참고문헌
- Kim, J. H., Jeon, Y. J., Kim, T. S. and Ro, S. T., 1999, 'Analysis of the Dynamic Cha- racteristics of a Small Regenerative Gas Turbine,' Trans. KSME (B), Vol. 23, No. 6, pp. 769-777
- McDonald, C. F. and Wilson, D. G., 1996, 'The Utilization of Recuperated and Regenerated Engine Cycles for High-Efficiency Gas Turbines in the 21st Century,' Applied Thermal Eng, Vol. 16, No. 8, pp. 635-653 https://doi.org/10.1016/1359-4311(95)00078-X
- McDonald, C. F., 1990, 'Gas Turbine Recuperaor Renaissance,' Heat Recovery Systems & CHP, Vol. 10, No. 1, pp. 1-30 https://doi.org/10.1016/0890-4332(90)90246-G
- Asako, Y. and Faghri, M., 1987, 'Finite-Volume Solutions for Laminar Flow and Heat Transfer in a Corrugated Duct,' J. Heat Transfer, Vol. 109, pp. 627-634 https://doi.org/10.1115/1.3248134
- Sawyers, D. R., Sen, M., Chang, H. C., 1998, 'Heat Transfer Enhancement in Three-Dimensional Corrugated Channel Flow,' Int. J. Heat and Mass Transfer, Vol. 23, No. 6, pp. 697-703 https://doi.org/10.1016/S0017-9310(98)00029-5
- Nishimura, T., Yano, K., Yoshino, T. and Kawamura, Y., 'Occurrence and Structure of Taylor-Gortler Vortices Induced in Two-Dimensional Wavy Channels For Steady Flow,' J. Chemical Engineering Of Japan, Vol. 23, No. 6, pp. 697-703
- Rokni, M. and Sunden, B., 1998, '3D Numerical Investigation of Turbulent Foreced Convection in Wavy Ducts with Trapezoidal Cross-section,' Int. J. Numerical Methods for Heat & Fluid Flow, Vol. 8, pp. 118-141 https://doi.org/10.1108/09615539810198069
- Rokni, M. and Gatski, T. B., 2001, 'Predicting Turbulent Convective Heat Transfer in Fully Developed Duct Flows,' Int. J. Heat & Fluid Flow, Vol. 22, pp. 381-392 https://doi.org/10.1016/S0142-727X(01)00104-7
- Goldstein, L. Jr. and Sparrow, E. M., 1977, 'Heat/Mass Transfer Characteristics for Flow in a Corrugated Wall Channel,' J. Heat Transfer, Vol. 99, pp. 187-195 https://doi.org/10.1115/1.3450667
- Utriainen, E. and Sunden, B., 2000, 'Numerical Analysis of a Primary surface Trapezoidal Cross Wavy Duct,' Int. J. Numerical Methods for Heat & Fluid Flow, Vol. 6, pp. 634-648 https://doi.org/10.1108/09615530010347213
- Eckert, E. R. G., 1976, 'Analogies to Heat Transfer Processes, in Measurements in Heat Transfer,' ed. E. R. G. Eckert and R. J. Goldstein, Hemisphere Pub., New York, pp. 397-423
- Rhee, D. H., Kim, B. G. and Cho, H. H., 1998, 'Characteristics of Heat/Mass Transger and Film Cooling Effectiveness Around a Single Film Cooling Hole with Compound Injection Angels,' Trans. KSME (B), Vol. 22, No. 10, pp. 1433-1444
- Ambrose, D., Lawrenson, I. J. and Spake, C. H. S., 1975, 'The Vapor Pressure of Naphthalene,' J. Chem. Thermodynamics, Vol. 7, pp. 1173-1176 https://doi.org/10.1016/0021-9614(75)90038-5
- Goldstein, R. J., Cho, H. H., 1995, 'A Review of Mass Transfer Measurements Using Naphthalene Sublimation,' Experimental Thermal and Fluid Science, Vol. 10, pp. 416-434 https://doi.org/10.1016/0894-1777(94)00071-F
- Kline, S. J. and McClinetock, F., 1953, 'Describing Uncertainty in Single Sample Experiments,' Mech. Engineering, Vol. 75, pp. 3-8
- Rohsenow, W. M., 1998, Handbook of Heat Transfer Part I, Mcgraw-Hill, pp. 5.22-5.31
- Jang, I. H., Hwang, S. D. and Cho, H. H., 2003, 'Effects of Reynolds Number on Flow and Heat/Mass Characteristics Inside the Wavy Duct,' Korean Journal of Air-Conditioning and Refrigeration Engineering, Vol. 15, No. 6, pp. 809-820
피인용 문헌
- Experimental Investigation on the Performance of a Scroll Expander for an Organic Rankine Cycle vol.26, pp.4, 2014, https://doi.org/10.6110/KJACR.2014.26.4.158