Analysis of Vibrating and Electromagnetic Performance According to Switching Angle in SRM

스위칭 각의 변화에 따른 SRM 전자기적 특성 및 진동 특성 분석

  • Lee, Ji-Yeong (Dept.of Electronics Engineering, Changwon National University) ;
  • Ha, Gyeong-Ho (Dept.of Electronics Engineering, Changwon National University) ;
  • Lee, Geun-Ho (Dept.of Electronics Engineering, Changwon National University) ;
  • Jo, Jae-Ok (Dept.of Electronics Engineering, Changwon National University) ;
  • Hong, Jeong-Pyo (Dept.of Electronics Engineering, Changwon National University) ;
  • Gang, Do-Hyeon
  • Published : 2002.08.01

Abstract

Switched Reluctance Motor (SRM) has been not commonly used because of the severe noise and vibration, although it has many advantages as solidity and economical efficiency. The origin of the acoustic noise and vibration in SRM's can be broadly classified into two types, mechanical and magnetic. Therefore this paper verifies the origin of vibration induced by radial magnetic forces from various experiments, and then studies the relationship between the output and vibration characteristics of SRM according to switch-on and off angles. Acceleration, torque and efficiency is measured by changing switching angles. From the comparison and analysis of the experimental results, a proper switching angle is presented for both satisfying electric performance and reducing vibration.

Keywords

References

  1. 스윗치드 릴럭턴스 모터의 기술동향, 리럭턴스모터 조사 전문 위원회, 제8호, 1994
  2. M. Besbes, C. Picod, F. Camus, M. Gabsi, 'Influence of stator geometry upon vibratory behaviour and electromagnetic performances of switched reluctance motors,' IEE Proceeding Electro Power Application, vol. 145, pp. 462-468, 1998 https://doi.org/10.1049/ip-epa:19982163
  3. C. G. C. Neves, et al, 'Vibrational behavior of switched reluctance motors by simulation and experimental procedures,' IEEE Transactions on Magnetics, vol. 34, pp. 3158-3161, 1998 https://doi.org/10.1109/20.717740
  4. 하경호, 홍정표, 김규탁, '스위칭에 따른 전자기 가진력에 의한 스위치드 릴럭턴스 전동기의 고정자 변위해석', 전기학회 논문지, vol. 49B, pp. 20-26, 2000
  5. Philip C. Kjaer, Jeremy J. Gribble, Timothy J. E. Miller, 'High-grade control of switched reluctance machines,' IEEE Transactions On Industry Applications, vol. 33, pp. 1585-1593, 1997 https://doi.org/10.1109/28.649972
  6. J. Faiz, J. W. Finch, 'Aspects of design optimization for switched reluctance motors,' IEEE Transactions On Energy Conversion, vol. 8, pp. 704-713, 1993 https://doi.org/10.1109/60.260984
  7. Kyung-Ho Ha, Jung-Pyo Hong, Gyu-Tak Kim, Ki-Chan Chang, Ju Lee, 'Orbital Analysis of Rotor Due to Electromagnetic Force for Switched Reluctance Motor,' IEEE Transactions on magnetics, vol. 36, pp. 1407-1411, 2000 https://doi.org/10.1109/20.877702
  8. Jung-Pyo Hong, Kyung-Ho Ha, Ju Lee, 'Stator Pole and Yoke Design for Vibration Reduction of Switched Reluctance Motor,' IEEE Transactions on magnetics, vol. 38, 2002 https://doi.org/10.1109/20.996239
  9. Kenneth G. McConnel, Vibration testing, John wiley & Sons
  10. R. S. Colby, F. M. Motier and T. J. E. Miller, 'Vibration modes and acoustic noise in a four -phase switched reluctance motor,' IEEE Trans. Ind. vol. 32, PP1357-1363, 1996 https://doi.org/10.1109/28.556639
  11. R. Krishnan, P. Vijayraghavan, 'State of the art: acoustic noise in switched reluctance motor drives,' Proceedings of the 1998 IEEE IECON. vol. 2, pp. 929-934, 1998 https://doi.org/10.1109/IECON.1998.724218
  12. Pragasen Pillay and William Cai, 'An investigation into vibration in switched reluctance motors,' IEEE Transactions on Industry Applications, vol. 35, 1999 https://doi.org/10.1109/IAS.1998.732316