Effects of the Charging Mass of Working Fluid on the Thermal Performance of Heat Pipe with Axially Grooved Wick

  • Suh, Jeong-Se (Department of Mechanical Engineering, ReCAPT, GyeongSang National University) ;
  • Kang, Chang-Ho (Department of Mechanical Engineering, ReCAPT, GyeongSang National University) ;
  • Hong, Jung-Kyu (Department of Mechanical Engineering, ReCAPT, GyeongSang National University)
  • Published : 2004.06.01

Abstract

An analytical and experimental study has been conducted to determine the optimal charging mass of working fluid for the maximum heat transport capacity of heat pipe with axially grooved wick. When the heat pipe is operated in a steady state, the liquid-vapor meniscus recession of working fluid to the bottom of groove is occurred in the evaporator region. In this work, the optimal charging mass of working fluid was obtained by considering the meniscus recession from the axial variation of capillary pressure, the radius of curvature and wetting angle of meniscus of liquid-vapor interface. Experimental results were also obtained by varying the charging mass of working fluid within a heat pipe, and presented for the trend of maximum heat transport capacity corresponding to the operating temperature and the elevation of heat pipe. Finally, the analytical results of the optimal charging mass of working fluid were compared with those from the experiment, both of which were in good agreement with each other.

Keywords

References

  1. Kemme, Josep E., Aug.1, 1969, Heat Pipe Design Considerations, Report LA-4221-MS, of the Los Alamos Scientific Laboratory of the University of California, Los Alamos, N. Mex. (for presentation at the 11th Heat Transfer Conference, Aug. 3-6, 1969, Min-neapolis, Minn.), pp.1-8
  2. Tathgir, R.G. and Singth, G., 1984, Perfor-mance characteristics of a stainless steel ravity assisted grooved water heat pipe at ow temperature, The Proceeding of 5IHPC Part I, pp. 18-23
  3. Ogushi, T. and Yanmanaka, G., 1986, Heat ransfer performance of axial grooved heat pipes, Trans. JSME, No.86-0252A, pp.600-607
  4. Shin, D.Y., 1987, An Experimental Study on the Optimal Charge of Working Fluid for Heat Pipe, M.S. Thesis of Seoul National University
  5. Lee, W., Park, Y.J., Suh, J.-S. and Kim, M.-G., 1997, Analysis and experiment for thermal performance of grooved heat pipe, Proci. the Air-Conditioning and Refrigera-tion Engng 1997 Summer Annual Meeting, Vol.2, pp.512-517
  6. Park, Y.J.. Kyun, W.S. and Sub, J.-S., 1998, Effects of the groove shape on the thermal performance of a axial groove heat pipe, Proci. the Air-Conditioning and Refrigera-tion Engng 1998 Winter Annual Meeting, Vol.l, pp.257-262
  7. Chi, S.W., 1976, Heat Pipe Theory and Practice, McGraw-Hill, New York
  8. Peterson, G.P., 1994, An Introduction to Heat Pipes, John Wiley & Sons, New York
  9. Feldman Jr. K.T. and Whiting, G.H., 1967, The heat pipe, Mechanical Engineering, pp.30-33
  10. Ivanovskii, M. V., Sorokin, V. P. and Yogodkin, I. V., 1982, The Physical Principles of Heat Pipes, Clarendon Press, Oxford