DOI QR코드

DOI QR Code

Characteristics of Cooling for the Adjacent Double Micro-Porous Coated Surfaces in PE5060

마이크로다공성 코팅된 인접 복수 발열체에 대한 PF5060의 냉각 특성

  • 김태균 (고려대학교 대학원 기계공학과) ;
  • 김윤호 (고려대학교 대학원 기계공학과) ;
  • 이규정 (고려대학교 기계공학과)
  • Published : 2006.07.01

Abstract

The present research is an experimental study on characteristics of cooling behavior for the adjacent copper blocks with surface roughness or micro-porous coated surface. The experiments were carried out at saturation state or within subcooled states of PF5060. The effects of heater orientation and the intervals between heating surfaces or substrates were investigated under various heat flux conditions. The boiling performance of copper block with micro-porous coated surface was better than that of copper block with surface roughness. It is understood that the bubble sweeping enhances boiling performance for the heaters with inclinations of $\theta=45^{\circ}\;and\;\theta=90^{\circ}$, where as the bubble flattening decreases boiling performance for the heaters with inclinations of $\theta=135^{\circ}\;and\;\theta=180^{\circ}$. In comparison to upper heater and below heater with orientation, the upper heater has lower superheat temperature than the below heater due to the bubble sweeping. It is also found that boiling performance decreases in the case of adjacent double heaters with only 0.2cm substrate interval.

Keywords

References

  1. Ferjancic, K. and Golobic, I., 2002, 'Surface Effects on Pooling CHF,' Experimental Thermal and Fluid Science, Vol. 25, pp. 565-571 https://doi.org/10.1016/S0894-1777(01)00104-2
  2. Misle, M., Guglielmine, G. and Schenone, C., 2002, 'Boiling of Saturated FC-72 on Square Pin Fin Arrays,' International Journal of Thermal Sciences, Vol. 41, pp. 599-608 https://doi.org/10.1016/S1290-0729(02)01353-4
  3. Kim, C., Lee, K. J. and Kim, Y. C., 2003, 'Effect of Micro-Fin Etched Heating Surfaces on Nucleate Boiling in PF5060,' Proceeding of the SAREK 2003 Winter Annual Conference, pp. 86-91
  4. Shu-Rong, T., Hiroshi, T. and Hiroshi, H., 1998, 'Experimental Study on the Immersion Cooling of an Upward-facing Multichip Module with an Opposing Condensing Surface,' Heat Transfer Japanese Research, Vol. 27, No.7, pp. 497-508 https://doi.org/10.1002/(SICI)1520-6556(1998)27:7<497::AID-HTJ3>3.0.CO;2-Z
  5. Chang, J. Y. and You, S. M., 1997, 'Enhanced Boiling Heat Transfer from Micro-porous Surfaces : Effects of a Coating Composition and Method,' International Journal of Heat and Mass Transfer, Vol. 44, pp. 4449-4460 https://doi.org/10.1016/S0017-9310(97)00057-4
  6. Rainey, K. N. and You, S. M., 2001, 'Effects of Heater Size and Orientation on Pool Boiling Heat Transfer from Microporous Coated Surfaces,' International Journal of Heat and Mass Transfer, Vol. 44, pp. 2589-2599 https://doi.org/10.1016/S0017-9310(00)00318-5
  7. Misale, M. and Bergles, A. E., 1997, 'The Influence of Channel width on Natural Convection and Boiling Heat Transfer from Simulated Microelectronic Components,' Experimental Thermal and Fluid Science, Vol. 14, pp. 187-193 https://doi.org/10.1016/S0894-1777(96)00065-9
  8. O'Connor, J. P. and You, S. M., 1995, 'A Painting Technique to Enhance Pool Boiling Heat Transfer in Saturated FC-72,' ASME Journal of Heat Transfer, Vol. 117, pp. 387-393 https://doi.org/10.1115/1.2822534
  9. Howard, Alicia H. and Mudawar, Issam., 1999, 'Orientation Effects on Pool Boiling Critical Heat Flux (CHF) and Modeling CHF for Near-vertical Surfaces,' International Journal of Heat and Mass Transfer, Vol. 42, pp. 1665-1688 https://doi.org/10.1016/S0017-9310(98)00233-6
  10. Rainey, K. N., You, S. M. and Lee, S., 2002, 'Effect of Pressure, Subcooling, and Dissolved Gas on Pool Boiling Heat Transfer from Micro-porous, Square Pin-finned Surfaces in FC-72,' International Journal of Heat and Mass Transfer, Vol. 46, pp. 23-35 https://doi.org/10.1016/S0017-9310(02)00257-0
  11. Honda, H. and Wei, J. J., 2004, 'Enhanced Boiling Heat Transfer from Electronic Components by Use of Surface Microstructures,' Experimental Thermal and Fluid Science, Vol. 28, pp. 159-169 https://doi.org/10.1016/S0894-1777(03)00035-9

Cited by

  1. Heat Transfer Characteristics of Spray Cooling up to Critical Heat Flux on a Low-fin Enhanced Surface vol.25, pp.9, 2013, https://doi.org/10.6110/KJACR.2013.25.9.522
  2. Heat Transfer Characteristics of Spray Cooling Up to Critical Heat Flux on Thermoexcel-E Enhanced Surface vol.28, pp.9, 2016, https://doi.org/10.6110/KJACR.2016.28.9.373