4원 공중합체 박리형 아크릴 점착제의 특성에 관한 연구

Studies on the Characteristic of Removal Type Pressure-Sensitive Acrylic Adhesives

  • 서영옥 (동아대학교 공과대학 화학공학과) ;
  • 설수덕 (동아대학교 공과대학 화학공학과)
  • Seo, Young-Ok (Department of Chemical Engineering, Dong-A University) ;
  • Seul, Soo-Duk (Department of Chemical Engineering, Dong-A University)
  • 투고 : 2000.05.30
  • 심사 : 2000.07.22
  • 발행 : 2000.09.26

초록

4원 아크릴 점착제를 합성하기 위하여 butyl acrylate(이하 BA), 2-ethylhexylacrylate(이하 2-EHA), methylmethacrylate(이하 MMA), 2-hydroxyethylmethacrylate(이하 2-HEMA)를 사용하였다. 점착제 구조는 FT-IR, 분자량 분포는 GPC로 측정하고 점도, 고형분 그리고 점착력도 조사하였다. 단량체와 용제의 부피비가 1.3:1일 때 점착력이 $160g_f/25mm$이며 가장 범용성이 있었다. 열처리속도가 50 m/min이었을 때 가사시간이 30 s이었으며, 최소 경화시간은 30 s로 확인하였다. 내후성 시험에서 1000 h 경과 후에도 점착력이 $160{\sim}180g_f/25mm$로 거의 일정하게 유지되었고, 점착 잔유물은 없었다.

To prepare acrylic type pressure-sensitive adhesive, quarter polymers were synthesized from butylacrylate (BA), 2-ethylhexylacrylate (2-EHA), methyl methacrylate (MMA), 2-hydroxyethylmethacrylate (2-HEMA). The quarter polymer was identified by FT-IR. Molecular weight was measured by Gel Pearmeation Chromatograhy. Also, viscosity, solid content and peel strength were investigated. The peel strength was $160g_f/25mm$ when the volume ratio of feed monomer to solvent was 1.3:1 and the ratio was relevant to commercial usage. The pot life of adhesive was 30 s at the 50 m/min of heat treatment rate, and it indicated that the minimum drying time was 30 s. Not only weathering resistance keep up peel strength $160{\sim}180g_f/25mm$ after 1000 h, but also no residual remains.

키워드