Journal of Mechanical Science and Technology

The Korean Society of Mechanical Engineers (대한기계학회)
권호 표지

Experimental Studies on Heat Transfer in the Annuli with Corrugated Inner Tubes

  • Ahn, Soo-Whan (School of Mechanical and Aerospace Engineering, Gyeongsang National University, Institute of Marine Industry)
  • Published : 2003.08.01
Download PDF
⟨ Previous Next ⟩

Abstract

Experimental heat transfer data for single-phase water flow in the annuli with corrugated inner tubes are presented. In the annuli with parallel flow, ten different annular arrangements are considered. For water flow rate in 1,700${\gamma}$$\^$*/). As P/e becomes closer to 8 in the range below the radius ratio (${\gamma}$$\^$*/) of 0.5, Nusselt numbers increase. However, Nusselt numbers decrease in the range above the radius ratio (${\gamma}$$\^$*/) of 0.5 because flow reattachment position becomes farther in the narrower clearance.

Keywords

References

  1. Ahn, S. W., Kim, K. C. and Lee,Y. P., 1994, 'Fully Developed Turbulent Flow and Heat Transfer in Concentric Annuli With Square-Ribbed Roughness,' Trans. KSME, Vol. 18, No. 4, pp. 1072-1088
  2. Bergles, A. E., 1980, Heat Transfer Characteristics of Turbotec Tubing, Heat Transfer Laboratory Report HTL-24 ISU-ERI-Ames-81018, Iowa State University
  3. Garimella, S., 1990, Experimental Investigation of Heat Transfer and Pressure Drop Characteristics of Annuli With Spirally Fluted Inner Tubes, Ph. D. Dissertation, The Ohio State University
  4. Garimella, S. and Christensen, R. N., 1993, 'Experimental Investigation of Fluid Flow Mechanisms in Annuli with Spirally Fluted Inner Tubes,' ASHRAE Trans, Vol. 99, Part 1, pp. 1205-1216
  5. Garimella, S. and Christensen, R. N., 1995a, 'Heat Transfer and Pressure Drop Characteristics of Spirally Fluted Annuli: Part Ⅰ- Hydrodynamics ,' ASME Journal of Heat Transfer, Vol. 117, No. 54, pp. 54-60 https://doi.org/10.1115/1.2822323
  6. Garimella, S. and Christensen, R. N., 1995b, 'Heat Transfer and Pressure Drop Characteristics of Spirally Fluted Annuli: Part Ⅱ- Heat Transfer,' ASME Journal of Heat Transfer, Vol. 117, No. 54, pp. 61-68 https://doi.org/10.1115/1.2822324
  7. Kays, W. M., Crawford, M. E., 1993, Convective Heat and Mass Transfer, McGraw-Hill Co., pp. 138-152
  8. Kays, W. M. and Leung, E. Y., 1963, 'Heat Transfer in Annular Passages: Hydrodynamically Developed Flow with Arbitrarily Prescribed Heat Flux,' Int. J. Heat Mass Transfer, Vol. 6, pp. 537-557 https://doi.org/10.1016/0017-9310(63)90012-7
  9. Kline, S. J. and McClintock, F. A., 1953, 'Describing Uncertainties on Single Sample Experiments,' Mechanical Engineering, Vol. 57, pp. 3-8
  10. Lawn, C. J., 1974, 'The Use of an Eddy Viscosity Model to Predict the Heat Transfer and Pressure Drop Performance of Roughened Surfaces,' Int, J. Heat Mass Transfer, Vol. 17, pp. 421-428 https://doi.org/10.1016/0017-9310(74)90013-1
  11. Marto, P. J., Reilly, R. J. and Fenner, J. H., 1979, 'An Experimental Comparison of Enhanced Heat Transfer Condenser Tubing in: Advance in Heat Transfer,' ASME, NewYork, pp. 1-9
  12. Nakayama, W., Takahashi, K. and Daikoku, T., 1983, 'Spiral Ribbing to Engance Single Phase Heat Transfer Inside Tubes,' ASME-JSME Thermal Engineering Joint Conference Proceedings, Honolulu, HI, Vol. 1, pp. 365-372
  13. Petukhov, B.S., 1970, Heat Transfer and Friction in Turbulent Pipe Flow Variable Physical Properties, in : Advance in Heat Transfer, T. F. Irvine, and J. P. Hartnett, Vol. 6, Academic Press
  14. Petukhov, B. S. and Popov, V. N., 1963, 'Theoretical Calculation of Heat Exchange and Frictional Resistance in Turbulent Flow in Tubes of an Incompressible Fluid With Variable Physical Properties,' High Temperature, Vol. 1, pp. 69-83
  15. Ravigururajan, T. S. and Bergles, A. E., 1985, 'General Correlation for Pressure Drop and Heat Transfer for Single Phase Turbulent Flow in Internally Ribbed Tubes, in : Augumentation of Heat Transfer in Energy System,' ASME-HTD-Vol. 52, pp. 9-20
  16. Wilkie, D., 1966, 'Forced Convection Heat Transfer from Surface Roughened by Transverse Ribs,' 3rd International Heat Transfer Conference, Chicago, Illinois, Vol. 1, p. 19
  17. Withers, J. G., 1980a, 'Tube-Side Heat Transfer and Pressure Drop for Tubes Having Helical Internal Riding With Turbulent/Transitional Flow of Single Phase Fluid, Part 1. Single-Helix Ridging,' Heat Transfer Engineering, Vol. 2, No. 1, pp. 48-58 https://doi.org/10.1080/01457638008962750
  18. Withers ,J. G., 1980b, 'Tube-Side Heat Transfer and Pressure Drop for Tubes Having Helical Internal Ridging with Turbulent/Transitional Flow of Single Phase Fluid, Part 2. Multiple Helix Ridging,' Heat Transfer Engineering, Vol. 2, No. 2, pp. 43-50 https://doi.org/10.1080/01457638008962755