References
- Int. J. Mach. Tool Des. Res. v.15 The effect of rake face configuration on the curvature of the chip in metal cutting B. Worthington
- Annals of the CIRP v.40/1 Chip control in cut-off tools Rotberg, J.;Ber, A.;Wertheim, R.
- J.Eng.Ind. Trans. ASME v.81 Controlled contact cutting tools Chao, B. T.;Trigger, K. T.
- Int.J.Mech.Sci. v.4 An analysis for orthorgonal cutting with restricted tool-chip contact Oxley, P. L. B.
- J. Eng. Ind. Trans. ASME v.86 The theory of plasticity applied to machining with tools Usui, E.;Kikuchi, K.;Hoshi, K.
- Int. J. MTDR v.22/4 Cutting tools with restricted contact De Chiffre, L.
- Annals of the CIRP v.37/1 The tool restricted contact effect as a major influencing factor in the chip breaking: An experimental analysis Jawahir, I. S.
- Int. J. Mach. Tools Manufact. v.32/5 On the interrelationships of some machinability parameters in finish turing with cermet chip forming tool inserts Jawahir, I. S.;Qureshi, N.;Arsecularatne, J. A.
- Bulletin of JSME v.5/17 A study on chip breaker Nakayama,K.
- Cutting Tool Engineering Power reduction through efficient chip control Bator, J. S.
- Annals of the CIRP v.39/1 On the controllability of chip breaking cycles and modes of chip breaking in metal cutting Jawahir, I. S.
- Cutting Tool Engineering Power reduction through efficient chip control Bator, J. S.
- Annals of the CIRP v.39/1 On the controllability of chip breaking cycles and modes of chip breaking in metal cutting Jawahir, I. S.
- Annals of the CIRP v.28/2 Present knowledge of chip control Kluft, W.;Konig, W.;Luttervelt, C.;A. Nakayama