DOI QR코드

DOI QR Code

Effects of coupled translational-torsional motion and eccentricity between centre of mass and centre of stiffness on wind-excited tall buildings

  • Thepmongkorn, S. (Construction Engineering and Technology Division, Mahanakorn University of Technology) ;
  • Kwok, K.C.S. (Department of Civil Engineering, Hong Kong University of Science and Technology, Department of Civil Engineering, University of Sydney)
  • 발행 : 2002.02.25

초록

Wind tunnel aeroelastic model tests of the Commonwealth Advisory Aeronautical Research Council (CAARC) standard tall building were conducted using a three-degree-of-freedom base hinged aeroelastic(BHA) model. Experimental investigation into the effects of coupled translational-torsional motion, cross-wind/torsional frequency ratio and eccentricity between centre of mass and centre of stiffness on the wind-induced response characteristics and wind excitation mechanisms was carried out. The wind tunnel test results highlight the significant effects of coupled translational-torsional motion, and eccentricity between centre of mass and centre of stiffness, on both the normalised along-wind and cross-wind acceleration responses for reduced wind velocities ranging from 4 to 20. Coupled translational-torsional motion and eccentricity between centre of mass and centre of stiffness also have significant impacts on the amplitude-dependent effect caused by the vortex resonant process, and the transfer of vibrational energy between the along-wind and cross-wind directions. These resulted in either an increase or decrease of each response component, in particular at reduced wind velocities close to a critical value of 10. In addition, the contribution of vibrational energy from the torsional motion to the cross-wind response of the building model can be greatly amplified by the effect of resonance between the vortex shedding frequency and the torsional natural frequency of the building model.

키워드

참고문헌

  1. Bearman, P.W. and Davies, M.E. (1975), "The flow about oscillating bluff structures", Proc. of 4th Int. Conf. Wind Effects on Buildings and Struct., Heathrow, UK, 285-295.
  2. Hart, G.C., DiJulio, R.M.Jr. and Lew M. (1975), "Torsional response of high-rise buildings", J. Struct. Div., ASCE, 101(ST2), 397-416.
  3. Kareem, A. (1985), "Lateral-torsional motion of tall buildings to wind loads", J. Struct. Eng., ASCE, 111(11), 2479-2496. https://doi.org/10.1061/(ASCE)0733-9445(1985)111:11(2479)
  4. Kwok, K.C.S. (1977), "Cross-wind response of structures due to displacement dependent excitations", Thesis presented to the Department of Mechanical Engineering, Monash University, Australia, in fulfilment for the degree of Doctor of Philosophy.
  5. Kwok, K.C.S. and Melbourne, W.H. (1981), "Wind-induced lock-in excitation of tall structures", J. Struct. Div., ASCE, 107(ST1), 57-72.
  6. Kwok, K.C.S., Wilhelm, P.A. and Wilkie, B.G. (1988), "Effect of edge configuration on wind-induced response of tall buildings", Eng. Struct., 10, 135-140. https://doi.org/10.1016/0141-0296(88)90039-9
  7. Kwok, K.C.S., Lakshmanan, N. and Donovan, P.F. (1994), "Development of a special base hinge assembly for stick models", Report PROJ.UNDP/AND/91/011, Structural Engineering Research Centre, Madras, India.
  8. Melbourne, W.H. (1974), "Response of a slender tower to wind excitation", Proc. 5th Australasian Conf. on Hydraulics and Fluid Mechanics, University of Canterbury, New Zealand, 251-257.
  9. Melbourne, W.H. (1975), "Cross-wind response of structures to wind action", Proc. 4th Int. Conf. on Wind Effects on Buildings and Struct., Heathrow, UK, 343-358.
  10. Melbourne, W.H. (1977), "Probability distributions associated with the wind loading of structures", Civil Engineering Transactions, The Institution of Engineers, Australia, CE 19(1), 58-67.
  11. Patrickson, C.P. and Friedmann, P.P. (1979), "Deterministic torsional building response to winds", J. Struct. Div., ASCE, 105(ST12), 2621-2637.
  12. Saunders, J.W. (1974), "Wind excitation of tall buildings with particular reference to the cross-wind motion of tall buildings of constant rectangular cross-section", Thesis presented to the Department of Mechanical Engineering, Monash University, Australia, in fulfilment for the degree of Doctor of Philosophy.
  13. Standards Australia (1989), SAA Loading Code Part 2: Wind Loads, AS1170.2-1989.
  14. Tallin, A. and Ellingwood, B. (1985), "Wind induced lateral-torsional motion of buildings", J. Struct. Eng., ASCE, 111(10), 2197-2213. https://doi.org/10.1061/(ASCE)0733-9445(1985)111:10(2197)
  15. Thepmongkorn, S. and Kwok, K.C.S. (1998), "Wind-induced coupled translational-torsional motion of tall buildings", Wind and Structures, 1(1), 43-57. https://doi.org/10.12989/was.1998.1.1.043
  16. Thepmongkorn, S., Kwok, K.C.S. and Lakshmanan, N. (1999), "A two-degree-of-freedom base hinged aeroelastic (BHA) model for response predictions", J. Wind Eng. Ind. Aerod., 83, 171-181. https://doi.org/10.1016/S0167-6105(99)00070-7
  17. Yip, D.Y.N. (1995), "Wind-induced dynamic response of tall buildings with coupled 3D modes of vibration", Thesis presented to the Department of Mechanical Engineering, the University of Auckland, New Zealand, in fulfilment for the degree of Doctor of Philosophy.
  18. Yip, D.Y.N. and Flay, R.G.J. (1995), "A new force balance data analysis method for wind response predictions of tall buildings", J. Wind Eng. Ind. Aerod., 54/55, 457-471. https://doi.org/10.1016/0167-6105(94)00059-M
  19. Yoshie, R., Kawai, H., Shimura, M. and Wei, R. (1997), "A study on wind-induced vibration of super high rise building by multi-degree-of-freedom model", J. Wind Eng. Ind. Aerod., 69-71, 745-755. https://doi.org/10.1016/S0167-6105(97)00202-X