폐식용유를 이용한 소형 디젤기관의 성능

Performances of the Used Frying Oil on a Small Diesel Engine

  • 발행 : 2001.06.01

초록

This study was carried out to investigate the usability of the used frying oil, which was extracted from soybean, as one of the alternative fuel of a small diesel engine. For the experiment, NO. 2 diesel oil [D], used frying oil [UF], and their volumetric blends were applied and analysis of the properties and compositions of the experimental fuels were conducted. A four cycle diesel engine with single cylinder, water cooling system, maximum output 8.1 ㎾/2,200 rpm was selected and a direct injection chamber and a precombustion chamber were attached alternately. The results obtained were as follows: 1. Engine power (BHP) were increased from 4.13~4.27㎾ to 9.08~9.15㎾ for diesel oil, from 4.05~4.19㎾ to 8.44~8.92㎾ for UF, and from 4.01~4.48㎾ to 8.69~9.16㎾ for blend fuel, as the engine speed increased from 1,000 rpm to 2,200 rpm. The BHP in case of the direct combustion chamber were fluctuated higher than those of the pre-combustion chamber. 2. With the engine speed increased, torque of the engine were increased from 39.50~40.80 N.m to 42.89 N.m, then decreased to 39.44~39.77 N.m for diesel oil, and increased from 38.73~40.04 N.m to 40.12~40.82 N.m then decreased as 36.53~38.76 N.m for UF. Torque of the blend fuels were increased from 38.75~41.76 N.m to 40.47~42.89 N.m then decreased to 37.73~39.78 N.m. There is no significant difference of torque between the type of combustion chambers. 3. The specific fuel consumption of the UF was increased about 20 percent depending on the engine speed variations. And in case of direct injection chamber, about 12 percent lower fuel consumption was observed than that of precombustion chamber. 4. NOx emission of the UF was higher than that of diesel oil at above 1,800rpm of the engine speed. In case of the direct injection chamber, NOx emission was revealed higher about 59 percent than that of the precombustion chamber, depending on the range of the engine speeds. 5. Smoke emission was decreased in case of UF compared with diesel oil on direct injection chamber. When using precombustion chamber smoke emission was a little higher than that of the direct injection chamber were showed at the engine speed range. 6. At all the engine speed range, exhaust gas temperatures were decreased 2~3$^{\circ}C$ for UF used engine compared with those of the diesel oil. The exhaust gas temperature of the direct injection chamber was higher than that of the precombustion chamber by 72$^{\circ}C$. 7. Unburnt materials remained in the cylinder in case of the pre-combustion chamber was smaller and softer than that of the direct combustion chamber. 8. The feasibility of the blend fuel B-1 and B-2 were verified as a direct combustion chamber was attached to the diesel engine, with respect to the power performance of the engine.

키워드

참고문헌

  1. ASAE EP552, Agricultural engineers yearbook Repoting of fuel properties when testing diesel engines with alternative fuels derived from biological materials ASAE
  2. ASTM D4737-90 Standard test method for calculated cetane index by four variable equation ASTM
  3. ASAE Biodiesel: World Status. Liquid Fuels, lubricants and additives from biomass Borgelt,S.C.;T.S. Dolb;L.G. Schumacher
  4. Liquid fuels and industrial products from renewable resources Low-temperature filterability properties of alternative diesel fuels from vegetable oils Dunn,Rovert O.;Marvin O. Bagby.
  5. J. of the ASAE v.25 no.6 Fuel properties of eleven vegetable oils Goering, C. E.;A.W. Schwab;M.J. Daugherty;E.H. Pryde;A.J. Heakin
  6. J. of the ASAE v.30 no.1 Vegetable oils and their effect on farm engine performance Ishii,Y.;R.Takeuchi
  7. J. of the IARU v.32 A review on alternative fuels of the agricultural engine(1),(2), Kim,S.T.;Y.B. Kim;T.S. Chung;D.B. Song;K.H. Cho
  8. Quality characteristics of the D-2 oil Korean Petroleum Quality Inspection Institution
  9. J. of the KSAM v.25 no.6 Performance and emissions characteristics of a diesel engine with some bio-oil fuels La,W.J.;K.H.Cho.
  10. J. of the KSAE v.18 no.4 A study on the operation performance of diesel engine by using of the soybean fuel Lee, K.M.
  11. Liquid fuels and industrial products from renewable resources A continuous process for the conversion of vegetable oils into biodiesel Noureddini,H.;D. Harkey;V. Medikonduru
  12. J. of the ASAE v.29 no.5 Vegetable oil as a diesel fuel: Status and research priorities Peterson, Charles L.
  13. J. of the ASAE v.26 no.2 Soybean oil fuel in a small diesel engine Pryor, Randy W.;Milford A. Hanna;Jack L. schinstock;Leonard L. Bashford
  14. SAE paper 930934 Combustion of soybean oil methy1 ester in a direct injection diesel engine Scholl,Kyle W.;Spencer C. Sorenson
  15. J. of the AEA v.11 no.1 Fueling a diesel engine with methy-ester soybean oil Schumacher,L.G.;S.C. Borgelt;W.G. Hires
  16. Liquid fuels, lubricants and additives from biomass Fueling heavy duty diesel engines with blends of soydiesel and low sulfur diesel fuel Schumacher,L.G.;D.Fosseen;W.Goetz;S.C.Borgelt;W.G. Hires
  17. J. of the KSAM v.9 no.2 Rheological properties of soybean oil ester fuel and additives Suh,S.R.;F.D. Harris
  18. J. of the JSAM v.1 no.1 Operation of a diesel engine using soybean oil Tamura,H.