A Study on the Wear of Milling Tool and Relativity of Acoustic Emission in Cutting Process

절삭중 밀링공구의 마멸과 음향방출의 관련성에 관한 연구

  • 윤종학 (서울산업대학교 기계공학과) ;
  • 김동성 (대한상공회의소 직업교육훈련사업단)
  • Published : 1995.07.01

Abstract

This study is focused on the prediction of appropriate tool life by clarifying the correlation between progressive tool wear and AE signal. when rcutting SM45C by End mill in machining center. First of all, end mill have a problem that position of sensor sticking because it is revolution tool, but I think that it can be bained specific character according to sticking Sensor in the Vise. Consequently, the following results have been obtained; 1. Each cutting speed of feed rate over 0.1mm had a tendency to increase linearly according to the RMSAE 2. The level of AE signal at the same cutting area was more sensitive to depth of cut tharn the variation of feed rate 3. In the range of cutting duringqr about 75minqr atqr cutting speed 27m/min flankqr wear turns up aboutqr 0.21mm, aboutqr 0.29mm in the caseqr of about 65minqr at 33/min, qr hereby RMSAE increased rapidly at 0.2mm flank wear, also AE-HIT and CUM-CNTS.

Keywords