DOI QR코드

DOI QR Code

Effect on Boiling Bleat Transfer of Horizontal Micro-channel Diameters for R-22 and R-407C

수평미세관의 직경이 R-22 및 R-407C 비등열전달에 미치는 영향

  • 윤국영 (여수대학교 대학원 냉동공학과) ;
  • 최광일 (여수대학교 대학원 냉동공학과) ;
  • 오종택 (여수대학교 냉동공학과)
  • Published : 2003.02.01

Abstract

Boiling heat transfer coefficients and pressure drops for R-22 and R-407C were measured in horizontal micro-channels. The test section is stainless steel tube, inner tube diameters are 1.8mm and 2.8mm, and the respective lengths are 1500mm and 3000mm. The range of mass flux is 300-600kg/$m^2$s and heat flux is 5-15kW/$m^2$. In this results, pressure drop increased linearly for both R-22 and R-407C with increased mass flux, but the increase of heat flux did not affect the pressure. In addition, the pressure drop was fairly increased in the high quality region rather than low quality region. In the range of low quality, the mass flux had a small affect on the heat transfer coefficients, however, in high quality region, the heat transfer coefficients increased even more with increasing mass flux. Under the low quality region and low mass flux, the heat transfer coefficients increased with increasing heat flux densities. The effects of inner tube diameter were clearly observed. Namely, the measured pressure drop inside inner tube diameter 1.8 mm is higher than 2.8 mm with increasing the mass flux and heat flux. Also, the measured local heat transfer coefficient inside inner tube diameter 1.8 mm is higher than 2.8 mm in the range of high qualities. The experimental data for R-407C compared with proposed correlation using pure refrigerant. The experimental data for R-407C was more decreased than the proposed correlation for pure refrigerant up to 50% or more.

