Effect of Manufacturing Parameters on Characteristic of Thin Film Resistor

박막저항기 특성에 미치는 제조 공정 인자의 영향

  • Park Hyun-Sik (Dept. of Electronic Eng., Dept. of Information and Control Eng., Hankyong National University) ;
  • Yu Yun-Seop (Dept. of Electronic Eng., Dept. of Information and Control Eng., Hankyong National University)
  • 박현식 (국립 한경대학교 전자공학과, 정보제어공학과, 전자기술종합연구소) ;
  • 유윤섭 (국립 한경대학교 전자공학과, 정보제어공학과, 전자기술종합연구소)
  • Published : 2005.03.01

Abstract

The effect of trimming process to adjust accurate resistance of a thin-film resistor was studied with respect to low temperature coefficient of resistance(TCR) and high precision. The characteristics of a thin-film resistor fabricated by sputtering were investigated depending on trimming condition and annealing temperature. Measured results showed that the characteristic of a thin-film resistor was degraded with increased trimming speed. However, an average resistance deviation and a TCR were improved to $0.26\%$ and 52.77[ppm/K], respectively, through annealing treatment. Also, thin-film resistors with 1 k$\Omega$ and 10k$\Omega$ showed better performance compared to a resistor with 100k$\Omega$. The Optimal trimming speed and annealing temperature were 20mm/sec and 539K, respectively, and under this optimal condition, a thin-film resistor with an average resistance deviation of $0.31\%$ and a TCR of below 10[ppm/K] was obtained.

저항 값을 맞추기 위한 트리밍 공정이 낮은 저항온도계수와 높은 정밀성을 요구하는 박막저항기 특성에 미치는 영향에 대한 연구가 수행되었다. 스퍼터링 방법으로 제조된 박막 저항기의 트리밍 속도에 따른 저항기의 특성 변화와 온도계수의 변화가 관찰되었다. 트리밍 속도의 증가에 따라서 박막 저항기 특성은 저하되었으며, 열처리로 저항 값의 평균 편차 $0.26\%$ 및 저항온도계수 52.77(ppm/K)의 개선효과가 있었다. 1k$\Omega$와 10k$\Omega$저항기가 100k$\Omega$ 박막저항기 보다는 특성이 양호하였으며, 트리밍 속도의 치적 조건으로는 20mm/sec와 특성 개선을 할 수 있는 최적 열처리 온도는 593K였으며 최적 조건에서 제작된 저항기의 저항 값의 평균 편차는 $0.31\%$ 및 저항온도계수 10(ppm/K)미만이었다.

Keywords