초록
Ultrasonic travel-times obtained with the LCR ultrasonic technique have shown an ability to distinguish among three aluminum plates. The 244$\times$150mm thick, but differ in heat treatment. One is fully annealed, the second is quenched and then tempered, and the third is heat-treated to T651 plate, as received plate. Travel-times were obtained at four locations on each side of all plates. The data for both sides of each plate clearly are in very close agreement except location 1 of each plate. In order to show travel-time variation throughout the plate areas, the average travel-time for both sides of each plate were calculated. For Plate 1, the travel-time data were the highest and the data of Plate, the travel-time data were the highest and the data of Plate 2 were upper than Plate 3. Finally, the residual stresses for each plate were measured by X-ray diffraction method. The results showed a good relation. These preliminary results indicate that the LCR Ultrasonic Technique may be not only further developed for use in quality control in the manufacture of rolled aluminum plates but also industry.