KIEE International Transactions on Power Engineering

대한전기학회 (The Korean Institute of Electrical Engineers)
권호 표지

A Hybrid Correction Technique of Missing Load Data Based on Time Series Analysis

  • 발행 : 2004.12.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

Traditionally, electrical power systems had formed the vertically integrated industry structures based on the economics of scale. However, power systems have been recently reformed to increase their energy efficiency. According to these trends, the Korean power industry underwent partial reorganization and competition in the generation market was initiated in 2001. In competitive electric markets, accurate load data is one of the most important issues to maintaining flexibility in the electric markets as well as reliability in the power systems. In practice, the measuring load data can be uncertain because of mechanical trouble, communication jamming, and other issues. To obtain reliable load data, an efficient evaluation technique to adjust the missing load data is required. This paper analyzes the load pattern of historical real data and then the tuned ARIMA (Autoregressive Integrated Moving Average), PCHIP (Piecewise Cubic Interpolation) and Branch & Bound method are applied to seek the missing parameters. The proposed method is tested under a variety of conditions and also tested against historical measured data from the Korea Energy Management Corporation (KEMCO).

키워드

참고문헌

  1. A.A. El-keib and X. Ma, 'Calculating Short-Run Marginal Costs of Active and Reactive Power Production', IEEE Trans. on Power Systems, Vol. 12, No. 2, May 1997, pp. 559-565 https://doi.org/10.1109/59.589604
  2. Y.Z. Li and A.K. David, ‘Wheeling Rates of Reactive Power Flow under Marginal Cost Pricing’, IEEE Trans. on Power Systems, Vol. 9, No. 3, Aug. 1994, pp. 1263-1269
  3. N.H. Dandachi et al., ‘OPF for Reactive Pricing Studies on the NGC System’, IEEE Trans. on Power Systems, Vol.11, No. 1, February 1996, pp. 226-232
  4. M.C. Caramanis et al., ‘The Costs of Wheeling and Optimal Wheeling Rates’, IEEE Trans. on Power Systems, Vol. 1, No. 1, Feb. 1986, pp. 63-73
  5. M.L. Baughman and S.N. Siddiqi, ‘Real Time Pricing of Reactive Power: Theory and Case Study Results’, IEEE Trans. on Power Systems, Vol. 6, No. 1, Feb. 1991, pp. 23-29
  6. J.Y. Choi et al., ‘Optimal Real Time Pricing of Real and Reactive Powers’, IEEE Trans. on Power Systems, Vol.13, No. 4, Nov. 1998, pp. 1226-1231
  7. S. Hao and A. Papalexopoulos, ‘Reactive Power Pricing and Management’, IEEE Trans. on Power Systems, Vol.12, No. 1, February 1997, pp. 95-104
  8. K. Ro and S. Park, ‘A Method to Calculate Charge for Reactive Power Service under Competition of Electric Power Utilities’, KIEE International Trans. on Power Engineering, Vol. 11A, No. 4, December 2001, pp. 39-44
  9. J.W. Lamont and J. Fu, ‘Cost Analysis of Reactive Power Support’, IEEE Trans. on Power Systems, Vol. 14, No. 3, August 1999, pp. 890-898
  10. J.B. Gil et al., ‘Reactive Power Pricing: A Conceptual Framework for Remuneration and Charging Procedures’, IEEE Trans. on Power Systems, Vol. 15, No. 2, May 2000, pp. 483-489
  11. S. Ahmed and G. Strbac, ‘A Method for Simulation and Analysis of Reactive Power Market’, IEEE Trans. on Power Systems, Vol. 15, No. 3, August 2000, pp. 1047-1052
  12. New York Independent System Operator Ancillary Services Manual, 1999
  13. California Independent System Operator Corporation, Ancillary services requirement protocol, FERC Electricity Tariff, October 2000
  14. National Grid Company, An introduction to reactive power: Ancillary Services, June 1998.
  15. National Grid Company, NGC reactive market report, May 2000
  16. Korea Power Exchange, Ancillary Services Agreement- Technical Schedules, September 2002