Keywords

References

  1. Goto, M, Kambe, K., Inoue, N. and Sato, M., 1994, 'Condensation Heat Transfer of HCFC-22 and HFC-32/HFC-125HFC-134a Inside an Internally Grooved Horizontal Tube,' 31st National Heat Transfer Symposium of Japan, G221, pp.736-738
  2. Oh, J. T., Choi, K. I., Aoyama, Y., Saito, S. and Hihara, E., 1999, 'Effect of Tube Diameter on Boiling Heat Transfer for R-407C Inside a Horizontal Tube,' Proc. SAREK'99 Summer Annual Conference(I), pp. 14-18
  3. Oh, J. T., Park, K. W., Oh, H. K., L. Zhang, and Hihara, 1996, 'Forced Convective Boiling Heat Transfer of a Ternary Refrigeration Mixture for HCFC22 Alternative,' Proc. KSME 1996 Fall Annual Meeting B, pp. 749-754
  4. Hwang, Y. W. and Kim, M. s., 2001, 'An Experimental Study on Evaporative Heat Transfer Characteristics in a Small Diameter Tube,' Trans. KSME B, Vol.25, No., pp. 216-224
  5. Oh, H. K., Katsuta, M. and Shibata, K., 1998, 'Heat Transfer Characteristics of R-134a in a Capillary Tube Heat Exchanger,' Heat Transfer 1998, Proceeding of 11th IHTC, Vol. 6, pp. 13 1-136
  6. Zang, L., Hihara, E., Satio, T. and Oh, J. T., 1997, 'Boiling Heat Transfer of a Ternary Refrigerant Mixture Inside a Horizontal Smooth Tube,' Int. J. Heat Mass Transfer, Vol. 40, No. 9, pp. 2009-2017 https://doi.org/10.1016/S0017-9310(96)00301-8
  7. Yang, C. Y. and Webb, R. L., 1997, 'A Predictive Model for Condensation in Small Hydraulic Diameter Tubes Having Axial Micro-Fins,' ASME journal of Heat Transfer, Vol. 119, pp. 776-782 https://doi.org/10.1115/1.2824182
  8. Wang, C. C, Kuo, C. S., Chang, Y. J. and Lu, D. C, 1996, 'Two-Phase Flow Heat Transfer and Friction Characteristics of R22 and R407C,' ASHRAE transactions : Symposia
  9. Barajas, M. and Panton, R.l, 1993, 'The Effect of Contact Angle on Two-Phase Flow in Capillary Tubes,' Int. J. Multiphase Flow, Vol. 19, No. 2, pp. 337-346 https://doi.org/10.1016/0301-9322(93)90007-H
  10. Yang, C. Y. and Webb, R. L., 1996, 'Friction Pressure Drop of R-12 in Small Hydraulic Diameter Extruded Aluminum Tubes with and Without Micro-fins,' Int. J. Heat Mass Transfer, Vol. 39, No. 4, pp. 801-809 https://doi.org/10.1016/0017-9310(95)00151-4
  11. Yan, Y. Y. and Lin, T. F., 1998, 'Evaporation Heat Transfer and Pressure Drop of Refrigerant R-134a in a Small Pipe,' Int. J. Heat Mass Transfer, Vol. 41, No. 24, pp. 4183-4194 https://doi.org/10.1016/S0017-9310(98)00127-6
  12. Fukano, T. and Kariyasaki, A., 1993, 'Characteristics of Gas-Liquid Two-Phase Flow in a Capillary Tube,' Nuclear Engineering and Design, Vol. 141, pp. 59-68 https://doi.org/10.1016/0029-5493(93)90092-N
  13. Kew, P. A. and Cornwell, K., 1997, 'Correlations for The Prediction of Boiling Heat Transfer in Small-Diameter Channels,' Applied Thermal Engineering, Vol. 17, pp. 705-715 https://doi.org/10.1016/S1359-4311(96)00071-3
  14. Wambsgans, M. W., France, D. M., Jendrzejczyk, J. A., and Tran, T. N., 1993, 'Boiling Heat Transfer in a Horizontal Small-Diameter Tube,' ASME journal of Heat Transfer, Vol. 115, pp. 963-972 https://doi.org/10.1115/1.2911393
  15. Peng, X. F. and Wang, B. X., 1993, 'Forced Convection and Flow Boiling Heat Transfer for Liquid Flowing Through Micro Channels,' Int. J. Heat Mass Transfer, Vol. 36, No. 14, pp. 3421-3427 https://doi.org/10.1016/0017-9310(93)90160-8
  16. Lee, H. J., Lee, S. Y., 2001, 'Heat Transfer Correlation for Boiling Flows in Small Rectangular Horizontal Channels with Low Aspect Ratios,' Int. J. of Multiphase Flow, Vol. 27, pp. 2043-2062 https://doi.org/10.1016/S0301-9322(01)00054-4
  17. Tran, T. N., Chyu, M. C, Wambsganss, D. M. and France, D. M., 2000, 'Two-Phase Pressure Drop of Refrigerants During Flow Boiling in Small Channels: an Experimental Investigation and Correlation Development,' Int. J. of Multiphase Flow, Vol. 26, pp. 1739-1754 https://doi.org/10.1016/S0301-9322(99)00119-6
  18. Chen, J. C, 1966, 'A Correlation for Boiling Heat Transfer to Saturated Fluids in Vertical Flow,' Heat Transfer Engineering, Vol. 1, No. 4, pp. 32-37 https://doi.org/10.1080/01457638008939566
  19. Gungor, K. E. and Winterton, R. H. S., 1987, 'Simplified General Correlation for Flow Saturated Boiling and Comparisons of Correlations with Data,' Chem. Eng. Res., Vol. 65, pp. 148-156
  20. Kandlikar, S. G., 1990, 'A General Correlation for Saturated Two-Phase Flow Boiling Horizontal and Vertical Tubes,' Trans. ASME, Vol. 112, pp. 219-228 https://doi.org/10.1115/1.2910348