한국생산제조학회지 (Journal of the Korean Society of Manufacturing Technology Engineers)

  • 제7권2호
  • /
  • Pages.40-46
  • /
  • 1998
  • /
  • 2508-5093(pISSN)
  • /
  • 2508-5107(eISSN)
한국생산제조학회 (The Korean Society of Manufacturing Technology Engineers)
권호 표지

절삭력에 의한 칩의 형상분류와 칩형상 예측

The Prediction and Classification of the Chip Fomation using Cutting Force

  • 발행 : 1998.04.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

In order to achieve high flexibility in manufacture, chip control is one of the most serious problems at present. The continuous type chip (uncontrolled chip), which interrupts the normal cutting process and damages the operator, tool and workpiece have a higher force ratio. while the controlled chip which is 6 or 9 type and C type, has the values of the force ratio below 0.6 The chips were classified by 4 types. in chip formation and by described chip history during the cutting process. Finally, the feasibility of utilizing force ratios in chip control will be pointed out while comparing generated force signals during the cutting process.

키워드

참고문헌

  1. Int. J. Mach. Tool Des. Res. v.15 The effect of rake face configuration on the curvature of the chip in metal cutting B. Worthington
  2. Annals of the CIRP v.40/1 Chip control in cut-off tools Rotberg, J.;Ber, A.;Wertheim, R.
  3. J.Eng.Ind. Trans. ASME v.81 Controlled contact cutting tools Chao, B. T.;Trigger, K. T.
  4. Int.J.Mech.Sci. v.4 An analysis for orthorgonal cutting with restricted tool-chip contact Oxley, P. L. B.
  5. J. Eng. Ind. Trans. ASME v.86 The theory of plasticity applied to machining with tools Usui, E.;Kikuchi, K.;Hoshi, K.
  6. Int. J. MTDR v.22/4 Cutting tools with restricted contact De Chiffre, L.
  7. Annals of the CIRP v.37/1 The tool restricted contact effect as a major influencing factor in the chip breaking: An experimental analysis Jawahir, I. S.
  8. Int. J. Mach. Tools Manufact. v.32/5 On the interrelationships of some machinability parameters in finish turing with cermet chip forming tool inserts Jawahir, I. S.;Qureshi, N.;Arsecularatne, J. A.
  9. Bulletin of JSME v.5/17 A study on chip breaker Nakayama,K.
  10. Cutting Tool Engineering Power reduction through efficient chip control Bator, J. S.
  11. Annals of the CIRP v.39/1 On the controllability of chip breaking cycles and modes of chip breaking in metal cutting Jawahir, I. S.
  12. Cutting Tool Engineering Power reduction through efficient chip control Bator, J. S.
  13. Annals of the CIRP v.39/1 On the controllability of chip breaking cycles and modes of chip breaking in metal cutting Jawahir, I. S.
  14. Annals of the CIRP v.28/2 Present knowledge of chip control Kluft, W.;Konig, W.;Luttervelt, C.;A. Nakayama