DECT 단말기용 Switchable VCO 설계 및 제작

Design and Fabrication of Switchable VCO for DECT Handset

  • 발행 : 2000.06.01

초록

DECT 단말기용 Switchable veo를 설계 및 제작하였다. 이중모드 단말기에서는 하나의 veo가 송.수신모 드의 규격을 만족하도록 두 개의 다른 주파수에서 동작되어야 한다. 이중 모드 veo는 하나의 공진부를 스위칭 한 VCO 두 개의 공진부를 스위칭한 veo 그리고 두개의 VCO를 스위칭한 형태가 있다. 본 논문에서는 하나의 공진부를 스위칭한 VCO를 사용하였는데, 핀 다이오드를 사용하여 공진부의 커패시턴스를 스위칭하였다. 측정 결과 바이어스 조건이 3V와 13mA일때 출력전력은 - 6.5 dBm 이상, 25 kHz offset 주파수에서 - 104 dEe/Hz의 위상잡음 특성을 나타내었다. 따라서 제작된 switchable VCO는 DECT 단말기에 적용할 가능함을 알 수 있다.

A switchable VCO for DECT handset is designed and fabricated. In dual mode radios, a single VCO is desired to operate at two different frequencies to meet the requirement of two mode(Tx, Rx). The three design types of switchable VCO are switched resonator VCO, switched mode VCO and dual band VCO. In this paper, we use the switched resonator VCO type using pin diode switch to change the total amount of capacitance in the tank circuit. At the bias condition of 3 V and 13mA, the output power and phase noise are better than6.5dBm and -104dBc/Hz at 25khz offset from the carrier, respectively , across the operating frequency range. From these results, the fabricated switched VCO is applicable to the DECT handset.

키워드

참고문헌

  1. Solid-state microwave power oscillator design Eric Holzman
  2. OM 5045 DECT radio design Phillps Electronics N.V.
  3. Microwave Product Digest Dual band voltage controlled oscillators for personal communication Vari-L
  4. IEEE Trans. MTT v.35 A generalized approach to the design of microwave oscillator Y. Xuan
  5. IEEE Trans. MTT v.32 A technique for the design of microwave transistor oscillators K. L. Kotzebue