A Pilot Study of Stiffness Mesurements for Tunnel-Face Materials Using In-hole Seismic Method

인홀 시험을 이용한 터널 막장의 암반강성 측정에 대한 적용성 연구

  • Mok Young-Jin (College f Architecture and Civil Engrg., Kyung Hee Univ) ;
  • Kim Young-Su (Construction Supervision Division, Korea Engrg, Consultants Corportion)
  • Published : 2005.07.01

Abstract

The research concentrates on improving the in-hole seismic probe, which has been developed in past five years, to be used in stiffness measurements of tunnel-face materials. The size of probe was reduced to be fit in 45-mm diameter holes (or BX) drilled by a jumbo-drill, which is used to drill holes to install explosives for tunneling. Also trigger system was improved by using a down-speeding motor for operating convenience and air packing system was replaced with a set of plate-springs to eliminate supply of compressed air. These modifications are to adjust the probe for the unfavourable environment inside of tunnels and to test without any further drilling cost. The probe and testing procedure were successfully adopted with horizontal holes drilled by a jumbo-drill at a tunnel-face to evaluate the stiffness of rock mass. The measured shear wave velocities can be used to estimate deformation properties of rock mass for tunnel analyses.

본 연구는 지난 5년간 개발해온 인홀 발진자를 터널 막장의 강성도 계측에 사용가능하도록 개선하는데 주력하였다. 프로브는 터널의 폭파를 위해 점보드릴로써 천공된 직경 45m의 홀에 맞추기 위하여 소형화되었다. 또한 트리거 시스템은 감속모터를 사용함으로서 편리하게 되었고, 에어 팩킹 시스템은 압축공기 없이 사용하기위한 플레이트 스프링으로 교체하였다. 이러한 개선은 프로브를 터널내부의 환경에 적합하게 만들고 추가되는 비용 없이 실험하기 위함이다. 프로브와 테스트 과정은 암반의 강성을 측정하기 위해 터널의 막장의 수평 홀에 성공적으로 적용되었다. 측정된 전단파 속도는 터널 해석을 위한 암반의 변형 특성을 측정하는 것에 사용될 수 있다.

Keywords

References

  1. 강병수 (2003), '인흘 시험을 이용한 암반의 동적물성치 측정', 석사 학위논문
  2. 김정한 (2002), '지반의 강성도 측정을 위한 인홀 탄성파 시험법의 개발', 석사학위 논문-
  3. 목영진, 조성호 (1998), '탄성파 기법을 이용한 그라우팅 성능 평가에 관한 실험적 연구', 연구보고서
  4. 목영진 (1994), '역산이론을 이용한 다운흘 시험 결과의 해석', 한국지반공학회 논문집 제10권, 제4호, pp.29-37
  5. 송정락 (1995), '지반진동학', 엔지니어즈, pp.137-145
  6. 이중재 (2001), '검측공 탄성파 시험법을 이용한 현장타설말뚝의 건전도평가' 석사학위 논문
  7. 정진훈 (2004), '지반의 동적 물성치 측정을 위한 인흘시험법에 대한 연구', 석사학위 논문
  8. 지반공학용어사전, 엔지니어즈 (1996), pp.203
  9. 한국지반공학회 (1997), '진동 및 내진 설계(지반공학시리즈8)', pp.62-77, 161-165
  10. Dobry, R. and Vucetic, M (1987). 'Dynamic Properties and Seismic Response of Soft Clay Deposits', Proceedings, International Symposium on Geotech, Eng. of Soft Soils, Vol.2, pp.51-87
  11. Hardin, B. O. and Drnevich, V. P. (1972), 'Shear Modulus and Damping in Soil : Measurement and Parameter Effects', Journal of the Soil Mechanics and Foundation Division
  12. Hoar, R.J., Stokoe and K.H., II (1978), 'Generation and Measurement of Shear Wave in suit'. Dynamic Geotechnical Testing, ASTM STP 654, ASTM, pp.3-29
  13. Meissner, R. (1961), 'Wave-Front Diagrams from up-hole shooting', Geophysical Prospecting, Vol.9, No.4, pp.533-543 https://doi.org/10.1111/j.1365-2478.1961.tb01673.x
  14. Mok, Y.J. (1987), 'Analytical and Experimental Studies of Borehole Seismic Methods', Ph. D. Dissertation, The University of Texas at Austin, p.32
  15. Mok, Y. J. et al. (1988), 'In Situ Damping Measurements by Crosshole seismic Method', Proceedings, ASCE, Specialty Conference an Earthquake Engineering and Soil Dynamics II
  16. Ogura, K. (1979). 'Development of a Suspension Type S-wave Log System', OYO Technical Note TN-34, OYO Corp., Tokyo, Japan, 23, pp.23
  17. Paik, Y.S., Mok. Y.J., and Im, S.B. (1997), 'A Study of the Geotechnical Imaging Techniques using Seismic Geotomography', Proceedings of the XIV ICSMFE, pp.565-568
  18. Richard J. Hoar (1982), 'Field Measurement Of Seismic Wave Velocity And Attenuation For Dynamic Analyses', Ph. D Dissertation, University of Texas at Austin, pp.37447
  19. Stokoe, K. H. II, Abdel-razzak and K H. (1975), 'Shear Moduli of Two Compacted Fills', Proceedings of Conference on In Situ Measurement of Soil Properties, ASCE, Vol.I, Raleigh, NC, pp. 442-449