DOI QR코드

DOI QR Code

변환각 트러스 모델에 의한 축력을 받는 철근콘크리트 부재의 전단강도 예측

Shear Strength Prediction of Reinforced Concrete Members Subjected In Axial force using Transformation Angle Truss Model

  • Kim Sang-Woo (Dept of Architectural Engineering, Sungkyunkwan University) ;
  • Lee Jung-Yoon (Dept of Architectural Engineering, Sungkyunkwan University)
  • 발행 : 2004.12.01

초록

축하중을 받는 철근콘크리트 부재의 전단강도를 예측하기 위하여, 본 연구에서는 전단력과 축하중 및 휨모멘트를 받는 철근 콘크리트 부재의 전단거동을 예측할 수 있는 변환각 트러스 모델(TATM)을 제안하였다. TATM에서, 축력의 영향을 고려하기 위하여 축압축력이 증가할수록 고정각은 감소하며 균열 방향의 콘크리트 전단저항은 증가한다. TATM의 예측결과가 축력을 받는 철근콘크리트 부재에 대하여 정확성과 신뢰성을 가지는지 검증하기 위하여, 축력을 받는 총 67개의 전단실험 결과를 수집하였으며, TATM 및 기존의 트러스 모델(MCFT, RA-STM FA-STM)과 비교하였다. 수집한 실험결과와 해석결과를 비교한 결과, TATM에 의한 해석결과는 실험결과를 평균 0.95, 변동계수 $12.0\%$로 기존의 트러스 모델보다 더 정확히 예측하였으며, 철근능력비, 축력, 전단경간비 및 압축철근비의 영향을 받지 않았다.

For the prediction of the shear strength of reinforced concrete members subjected to axial force, this paper presents a truss model, Transformation Angle Truss Model (TATM), that can predict the shear behavior of reinforced concrete members subjected to combined actions of shear, axial force, and bending moment. In TATM, as axial compressive stress increases, crack angle decreases and concrete contribution due to the shear resistance of concrete along the crack direction increases in order to consider the effect of the axial force. To verify if the prediction results of TATM have an accuracy and reliability for the shear strength of reinforced concrete members subjected to axial forces, the shear test results of a total of 67 RC members subjected to axial force reported in the technical literatures were collected and compared with TATM and existing analytical models(MCFT RA-STM and FA-STM). As a result of comparing with experimental and theoretical results, the test results was better predicted by TATM with 0.94 in average value of $\tau_{test}/\tau_{ana}$. and $11.2\%$ in coefficient of variation than other truss models. And theoretical results obtained from TATM were not effect by steel capacity ratio, axial force, shear span-to-depth ratio, and compressive steel ratio.

