A Study on the Rapid Bulk Combustion of Premixture Using the Radical Seeding

  • Published : 2004.09.01

Abstract

The objective of this study is the rapid bulk combustion of mixture in a constant volume chamber with a tiny sub-chamber. Some narrow passage holes were arranged to induce simultaneous multi-point ignition in the main chamber by jet of burned and unburned gases including radicals from the sub-chamber, and the equivalence ratios of pre-mixture in the main chamber and the sub-chamber were the same. The principal factors of the Radical Induced Auto-Ignition (RIAI) method are the diameter of the passage holes and the volume of sub-chamber. The relationship between the sub-chamber and diameter of passage hole was represented by the ratios of sub-chamber volume to passage hole volume. The ratios are non-dimensional coefficients for sub-chamber characteristics. As a result, the RIAI method reduced the combustion period, which expanded the lean limit in comparison with SI method.

Keywords

References

  1. Arcoumanis, C., Hull, D. R. and Whitelaw, J. H., 1994, 'An Approach to Charge Stratification in Lean-Burn Spark-Ignition Engines,' SAE paper, No. 941878
  2. Bae, C. S., Lee, J. S. and Ha, J. Y., 1998 'High- Frequency Ignition Characteristics in a 4-Valve SI Engine with Tumble-Swirl Flow,' SAE International Meeting and Exposition, SAE No. 981433, Dearborn, Michigan
  3. Edward, R., Radu, R. and Radu, G. 1999, 'Influence of Fuel Injection Timing over the Performances of Direct Injection Spark Ignition Engine,' SAE paper, No. 1999-01-0174
  4. Evans, R. L., 1992, 'Combustion Chamber Design for a Lean-Burn SI Engine,' SAE paper, No. 921545
  5. Hara, H., Komoriya, H., Ikebe, H. and Iwamiya, Y., 1996, 'Lean-Burn Fuel Development Using the Correlation of CVCC and Engine Test,' SAE paper, No. 961158
  6. Heywood, J. B., 1983, 'International Combustion Engine Fundamentals,' McGraw-Hill Book Co., pp.413-423
  7. Hige1in, P. et al., 1999, 'A New Combustion Concept for Internal Combustion Engines,' Proceedings of the 15th Internal Combustion Engine Symposium (International) 9935761
  8. Kim, B. S., Kwon, C. H. and Ryu, J. I., 1995, 'Combustion Characteristics of Stratified Mixture in a Constant Volume Combustion Chamber with Sub-chamber,' KSAE paper, No. 953773, pp. 122-134
  9. Kn, M., Abthoff, J., Kemmler, R. and Kaiser, T., 1996, 'Influence of the Inlet Port and Combustion Chamber Configuration on the Lean-Burn Behavior of a Spark-Ignited Gasoline Engine,' SAE paper, No. 960608
  10. Lee, J. S. et al., 1996, 'Effect of Ignition-Energy Characteristics on the Ignition and the Combustion of a Premixed Gas,' Trans. KSAE, Vol. 4, No.1, pp. 28-35
  11. Lee, J. S. et al., 1998, 'Effect of Ignition Energy Discharge Characteristics on the Lean Flammability Limit,' Trans. KSAE, Vol. 6, No.4, pp.47-55
  12. Lim, H. J. et al., 2000, 'A Simulation on Auto ignition Characteristics of DME for Bulk Combustion,' 2000 KSAE spring conference proceeding, Vol. 1, pp. 322-327
  13. Ma, T., Zhao, H., Li, J. and Ladommatos, N., 2001, 'Experimental Investigation of Controlled Auto-Ignition Combustion in a 4-Stroke Multi-Cylinder Gasoline Engine and Drive Cycle Simulations,' IFP International Congress
  14. Park, J. S., Choi, H. S., Lee, M. J., Ha, J. Y. and Chung, S. S., 2002, 'A Study on Combustion Characteristic of Premixture by Radical Induced Injection in a Constant Volume Chamber,' 2002 KSAE spring conference proceeding, Vol. 1, pp.35-41
  15. Taro, A., Yoshiaki, H., Junichi, M. and Yasuo, S., 1996, 'An Experimental Study on Premixed-Charge Compression Ignition Gasoline Engine,' SAE Paper, No. 960081, pp. 1-7
  16. Varde, K. S., Patro, N. and Ken Drouillar, 1995, 'Lean Burn Natural Gas Fueled S.I. Engine and Exhaust Emissions,' SAE paper, No. 952499
  17. Yasuhiru, D., 1994, 'Engine Handbook,' Daekwang Publishing co., pp. 62-72
  18. Yoshida, K. and Saima, A., 1994, 'Influence of the Characteristics Length on Performance of Plasma Jet Igniters,' SAE paper, No. 942051, pp. 1-11