DOI QR코드

DOI QR Code

Cyclic behavior of interior beam-column connections in non-seismic RC frames at different loading rates

  • Dhakal, Rajesh P. (Department of Civil Engineering, University of Canterbury) ;
  • Pan, Tso-Chien (Protective Technology Research Centre, Nanyang Technological University)
  • 투고 : 2005.12.13
  • 심사 : 2006.02.23
  • 발행 : 2006.05.30

초록

This paper provides an insight into the response of non-seismic reinforced concrete (RC) building frames to excitations of different frequencies through experimental investigation. The results of cyclic loading tests of six full-scale RC beam-column sub-assemblies are presented. The tested specimens did not have any transverse reinforcement inside the joint core, and they were subjected to quasi-static and dynamic loading with frequencies as high as 20 Hz. Some important differences between the cyclic responses of non-seismic and ductile RC frames are highlighted. The effect of excitation frequency on the behavior of non-seismic joints is also discussed. In the quasi-static tests, shear deformation of the joint panel accounted for more than 50% of the applied story drift. The test results also showed that higher-frequency excitations are less detrimental than quasi-static cyclic loads, and non-seismic frames can withstand a higher load and a larger deformation when they are applied faster.

키워드

참고문헌

  1. ACI-ASCE Committee 352 (1991), Recommendations for Design of Beam-Column Joints in Monolithic Reinforced Concrete Structures (ACI 352R-91), American Concrete Institute
  2. Aycardi, L.K, Mander, J.B. and Reinhorn, A.M. (1994), ' Seismic resistance of reinforced concrete frame structures designed only for gravity loads: Experimental performance of subassemblages ', ACI Struct. J., 91(5), 552-563
  3. Beres, A., EI-Borgi, S., White, R.N. and Gergely, P. (1992), ' Experimental results of repaired and retrofitted . beam-column joint tests in lightly reinforced concrete frame buildings,' Technical Report NCEER-92-0025,Comell University
  4. Bertero, P.P. and Popov, E.P. (1977), ' Seismic behavior of ductile moment resisting reinforced concrete frames ', Reinforced Concrete Structures in Seismic Zones (SP-53), American Concrete Institute, Michigan, 247-291
  5. Cadoni, K, Labibes, K., Berra, M., Giangrasso, M. and Albertini, C. (2000), ' High-strain-rate tensile behaviour of concrete ', Magazine of Concrete Research, 52(5), 365-370 https://doi.org/10.1680/macr.2000.52.5.365
  6. Dhakal, R.P. and Pan, T.C. (2003a), ' Response characteristics of structures subjected to blasting induced ground motions ', Int. J. Impact Eng., 28(8), 813-828 https://doi.org/10.1016/S0734-743X(02)00157-4
  7. Dhakal, R.P. and Pan, T.C. (2003b), ' Characteristics of high-speed cyclic test of beam-column joints ', ACI Struct. J., 100(2),188-196
  8. Filiatrault, A. and Holleran, M. (2001), ' Stress-strain behavior of reinforcing steel and concrete under seismic strain rates and low temperatures ', Mater. Struct., 34(238), 235-239 https://doi.org/10.1007/BF02480594
  9. Ghobarah, A. and Biddah, A. (1999), ' Dynamic analysis of reinforced concrete frames including joint shear deformation ', Eng. Struct., 21(11), 971-987 https://doi.org/10.1016/S0141-0296(98)00052-2
  10. Hakuto, H., Park, R. and Tanaka, H. (2000), ' Seismic load tests on interior and exterior beam-column joints with substandard reinforcing details ', ACI Struct. J., 97(1), 11-25
  11. Klepaczko,J.R. and Brara, A. (2001), ' An experimental method for dynamic tensile testing of concrete by spalling ', Int. J. Impact Eng., 25(4), 387-409 https://doi.org/10.1016/S0734-743X(00)00050-6
  12. NZS 3101-95 (1995), Concrete Structures Standard - The Design of Concrete Structures, Standards New Zealand
  13. Oka, K. and Shiohara, H. (1992),' Tests of high-strength concrete interior beam-column joint subassemblages ', Proc. of the 10th World Conf. on Earthquake Engineering, Balkema, Rotterdam, 3211-3217
  14. Otani, S., Kobayashi, Y. and Aoyama, H. (1984), ' Reinforced concrete interior beam-column joints under simulated earthquake loading ', First US-NZ-Japan Seminar on Design of Reinforced Concrete Beam-ColumnJoints, California, pp.48
  15. Otani, S., Kitayama, K. and Aoyama, H. (1985), ' Beam bar bond stress and behaviour of reinforced concrete interior beam-column connections ', Second US-NZ-Japan Seminar on Design of Reinforced Concrete BeamColumn Joints, Tokyo, pp.40
  16. Park, R. (2002),' A summary of results of simulated seismic load tests on reinforced concrete beam-column joints, beams and columns with substandard reinforcing details ', J. Earthq. Eng., 6(2), 147-174 https://doi.org/10.1142/S1363246902000759
  17. Wong, P.K.C., Priestley, M.J.N. and Park, R. (1990),' Seismic resistance of frames with vertically distributed longitudinal reinforcement in beams ', ACI Struct. J., 87(4), 188-198

피인용 문헌

  1. A comparative study of the effect of adding steel fiber on the mechanical behavior of RSCC beams under displacement and force control conditions vol.166, pp.None, 2006, https://doi.org/10.1016/j.conbuildmat.2018.01.122
  2. Cyclic Nonlinear Modeling Parameters for Unconfined Beam-Column Joints vol.119, pp.1, 2006, https://doi.org/10.14359/51733139