DOI QR코드

DOI QR Code

저온 경화형 Ag 페이스트 및 이를 이용한 Ag 후막의 제조 및 특성

Properties of Ag Thick Films Fabricated by Using Low Temperature Curable Ag Pastes

  • Park, Joon-Shik (Nano Mechatronics Research Center, Korea Elentronics Technology Institute) ;
  • Hwang, Joon-Ho (Nano Mechatronics Research Center, Korea Elentronics Technology Institute) ;
  • Kim, Jin-Gu (Sung Jee Tech) ;
  • Kim, Yong-Han (Sung Jee Tech) ;
  • Park, Hyo-Derk (Nano Mechatronics Research Center, Korea Elentronics Technology Institute) ;
  • Kang, Sung-Goon (Div. of Materials Science and Engineering, Han Yang University)
  • 발행 : 2003.01.01

초록

Properties of Ag thick films fabricated by using low temperature curable silver pastes were investigated. Ag pastes were consisted of polymer resins and silver powders. Ag pastes were used for conductive or fixing materials between board and various electrical and electronic devices. Low temperature curable Ag pastes have some advantages over high temperature curable types. In cases of chip mounting, soldering properties were required for screen printed Ag thick films. In this study, four types of Ag pastes were fabricated with different compositions. Screen printed Ag thick films on alumina substrates were fabricated at various curing temperatures and times. Thickness, resistivity, adhesive strength and solderability of fabricated Ag thick films were characterized. Finally, Ag thick films produced using Ag pastes, sample A and B, cured at $150^{\circ}C$ for longer than 6 h and $180^{\circ}C$ for longer than 2 h, and $150^{\circ}C$ for longer than 1 h and $180^{\circ}C$ for 1 h, respectively, showed low resistivities of $10^{-4}$ $∼10^{-5}$ Ωcm and good adhesive strength of 1∼5 Mpa. Soldering properties of those Ag thick films with curing temperatures at solder of 62Sn/36Pb/3Ag were also investigated.

키워드

참고문헌

  1. R. J. Klein Wassink, 'Soldering in Electronics', 2nd edition, pp. 300-314, Electrochemical Publications Limited, Bristol, England, (1989)
  2. IEC 68-2-54, 'Basic environmental testing procedures. Part 2 : Solderability testing by the wetting balance method' (1985)
  3. P. J. holmes and R. G. Loasby, 'Hanbook of Thick Film Technology', Chapter 1, Electrochemical Publications Limited, 106 (1976)

피인용 문헌

  1. A Method for Application of Ammonium-based Pretreatment Solution in Preparation of Copper Flakes Coated by Electroless Ag Plating vol.22, pp.4, 2015, https://doi.org/10.6117/kmeps.2015.22.4.057