ROAD CROWN, TIRE, AND SUSPENSION EFFECTS ON VEHICLE STRAIGHT-AHEAD MOTION

  • LEE J-H. (Vehicle Dynamics Team, Kumho Tire Co., Inc) ;
  • LEE J. W. (Vehicle Dynamics Team, Kumho Tire Co., Inc) ;
  • SUNG I. C. (Vehicle Dynamics Team, Kumho Tire Co., Inc)
  • Published : 2005.04.01

Abstract

During normal operating conditions, a motor vehicle is constantly subjected to a variety of forces, which can adversely affect its straight-ahead motion performance. These forces can originate both from external sources such as wind and road and from on-board sources such as tires, suspension, and chassis configuration. One of the effects of these disturbances is the phenomenon of vehicle lateral-drift during straight-ahead motion. This paper examines the effects of road crown, tires, and suspension on vehicle straight-ahead motion. The results of experimental studies into the effects of these on-board and external disturbances are extremely sensitive to small changes in test conditions and are therefore difficult to guarantee repeatability. This study was therefore conducted by means of computer simulation using a full vehicle model. The purpose of this paper is to gain further understanding of the straight-ahead maneuver from simulation results, some aspects of which may not be obtainable from experimental study. This paper also aims to clarify some of the disputable arguments on the theories of vehicle straight-ahead motion found in the literature. Tire residual aligning torque, road crown angle, scrub radius and caster angle in suspension geometry, were selected as the study variables. The effects of these variables on straight-ahead motion were evaluated from the straight-ahead motion simulation results during a 100m run in free control mode. Examination of vehicle behavior during straight-ahead motion under a fixed control mode was also carried out in order to evaluate the validity of several disputable arguments on vehicle pull theory, found in the literature. Finally, qualitative comparisons between the simulation results and the test results were made to support the validity of the simulation results.

Keywords

References

  1. Dijks, A. (1981). Measuremen of Tire Properties. Chapter of 8.2.6 of Mechanics of Pneumatic Tires. Clark, S. K. ed, U.S Department of Transportation. National Highway Traffic Safety Administration. Washington. D. C
  2. Lee, J.-H. (1998). Effect of tire characteristics on the simulation of vehicle straight ahead motion. SAE SP-1338, Paper No. 980249
  3. Lee, J.-H. (2000). Analysis of tire effect on the simulation of vehicle straight line motion. Vehicle System Dynamics 33, 6, 373-390 https://doi.org/10.1076/0042-3114(200006)33:6;1-M;FT373
  4. Matyja, F.E. (1987). Steering pull and residual aligning torque. Tire Science and Technology, TSTCA 15, 3, 207-240 https://doi.org/10.2346/1.2148791
  5. MDI, ADAMS User Manual, Version 9.1, Mechanical Dynamics, Inc. Ann Arbor. MI. USA
  6. Minitab, Inc. (2000). Minitab User's Manual. Minitab for Windows Release 13, USA
  7. Pottinger, M. (1990). Tire/Vehicle pull: An introduction emphasizing plysteer effects. Tire Science and Technology, TSTCA 18, 3, 170-190 https://doi.org/10.2346/1.2141698
  8. Stumpf, H.W. (2001). Linking evaluation of subjective tire tests on the road with objectively measured data. Int. J. Automotive Technology 2, 1, 17-23
  9. Toppings, R.W. (1975). Tire induced steering pull. SAE Paper No. 750406
  10. Vehicle Dynamics Terminology, SAE J670e (1976)