초록
Mobile IP에서 이동노드의 불필요한 위치 등록으로 인하여 발생되는 네트워크 시그널링 오버헤드를 줄이고자 IETF에서는 IP 페이징 기법을 제안하였다. IP 페이징 기법을 지원하기 위하여 이동노드는 active on, active off, idle 중 한가지 상태를 유지하여야 한다. Active on 상태는 이동노드에 데이터 세션이 형성되어 데이타를 수신하거나 또는 송신하는 상태를 말한다. 이때 이동노드가 데이타의 송수신을 완료하고 나면 이동노드는 active off 상태로 바뀌게 되며 active timer를 구동한다. 그 후 일정시간 동안 이동노드가 데이타를 송수신하지 않고 페이징 영역 간 이동이 발생하지 않으면 active timer가 만료된다. 이때 이동노드의 상태는 idle 상태로 바뀌게 된다 기존의 IP 페이징 기법에서는 고정된 active timer 값을 사용하고 있으나 본 논문에서는 이동노드의 이동성 및 트래픽 특성에 따라 active timer 값을 동적으로 설정하여 불필요한 위치갱신 작업을 줄일 수 있는 IP 페이징 기법을 제안한다. 또한 본 논문의 제안기법과 기존의 IP 페이징 기법간의 위치 갱신 및 페이징 비용에 대한 수학적 모델을 수립하고 성능평가를 수행한다. 이를 이용하여 성능 분석을 수행한 결과 기존 기법에 비하여 제안 기법이 보다 효율적임을 보여주고 있다.
Paging extensions for Mobile IP was proposed to avoid unnecessary registration signaling overhead of Mobile IP. In order to support the paging function in Mobile IP, the slates of a mobile node arc divided into active on, active off, idle. The active on state means when any incoming or outgoing data session arrives to a mobile node. After data session is completed, the state of the motile node is changed into active off from active on. At this moment, the active timer starts to be operated. If the active timer expires, the mobile node moves to idle state. If a mobile node has very frequently data sessions at the same cell, the mobile node is better to move slowly into idle state. The other way, if the mobile node very frequently moves into new cell area and receives or sends little data, the mobile node is better to move earlier into idle state. In this raper, the active timer is adaptively set by the mobile nodes traffic and mobility characteristics and the paging scheme using this active timer is proposed to reduce the location registration cost.