Journal of Mechanical Science and Technology

  • 제14권1호
  • /
  • Pages.93-102
  • /
  • 2000
  • /
  • 1738-494X(pISSN)
  • /
  • 1976-3824(eISSN)
대한기계학회 (The Korean Society of Mechanical Engineers)
권호 표지

Comparison of Two-Equation Model and Reynolds Stress Models with Experimental Data for the Three-Dimensional Turbulent Boundary Layer in a 30 Degree Bend

  • Lee, In-Sub (Department of Mechanical Engineering, Chung-Ang University) ;
  • Ryou, Hong-Sun (Department of Mechanical Engineering, Chung-Ang University) ;
  • Lee, Seong-Hyuk (Research Institute of Production Engineering, Chung-Ang University) ;
  • Chae, Soo (Kun-Jang College)
  • 발행 : 2000.01.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

The objective of the present study is to investigate the pressure-strain correlation terms of the Reynolds stress models for the three dimensional turbulent boundary layer in a $30^{\circ}$ bend tunnel. The numerical results obtained by models of Launder, Reece and Rodi (LRR) , Fu and Speziale, Sarkar and Gatski (SSG) for the pressure-strain correlation terms are compared against experimental data and the calculated results from the standard k-${\varepsilon}$ model. The governing equations are discretized by the finite volume method and SIMPLE algorithm is used to calculate the pressure field. The results show that the models of LRR and SSG predict the anisotropy of turbulent structure better than the standard k-${\varepsilon}$ model. Also, the results obtained from the LRR and SSG models are in better agreement with the experimental data than those of the Fu and standard k-${\varepsilon}$ models with regard to turbulent normal stresses. Nevertheless, LRR and SSG models do not effectively predict pressure-strain redistribution terms in the inner layer because the pressure-strain terms are based on the locally homogeneous approximation. Therefore, to give better predictions of the pressure-strain terms, non-local effects should be considered.

키워드

참고문헌

  1. Bradshaw, P. and Terrell, M. G., 1969, The response of a turbulent boundary layer on an infinite swept wing to the sudden removal of pressure gradient, NPL Aero Rep. 1305
  2. Durbin, P. A., 1993, On modeling three-dimensional turbulent wall layers, Phys. Fluids, A, 5 (5)
  3. Flack, K. A., and Johnston, J. P., 1993, The near-wall region of a detaching three-dimensional turbulent boundary layer, Int. Conf. On Near-Wall Turbulent Flow, March 15-18, Tempe, Arizona
  4. Fu, S., 1988, Computational modeling of turbulent swirling flows with second-moment closures, Ph. D. Thesis, UMIST, Manchester, England
  5. Gibson, M. M. and Launder, B. E., 1978, Ground effects on pressure fluctuations in the atmospheric boundary layer, J. Fluid Mech. 86, 491-511
  6. Hogg, S. and Leschziner, M. A., 1989, Secondmomentum-closure calculation of strongly swirling confined with large density gradients, Int. J. Heat and Fluid Flow, Vol. 10. No.1, pp. 16-27
  7. Johnston, J. P., 1970, Measurements in a threedimensional turbulent boundary layer induced by a swept, forward-facing step, J. Fluids Eng., Vol. 98, pp. 823-844 https://doi.org/10.1017/S0022112070001623
  8. Johnston, J. P., 1994, Near wall flow in a threedimensional turbulent boundary layer on the end wall of a rectangular bend, AIAA 94-0405
  9. Jones, W. P. and Launder, B. E., 1972, The prediction of laminarization with a two-equation model of turbulence, International Journal of Heat and Mass transfer, vol. 15, pp. 301-314
  10. Launder, B. E., 1986, Low-Reynolds-number turbulence near walls, Rep., TFD/86/4, Dept. of Mech. Eng., UMIST
  11. Launder, B. E. and Spalding, D. B., 1974, The numerical computation of turbulent flow, Computer Method in Applied Mechanics and Engineering, Vol 3, pp. 269-289
  12. Launder, B. E., Reece, G. J. and Rodi, W., 1975, Progress in the development of a Reynoldsstress turbulence closure, J. Fluid Mech., 68, 537 -566
  13. Lin, C. A., 1990, Three-dimensional computations of injection into swirling cross-flow using second moment closure, Ph. D. Thesis, UMIST, Manchester, England
  14. Reynolds, W. C., 1991, Analytical methods in turbulence, ME261B course, Stanford University
  15. Rotta, J. C., 1979, A family of turbulence models for three-dimensional boundary layers, In Turbulent Shear Flows I Springer-Verlag, New York, 267 - 278
  16. Schwarz, W. R. and Bradshaw, P., 1992, Threedimensional turbulent boundary layer in a 30 degree bend: experiment and modeling, Rept. MD-61, Thermosciences Division, Stanford University
  17. Spalart, P. R., 1988, Direct simulation of a turbulent boundary layer up to $Re_{theta}$=1410, J. Fluid Mech. Vol. 187, pp. 61-98
  18. Speziale, C. G., Sarkar, S. and Gatski, T. B., 1991, Modelling the pressure-strain correlation of turbulence: an invariant dynamical systems approach, J. Fluid Mech., 227, 245-272
  19. Wilcox, D. C., 1993, Turbulence Modeling for CFD, DCW Industries Inc. Lacanada California