International Journal of Concrete Structures and Materials

Korea Concrete Institute (한국콘크리트학회)
권호 표지
DOI QR코드

DOI QR Code

Bond Strength of Super-CFRP Rod in Concrete

  • Published : 2006.06.30
Download PDF
⟨ Previous Next ⟩

Abstract

Elastic modulus, tensile and bond capacities are important factors for developing an effective reinforcing action of a flexural member as a reinforcing material for concrete structures. Reinforcement must have enough bond capacity to prevent the relative slip between concrete and reinforcement. This paper presents an experimental study to clarify the bond capacity of prestressed carbon fiber reinforced polymer(CFRP) rod manufactured by an automatic assembly robot. The bond characteristics of CFRP rods with different pitch of helical wrapping were analyzed experimentally. As the result, all types of CFRP rods show a high initial stiffness and good ductility. The mechanical properties of helical wrapping of the CFRP rods have an important effect on the bond of these rods to concrete after the bond stress reached the yield point. The stress-slip relationship analyzed from the pull-out test of embedded cables within concrete was linear up to maximum bond capacity. The deformation within the range of maximum force seems very low and was reached after approximately 1 mm. The average bond capacity of CF20, CF30 and CF40 was about 12.06 MPa, 12.68 MPa and 12.30 MPa, respectively. It was found that helical wrapping was sufficient to yield bond strengths comparable to that of steel bars.

Keywords

References

  1. Chajes, M.1., Finch,W. W., Januszka,T.F, and Thomson, T. A., 'Bond and Force Transfer of Composite-Material Plates Adhered to Concrete,' Structural Journal, ACI, Vol.93, No.2, 1996, pp.208-217
  2. Nanni, A., Al-Zaharani, M. M., Al-Dulaijan, S. u., Bakis, C. E., and Boothby, T. E., 'Bond of FRP reinforcement to concrete experimental results,' Proc., 2nd Int. RILEM SYMP., L. Tarewe, ED., E & FN Spon, London, 1995, pp.135-145
  3. Benmokrane H., Tighiouart, 8., and Chaallal, 0., 'Bond strength and load distribution of composite GFRP reinforcing bars in Concrete,' ACI Mat. J., Vol.93, No.3, 1996, pp.246-253
  4. Cosenza, E., Manfredi, G and Realfonzo, R., 'Behavior and modeling of bond of FRP rebars to concrete,' J. Compos. for Constr., ASCE, Vol.1, No.2, 1997, pp.40-50 https://doi.org/10.1061/(ASCE)1090-0268(1997)1:2(40)
  5. Burgoyne, J. M., and Lees, C. J., 'Experimental study of influence of bond on flexural behavior of concrete beams pretension with aramid fiber reinforced polymer,' ACI Structural Journal. Vol.96, No.3, 1999, pp.377-385
  6. Ayman, M. 0., Mohsen, S., and Sherif, E. T., 'Short-term tensile strength of carbon fiber-reinforced polymer laminates for flexural strengthening of concrete girders,' ACI Structural Journal, Vol.98, No.4, 2001, pp.470-478
  7. Abdullah, 8., Fundamental study on strengthening of steel girder bridge with RC slab by using pultruded GFRP members, PhD dissertation, University of Kyushu, Fukuoka, Japan, 2001, pp.l-B
  8. Ohta, T., Djamalluddy, R., Seo, S. T., Sajima, T., and Harada, K., 'Evaluation of tensile strength of unresin continuous carbon fiber cables are tensile reinforcement for concrete structure,' Memoirs of the Faculty of Engineering, Kyushu University, Vol.62, No.4, 2002, pp.179-190
  9. JSCE-E 539, 'Quality Specifications for Continuous Fiber Reinforcing Materials,' Concrete Library of JSCE, 1996, pp.55-129