Performance of the Squirrel Cage Induction Motor with High Temperature Superconducting Rotor Bars at Stable Operating Region

고온초전도단락봉을 사용한 농형유도전동기의 안정영역 특성

  • Published : 2003.09.01

Abstract

Motors with HTS wires or bulks have been developing recently. Those are large synchronous motor with HTS wires at the field winding in the rotor, hysteresis and reluctance motors with HTS bulk in the rotor. This paper presents the fabrication and test results of an HTS induction motor. Conventional end rings and short bars were replaced with HTS wires in the motor. Stator of the conventional induction motor was used as the stator of the HTS motor. Rated capacity and rpm at full rotor of the conventional motor were 0.75[kW] and 1,710[rpm]. Two, HTS wires are used in parallel to make the end rings and bars. The critical current of the BSCCO-2223 HTS wire which was used in the bars and end rings were 115[A]. Electrodynamometer was coupled directly to the shaft of the rotor with HTS wires.

Keywords

References

  1. J. D. Edick and R. F. Schiferl, 'High Temperature Superconductivity Applied to Electric Motors,' IEEE Trans. Appl. Supercond., Vol. 2, No.4, pp.189-193, 1992 https://doi.org/10.1109/77.182730
  2. D. Aized, B. B Gamble, A. Sidi-Yekhlef and J. P. Voccio, 'Status of the 1,000hp HTS Motor Development,' IEEE Trans. Appl. Supercond., Vol. 9, No.4, pp.1197-1200, 1999 https://doi.org/10.1109/77.783514
  3. A. Ishiyama and K. Hayashi, 'Design and Construction of a Superconduction Cylindrical Linear Induction Motor with AC Superconducting Primary Windings,' IEEE Trans. Appl. Supercond., Vol. 9, No.2, pp.1217-1220, 1999 https://doi.org/10.1109/77.783519
  4. J. Sim et al., 'Test of an Induction Motor with HTS wire at end ring and bars,' IEEE Trans. Appl. Supercond., Vol. 13, No.2, pp.2231-2234, 2003 https://doi.org/10.1109/TASC.2003.813053