DOI QR코드

DOI QR Code

Seismic resistance and mechanical behaviour of exterior beam-column joints with crossed inclined bars

  • Bakir, P.G. (Faculty of Civil Engineering, Istanbul Technical University)
  • 투고 : 2003.01.23
  • 심사 : 2003.07.03
  • 발행 : 2003.10.25

초록

Attempts at improving beam-column joint performance has resulted in non-conventional ways of reinforcement such as the use of the crossed inclined bars in the joint area. Despite the wide accumulation of test data, the influence of the crossed inclined bars on the shear strength of the cyclically loaded exterior beam-column joints has not yet been quantified and incorporated into code recommendations. In this study, the investigation of joints has been pursued on two different fronts. In the first approach, the parameters that influence the behaviour of the cyclically loaded beam-column joints are investigated. Several parametric studies are carried out to explore the shear resisting mechanisms of cyclically loaded beam-column joints using an experimental database consisting of a large number of joint tests. In the second approach, the mechanical behaviour of joints is investigated and the equations for the principal tensile strain and the average shear stress are derived from joint mechanics. It is apparent that the predictions of these two approaches agree well with each other. A design equation that predicts the shear strength of the cyclically loaded exterior beam-column joints is proposed. The design equation proposed has three major differences from the previously suggested design equations. First, the influence of the bond conditions on the joint shear strength is considered. Second, the equation takes the influence of the shear transfer mechanisms of the crossed inclined bars into account and, third, the equation is applicable on joints with high concrete cylinder strength. The proposed equation is compared with the predictions of the other design equations. It is apparent that the proposed design equation predicts the joint shear strength accurately and is an improvement on the existing code recommendations.

