초록
방전 플라즈마 소결법을 이용하여 건전한 강도를 갖는 다공성 육티탄산 칼륨 휘스커 프리폼을 제조하기 위해서, 여러 소결온도 조건하에서 휘스커 프리폼을 제조한 후 기공률과 압축강도 등을 조사하였다. 그 결과, 소결 온도 900∼950${\circ}C$, 유지시간 10분, 압축하중 40 MPa, 승온속도 50${\circ}C$/min, on-off pulse type 12:2의 조건에서 높은 기공률을 갖는 프리폼을 제조할 수 있었다. 이상의 최적조건에서 제조한 프리폼은 기공률이 15∼37% 범위임에도 불구하고 174∼266 MPa의 비교적 높은 압축강도를 나타내었다. 이와 같은 강도의 향상은 휘스커간의 스파크 플라즈마 방전 및 자기 발열작용의 영향에 기인한 것으로 생각된다. 900${\circ}C$ 이하에서 제조한 휘스커 프리폼의 강도 레벨은 80∼100MPa로 900∼950${\circ}C$의 온도조건에서 제조한 프리폼에 비해 2배 이하의 낮은 값을 나타내었다. 1000 ${\circ}C$에서의 압축강도는 523 MPa로 가장 높은 강도값을 나타내었으나, 약 5%의 낮은 기공률을 나타내었다. 이상의 결과로부터, 비교적 강도가 높고 다공성의 티탄산 칼륨 휘스커를 제조하는데 있어 방전 플라즈마 소결법이 효과적인 것으로 생각된다.
In order to develope the porous $K_2Ti_6O_13$ whisker preform with good strength, the pore characteristics and compressive strength were investigated as a function of spark plasma sintering temperature. As a result, high porous whisker preform were successfully fabricated by sintering at 900∼950${\circ}C$ for 10 min under a pressure of 40 MPa, heating rate of 50${\circ}C$/min and on-off pulse type of 12:2. The whisker preform prepared under above optimum condition showed relatively high compressive strength of 174∼266 MPa, despite of high porosity ranging from 15% to 37%. This improvement in strength was considered to be mainly due to the spark-plasma discharges and the self-heating action between whiskers. The compressive strength of whisker preform, fabricated at sintering temperature less than 900${\circ}C$, showed 80∼100 MPa. This is low strength level less than one half times compared with whisker preform fabricated at 900∼950${\circ}C$. The whisker preform fabricated at 1000${\circ}C$ showed the highest compressive strength of 523 MPa, but resulted in low porosity of ∼5%. Based on above results, it was considered that spark plasma sintering was an effective method for developing high strength and porosity of whisker preform.