Development of a Solar Powered Water Pump by Using Low Temperature Phase Change Material ­ System Construction and Operation Analysis ­

저온 상변화 물질 특성을 이용한 태양열 물펌프 실용화 연구개발(II) ­시스템 구성 및 작동분석

  • 김영복 (경상대학교 농업생명과학대학 농업시스템공학부, 농업생명과학연구원) ;
  • 이양근 (상주대학교 기계공학부) ;
  • 이승규 (경상대학교 농업생명과학대학 농업시스템공학부, 농업생명과학연구원) ;
  • 김성태 (경상대학교 농업생명과학대학 농업시스템공학부, 농업생명과학연구원) ;
  • 나우정 (경상대학교 농업생명과학대학 농업시스템공학부, 농업생명과학연구원) ;
  • 민영봉 (경상대학교 농업생명과학대학 농업시스템공학부, 농업생명과학연구원)
  • Published : 2003.12.01

Abstract

In this study, the energy conversion equipment from the radiation energy to mechanical energy by using n­pentane as the operating fluid was constructed and the performance to pump the water was tested for the utilization of solar powered water pump. The equipment was designed optimally, after the theoretical analyses of the water pumping head and water quantity per cycle were done. The pentane vapour temperature in the condenser and the temperature of the outlet water from the condenser became lowered and the heat transfer rate became higher with decreasing the water inlet level to the condenser. The temperature difference between the condenser and the water tank was significant. Therefore, the distance between the water tank and condenser was recommended to be shorten and the diameter of their connecting pipe was recommended to be narrow in order to reduce the resistance of the fluid passage and improve the heat transfer rate. The amount of water pumped was 1.6­2.4 liters. Mass flow rate of the cooling water became lowered when the cooling water pipe was prolonged from the condenser to improve the heat transfer rate.

태양열을 동력원으로 하여 열에너지를 동력으로 변환, 물을 양수할 목적으로 저온 상변화물질인 펜탄을 작동물질로 하는 에너지변환장치를 제작하여 실험하였다. 장치는 각부의 크기를 그 기능과 상호작용 원리에 따라 논리에 맞게 최적 설계하였다. 장치의 제작 후 실험을 통하여 그 운전 특성을 분석하여 성능향상에 필요한 자료를 획득하고자 하였다. 작동물질인 펜탄을 가열하는 탱크 내부의 온도는 사이클 경과시간에 따라 약 $40­86^{\circ}C$ 범위에서 변동하고 있었으며, 물탱크내 온도 약 $23­24^{\circ}C$, 공기탱크 내 온도 $22­23.5^{\circ}C$ 범위에서 비교적 일정하게 유지되고 있었다. 응축기내의 온도와 냉각수출구 온도는 냉각수입구 온도수준에 따라 정의 상관관계로 변하고 있는 것을 알 수 있었으며, 또한 열 교환 능력도 냉각수 온도수준이 낮을수록 커진다는 것을 확인하였다. 물탱크 내 온도와 응축기내 온도가 상당히 차이가 나므로 물탱크와 응축기와의 연결거리를 최소화하고 연결파이프 크기를 큰 것으로 하여 내부물질이동 저항을 줄이는 것이 바람직하다는 것을 알 수 있었다. 실험 중 양수량은 1.6­2.4 liter로 나타났으며, 냉각시간의 수준에 따른 물탱크내의 흡입물높이 상승은 차이를 나타내지 않았다. 응축기로부터의 냉각수 배출파이프가 연장되지 않은 경우 냉각수 유량이 5.9 liter/min 이었으나 연장파이프가 있을 때는 2.3 liter/min으로 나타났다. 이러한 현상에서 양수하는 물의 온도가 낮고 유량이 부족한 경우에는 연장파이프를 이용하는 것이 좋고, 냉각수치 양은 풍부하지만 그 온도가 낮지 않은 경우에는 연장파이프를 이용하지 않는 것이 좋다는 사실을 알 수 있다. 실험에서의 응축기내 냉각수의 최대 열교환량은 95.75 kJ/min로 나타났다. 작동물질가열탱크와 기액 분리탱크 내의 압력은 0.13­0.14 MPa.a, 물탱크와 응축기내의 압력은 약 0.11 MPa.a정도로 나타났다.

Keywords