키워드

참고문헌

  1. ACI-ASCE Committee 352R-91 (1998), "Recommendations for the design of beam-column joints in monolithic, reinforced concrete structures", ACI Manual of Concrete Practice: Part 3, Detroit, American Concrete Institute, 1998.
  2. ACI Committee 318 (1995), "Building code requirements for structural concrete (ACI 318-95) and commentary (318R-95)", American Concrete Institute, Farmington Hills, Michigan, 369pp.
  3. Alameddine, F.F. (1990), "Seismic design recommendation for high strength concrete beam-to-column connections", PhD Thesis, University of Arizona, 257pp.
  4. Architectural Institute of Japan (1990), "Design guidelines for earthquake resistant reinforced concrete buildings based on ultimate strength concept and commentary", 340pp.
  5. Bakir, P.G. (2003a), "A proposal for national mitigation strategy in Turkey", Submitted to Natural Hazards Journal for Possible Publication.
  6. Bakir, P.G. (2003b), ''Shear transfer mechanisms in exterior beam-column joints", Journal of Advanced Materials, Accepted for Publication in 2003.
  7. Bakir, P.G. and Boduroglu, M.H. (2002a), "Earthquake risk and hazard mitigation in Turkey", Earthquake Spectra, 18(3), 427-447, August, EERI. https://doi.org/10.1193/1.1503341
  8. Bakir, P.G. and Boduroglu, M.H. (2002b), "Mitigating against earthquakes in Turkey", (special paper), Proc. of the 12th European Conf. on Earthq. Eng., London, UK.
  9. Bakir, P.G. and Boduroglu, M.H. (2002d), "A new design equation for predicting the shear strength of the monotonically loaded exterior-beam column joints", Eng. Struct. J., 24(8), 1105-1117, August, Elsevier Science. https://doi.org/10.1016/S0141-0296(02)00038-X
  10. Bakir, P.G. and Boduroglu, M.H. (2002e), "Predicting the failure modes of monotonically loaded reinforced concrete exterior beam-column joints", Struct. Eng. Mech., An Int. J., 14(3), 307-330, September, Techno-Press. https://doi.org/10.12989/sem.2002.14.3.307
  11. Boduroglu, M.H. and Bakir, P.G. (2002c), "Proposals for earthquake planning in Turkey", Proc. of the 12th European Conf. on Earthq. Eng., London, UK.
  12. Collins, M.P. and Mitchell, D. (1991), Prestressed Concrete Structures, Prentice Hall, Englewood Cliffs, New Jersey, 07362.
  13. Ehsani, M.R. and Wight, J.K. (1985), "Exterior reinforced concrete beam-to-column connections subjected to earthquake type loading", ACI Struct. J., 82(3), 343-349.
  14. Fuji, S. and Morita, S. (1991), "Comparison between interior and exterior reinforced concrete beam-column joint behaviour", Design of Beam-Column Joints for Seismic Resistance, SP-123, J.O. Jirsa ed., American Concrete Institute, Farmington Hills, Michigan, 167-185.
  15. Kaku, T. and Akasuka, H. (1991), "Ductility estimation of exterior beam-column subassemblies in reinforced concrete frames", Design of Beam-Column Joints for Seismic Resistance, SP-123, J.O. Jirsa ed., American Concrete Institute, Farmington Hills, Michigan, 167-185.
  16. Kitayama, K., Otani, S. and Aoyama, H. (1991), ''Development of design criteria for RC interior beam-column joints'', Design of Beam-Column Joints for Seismic Resistance, SP-123-4, J.O. Jirsa ed., American Concrete Institute, Farmington Hills, Michigan, 167-185.
  17. Kurose, Y. (1993), ''Design of beam-column joints for shear'', A Volume Honouring Hiroyuki Aoyama, University of Tokyo publications, 488.
  18. Megget, L.M. (1974), "Cyclic behaviour of exterior reinforced concrete beam-column joints", Bulletin of the New Zealand National Society for Earthquake Engineering, 7(1), 27-47.
  19. Pantazopoulou, S. and Bonacci, J. (1992), "Consideration of questions about beam-column joints", ACI Struct. J., 89(1), 27-39.
  20. Park, R. and Paulay, T. (1975), ''Reinforced concrete structures'', John Wiley and Sons, New York, p.769.
  21. Paulay, T. and Park, R. (1984), ''Joints in reinforced concrete frames designed for earthquake resistance'', Research Report 84-9, Department of Civil Engineering, University of Canterbury, Christchurch, New Zealand.
  22. Paulay, T., Park, R. and Priestley, M.J.N. (1978), ''Reinforced concrete beam-column joints under seismic actions'', Journal of the ACI, Proceedings, 75(11), 585-593.
  23. Paulay, T. and Priestly, M.J.N. (1992), ''Seismic design of reinforced concrete and masonry buildings'', John Wiley & Sons, New York, 744.
  24. Paulay, T. and Scarpas, A. (1981), "Behaviour of exterior beam-column joints", Bulletin of the New Zealand National Society for Earthquake Engineering, 14, 131-144.
  25. Paulay, T. (1986), "Critique of the special provisions for seismic design of the building code requirements for reinforced concrete (ACI 318-83)", ACI Struct. J., 83(2), 274-283.
  26. Snedecor, G.W. and Cochran, W.G. (1980), Statistical Methods, 7th edition. Iowa State University Press, Ames.
  27. The Design of Concrete Structures, NZS 3101:1995 (1995), Standards 3101:1995, Standards New Zealand, Wellington.
  28. Tegos, I.A. (1984), ''Contribution to the study and improvement of earthquake-resistant mechanical properties of low slenderness structural elements'', PhD Thesis, Aristotle University of Thessaloniki, 185pp. (in Greek).
  29. Tsonos, A.G., Tegos, I.A. and Penelis, G. Gr. (1992), "Seismic resistance of type 2 exterior beam-column joints reinforced with inclined bars", ACI Struct. J., 89(1), 307-330.
  30. Tsonos, A.G. (1997), ''Shear strength of ductile reinforced concrete beam-to-column connections, for seismic resistant structures'', J. European Earthq. Eng., 2, 54-64.
  31. Tsonos, A.G. (1999), ''Lateral load response of strengthened reinforced concrete beam-to-column joints'', ACI Struct. J., 96(1), 46-56.
  32. Tsonos, A.G. (2000), ''Effect of vertical hoops on the behaviour of reinforced concrete beam-to-column connections'', J. European Earthq. Eng., 2, 13-26.
  33. Tsonos, A.G. (2001a) ''Seismic retrofit of R/C beam-to-column joints using local three-sided jackets'', J. European Earthq. Eng., 1, 48-64.
  34. Tsonos, A.G. (2001b), ''Seismic rehabilitation of reinforced concrete joints by the removal and replacement technique'', J. European Earthq. Eng., 3, 29-43.
  35. Uzumeri, S.M. (1977), ''Strength and ductility of cast-in-place beam-column joints'', Reinforced Concrete in Seismic Zones , Publication SP-53, American Concrete Institute, Detroit, 1977, 293-350.
  36. Vollum, R.L. (1998), ''Design and analysis of exterior beam-column connections", PhD thesis, Imperial College of Science Technology and Medicine-University of London.