키워드

참고문헌

  1. Vecchio, F. J. and Collins, M P., 'The Modified Compression-Field Theory for Reinforced Concrete Elements Subjected to Shear,' ACI Structural Journal, Vol.83, No.2, 1986, pp.219-231
  2. Hsu, T. T. C., 'Softened Truss Model Theory for Shear and Torsion,' ACI Structural Journal, Vol.85, No.6, 1988, pp.624-635
  3. Hsu, T. T. C., 'Nonlinear Analysis of Concrete Membrane Elements,' ACI Structural Journal, Vol. 88, No.5, 1991, pp.552-561
  4. Pang, X .B. and Hsu, T. T. C., 'Fixed Angle Softened Truss Model for Reinforced Concrete,' ACI Structural Journal, Vol.93, No.2, 1996, pp.197-207
  5. Hsu, T. T. C. and Zhang, L. X, 'Nonlinear Analysis of Membrane Elements by Fixed-Angle SoftenedTruss Model,' ACI Structural Journal, Vol.97, No.5, 1997, pp.483-492
  6. 김상우, 이정윤, '휨모멘트 효과가 고려된 변환각 트러스 모델에 의한 철근콘크리트 보의 전단능력예측', 한국콘크리트학회 논문집, 14권 6호, 2002, pp.910-921
  7. Li, B., Maekawa, K, and Okamura, H, 'Contact Density Model for Stress Transfer Across Cracks in Concrete,' Journal of the Faculty of Engineering, Vol.40, No.1, 1989, pp.9-52
  8. Watanabe, F. and Lee, J.-Y., 'Theoretical Prediction of Shear Strength and Ductility of Reinforced Concrete Beams,' ACI Strcutural Journal, Vol.95, No.6, 1998, pp.749-757
  9. Li, B., 'Shear Transfer Behavior of Cracked Concrete Under Cyclic Loading,' Ph.D Dissertation, University of Tokyo, 1988, 121pp
  10. Yoshikawa, H., Wu, Z., and Tanabe, T., 'Analytical Model for Shear Slip of Cracked Concrete,' Journal of Structural Engineering, Vol.l15, No.4, April 1989, pp.771-783
  11. Collins, M. P. and Mitchell, D., 'Prestressed Concrete Structures,' Prentice Hall Inc., Englewood Cliffs, New Jersey, 1991, 766 pp
  12. Taub, J. and Neville, A M, 'Resistance to Shear of Reinforced Concrete Beams,' ACI Journal, Proceedings Vol.57, Aug. 1960, pp.193-220
  13. Wilby, C. B., 'The Strength of Reinforced Concrete Beams in Shear,' Magazine cf Concrete Research (London), No.7, Aug. 1951, pp.23-30
  14. Al-Alusi, A. F., 'Diagonal Tension Strength of Reinforced Concrete T-Beams with Varying Shear Span,' ACI Journal, Proceedings Vol.53, No.11, May 1957, pp.1067-1077
  15. Bernander, K. G., 'An Investigation of the Shear Strength of Concrete Beams Without Stirrups or Diagonal Bars, Reinforced with High Tensile Steel with Various Rib Patterns,' RILEM Symposium on Bond and CraIk Formation in Reinforced Concrete, Stockholm, 1957, pp.211 -214
  16. Park, R. and Pauley, T., 'Reinforced Concrete Structures,' John Wiley & Sons Inc., New York, 1975, 769pp
  17. Haddadin, M. J., Hong, S.-T., and Mattock, A. H, 'Stirrup Effectiveness in Reinforced Concrete Beams with Axial Force,' Proceedings, ASCE, Vol.97, No. ST9, Sep., 1971, pp.2277-2297
  18. Bresler, B. and Pister, K. S., 'Strength of Concrete Under Combined Stresses,' ACI Journal, Proceedings Vol.55, No.3, Sep., 1958, pp.321-345
  19. 김상우, '적합조건을 고려한 트러스 모델에 의한 철근콘크리트 부재의 전단거동 예측', 성균관대학교, 박사학위논문, 2003
  20. 六車熙, 富永惠, 渡辺史夫, '輕量RC柱のせん 斷破환實驗と2,3 の 考察', ヤメント技術年報 25倦, 1971, pp.357-362
  21. 池田昭男, 廣澤雅也, 山田國正, '輕量骨材を 用にた 鐵筋 コンクりート柱のせん 斷破壞實驗報告,その1 :强度について, 日本建築學會大會學術講演梗槪集, 構造系, 1967.10, 325pp.
  22. 六車熙, 渡변史夫, 村上성, 西村章, '鐵筋 コンク りート柱 のせん斷力傳達 關 實驗的硏究', ヤメント技術年報 32倦, 1978, pp.440-443
  23. 黑正淸治, 松崎育弘, 林靜雄, 小林克巳, 偉川哲光, 能谷仁志, 武거泰, 夫타量, '高强度 セん斷補强筋 を用 いたRC柱に 關 する實驗硏究', 日本件築學會大會學術講演槪集, 1987.10. pp.483-486
  24. Bentz, E. C., 'Sectional Analysis of Reinforced Concrete Members,' Ph.D dissertation, Univ. of Toronto, Canada, 2000
  25. Bentz, E. C. and Collins, M. P., 'http//www. civ.utoronto.ca/sect/streng/index3.html,' Web Address of Response-2000

피인용 문헌

  1. Shear Behavior Models of Steel Fiber Reinforced Concrete Beams Modifying Softened Truss Model Approaches vol.6, pp.10, 2013, https://doi.org/10.3390/ma6104847
  2. Single Web Shear Element Model for Shear Strength of RC Beams with Stirrups vol.12, pp.1, 2018, https://doi.org/10.1186/s40069-018-0252-9