. Jirsa, J.O. (1988), 'Behaviour of epoxy-grouted dowels and bolts used for repair or strengthening of reinforced concrete structures', Proc. of 9th WCEE, Tokyo, VII, 371-376
  19. Jirsa, J.O. and Kreger, M.E. (1989), 'Recent research on repair and strengthening of reinforced concrete structures', Seismic Engineering, CA. Kircher and A.K. Chopra, eds., ASCE, 679-688
  20. Kahn, L.F. and Hanson, R.D. (1979), 'Infilled walls for earthquake strengthening', J. Struct. Div., ASCE, 105(2), 283-296
  21. Lee, H.S. and Woo, S.W. (2002), 'Effect of masonry infills on seismic performance of a 3-storey RC frame with non-seismic detailing', Earthq. Eng. Struct. Dyn., 31, 353-378 https://doi.org/10.1002/eqe.112
  22. Liauw, T.C and Kwan, K.H. (1985), 'Unified plastic analysis for infilled frames', J. Struct. Div , ASCE, 111(7), 1427-1449 https://doi.org/10.1061/(ASCE)0733-9445(1985)111:7(1427)
  23. Makino, M., Kawano, Y., Kurobane, M., Saisho and Yoshinaga, K. (1980), 'An investigation for the design of framed structures with infill walls', Proc. of the 7th WCEE, Istanbul, Turkey, 4, 369-372
  24. Miranda, E. and Bertero, V.V. (1990), 'Post-tensioning techniques for seismic upgrading of existing low-rise buildings', 4th US Nat. Conf. on Earthquake Engineering, Proceedings, 2, 139-148
  25. Moehle, J.P. (2000), 'State of research on seismic retrofit of concrete building structures in the US', US-Japan Symposium and Workshop on Seismic Retrofit of Concrete Structures
  26. Ohki, K. and Bessho, S. (1980), 'Experimental investigation on aseismic strengthening for existing reinforced concrete frames', Proc. of the Seventh World Conf. on Earthquake Engineering, 6, Istanbul, Turkey, 517-524
  27. Orangun, CO., Jirsa, J.O. and Breen, J.E. (1977), 'Re-evaluation of test data on development length and splices', J. American Concrete Inst., 74(3), 114-122
  28. Phan, L.T. and Lew, H.S. (1996), 'Strengthening methodology for lightly reinforced concrete frames', Proc. of the 11th WCEE, Paper No. 1896
  29. Pincheira, J.A. and Jirsa, J.O. (1995), 'Seismic response of RC frames retrofitted with steel braces or walls', J. Struct. Eng., ASCE, 121(8), 1225-1235 https://doi.org/10.1061/(ASCE)0733-9445(1995)121:8(1225)
  30. Sonuvar, M.O. Ozcebe, G and Ersoy, U. (2004), 'Rehabilitation of reinforced concrete frames with reinforced concrete infills', ACI Struct. J, 101(4), 1-7
  31. Sozen, M.A. (1987), 'Toward a behaviour based design of reinforced concrete frames to resist earthquakes', Proc. of9th Technical Conf. of Turkish Society of Civil Engineering, 1, Ankara, Turkey, 1-47, (in Turkish)
  32. Sugano, S. (1980), 'Aseismic strengthening of existing reinforced concrete buildings', Proc. of the First Seminar on Repair and Retrofit ofStructures, US/Japan Cooperative Earthquake Engineering Research Program
  33. Sugano, S. (1996), 'State-of-the-art in techniques for rehabilitation of buildings', Proc. of the 11th WCEE, Paper No. 2175
  34. Sugano, S. and Fujimura, M. (1980), 'Aseismic strengthening of existing reinforced concrete buildings', Proc. of the Seventh WCEE, 4, Istanbul, Turkey, 449-456
  35. TSC 75 (1975), 'Specifications for the structures to be built in disaster regions (The Turkish Seismic Code)', Ministry of Public Work and Settlement, Ankara
  36. TSC 98 (1998), 'Specifications for the structures to be built in disaster regions (The Turkish Seismic Code)', Ministry of Public Work and Settlement, Ankara
  37. Turk, A.M. (1998), 'Rehabilitation of reinforced concrete frames by reinforced concrete infill walls', Ph.D. Thesis, Bogazici University, Istanbul, Turkey
  38. Valluvan, R., Kreger, M. and Jirsa, J.O. (1993), 'Strengthening of column splices for seismic retrofit of nonductile reinforced concrete frames', ACI Struct. J, 90(4), 432-440
  39. Yuzugullu, O. (1980), 'Multiple precast reinforced concrete panels for aseismic strengtening of reinforced concrete frames', Proc. of the 7th WCEE, Istanbul, Turkey, 6, 263-270

피인용 문헌

  1. An investigation on global ductility of strengthened RC frames vol.163, pp.3, 2010, https://doi.org/10.1680/stbu.2010.163.3.177
  2. Occupant friendly seismic retrofit by concrete plates vol.14, pp.11, 2013, https://doi.org/10.1631/jzus.A1200324
  3. Shear Tests on Subassemblies Representing the Multi-anchored Connection between PC Wall Panels and RC Frames vol.22, pp.12, 2018, https://doi.org/10.1007/s12205-017-1156-y
  4. Experimental Study on Existing Reinforced Concrete Frames Strengthened by L-type Precast Concrete Wall Panels to Earthquake-Proof Buildings vol.22, pp.9, 2018, https://doi.org/10.1007/s12205-018-1197-x
  5. RCC frames with ferrocement and fiber reinforced concrete infill panels under reverse cyclic loading vol.5, pp.3, 2017, https://doi.org/10.12989/acc.2017.5.3.257