피인용 문헌

  1. Parametric Study of Exterior Shear Wall–Floor Slab Connections vol.29, pp.6, 2015, https://doi.org/10.1061/(ASCE)CF.1943-5509.0000498
  2. Seismic behaviour of infilled and pilotis RC frame structures with beam–column joint degradation effect vol.33, pp.10, 2011, https://doi.org/10.1016/j.engstruct.2011.06.006
  3. Interior wide beam-column connections in existing RC frames subjected to lateral earthquake loading vol.8, pp.2, 2010, https://doi.org/10.1007/s10518-009-9144-3
  4. Reinforced concrete beam–column joints with crossed inclined bars under cyclic deformations vol.37, pp.6, 2008, https://doi.org/10.1002/eqe.793
  5. Seismic design of RC external beam-column joints vol.10, pp.2, 2012, https://doi.org/10.1007/s10518-011-9303-1
  6. Improvement of the earthquake resistance of R/C beam-column joints under the influence of P-△ effect and axial force variations using inclined bars vol.18, pp.4, 2004, https://doi.org/10.12989/sem.2004.18.4.389
  7. Shear strength of reinforced concrete beam-column joints with crossed inclined bars vol.140, 2017, https://doi.org/10.1016/j.engstruct.2017.02.072
  8. Evaluation of the influence of the column axial load on the behavior of monotonically loaded R/C exterior beam–column joints through numerical simulations vol.30, pp.4, 2008, https://doi.org/10.1016/j.engstruct.2007.06.005
  9. Seismic resistance of exterior beam-column joints with non-conventional confinement reinforcement detailing vol.30, pp.6, 2008, https://doi.org/10.12989/sem.2008.30.6.733
  10. Shear strength criteria for design of RC beam–column joints in building codes pp.1573-1456, 2018, https://doi.org/10.1007/s10518-018-0492-8
  11. Behavior of exterior reinforced concrete beam-column joints including a new reinforcement vol.40, pp.6, 2003, https://doi.org/10.12989/sem.2011.40.6.867
  12. Comparative performance of seismically deficient exterior beam-column sub-assemblages of different design evolutions: A closer perspective vol.13, pp.2, 2017, https://doi.org/10.12989/eas.2017.13.2.177
  13. Experimental investigations and FE simulation of exterior BCJs retrofitted with CFRP fabric vol.17, pp.4, 2003, https://doi.org/10.12989/eas.2019.17.4.337
  14. Strut-and-tie model for shear strength prediction of RC exterior beam-column joints under seismic loading vol.18, pp.4, 2020, https://doi.org/10.1007/s10518-019-00756-4
  15. Plastic hinge relocation in exterior reinforced beam-column joint and compliance issues to seismic design guidelines-A review vol.21, pp.5, 2020, https://doi.org/10.1002/suco.201900008
  16. Strengthening of deficient RC joints with diagonally placed external C-FRP ropes vol.20, pp.1, 2003, https://doi.org/10.12989/eas.2021.20.1.123
  17. Analytical Model for the Design of HSFC and UHSFC Jackets with Various Steel Fiber Volume Fraction Ratios for the Retrofitting of RC Beam-Column Joints vol.13, pp.20, 2003, https://doi.org/10.3390/su132011209
  18. Retrofit of External Beam-Column Concrete Joints with Diagonally Crossed Reinforcement: Experimental and Analytical Investigations vol.27, pp.1, 2022, https://doi.org/10.1061/(asce)sc.1943-5576.0000638
  19. Implicit framework for developing design recommendations on shear strength of RC beam-column joints vol.47, pp.None, 2003, https://doi.org/10.1016/j.jobe.2021.103877