DOI QR코드

DOI QR Code

A Study on the Injection Molding for the Light Guide Plate of a Small Sized LCD (2) : Influences of Processing Conditions on the Brightness

소형 LCD 도광판의 사출성형에 관한 연구 (2) : 공정조건이 휘도에 미치는 영향

  • 이호상 (충주대학교 기계설계학과, 나노기술연구소)
  • Published : 2002.08.01

Abstract

For the light guide plate of the TFT-LCD, there have been increasing demands for higher brightness, thin and light-weight design, and lower power consumption. To meet these demands, a micro-prism-type frontlight that integrates a prismatic sheet and a light-guiding plate has been developed. In this paper, the influences of processing conditions on the brightness were studied lot the injection molding of the light guide plate. Based on the experiment with an actual mold, the design of experiments and the neural network theory were used lot choosing the optimal processing parameters to increase the brightness and the uniformity. The verification experiment also showed that the brightness and the uniformity were increased dramatically with the chosen processing conditions.

Keywords

References

  1. Technical Report of IEICE Design of Highly Efficient Waveguide for LCD Backlighting System Suzuki S.;Okada M.(etc.)
  2. Matsushita Technical Journal v.47 no.3 Light-Guiding Plate for Liquid Crystal Display Nagahara T.;Fukui A.(etc.)
  3. Polymer Engineering and Science v.34 Residual Stress Development in Neat Poly(Etheretherketone) Eduljee R.F.;Gillespie J.W.;Maccullough R.L. https://doi.org/10.1002/pen.760340607
  4. Polymer Engineering and Science v.35 Experimental and Theoretical Studies of Shrinkage, Warpage, and Sink Marks of Crystalline Polymer Injection Molded Parts Chang R.Y.;Tsaur B.D. https://doi.org/10.1002/pen.760351505
  5. Polymer Engineering and Science v.35 A Unified K-BKZ Model for Residual Stress Analysis of Injection Molded Three-Dimensional Thin Shapes Chang R.Y.;Chiou S.Y. https://doi.org/10.1002/pen.760352203
  6. Polymer Engineering and Science v.36 Effect of Pressure History on Shrinkage and Residual Stresses-Injection Molding With Constrained Shrinkage Jansen K.M.B.;Titomanlio G. https://doi.org/10.1002/pen.10598
  7. Polymer Engineering and Science v.36 Modeling and Simulation of Thermally Induced Stress and Warpage in Injection Molded Thermoplastics Liu S.J. https://doi.org/10.1002/pen.10468
  8. Polymer Engineering and Science v.36 Residual Thermal Stresses in Injection Molded Products Zoetelief W.F.;Douven L.F.A.;Housz A.J. https://doi.org/10.1002/pen.10585
  9. 강건설계를 이용한 품질공학 김호성(외4인)
  10. Neural network의 이론과 응용 배상현(외2)