Journal of Technologic Dentistry (대한치과기공학회지)
- Volume 3 Issue 1
- /
- Pages.9-16
- /
- 1981
- /
- 1229-3954(pISSN)
- /
- 2288-5218(eISSN)
A comparative study on the relationship of investing medium to vertical occusal change and surface smoothing during denture processing
Resin processing시(時) 매몰재(埋沒材)에 따른 교합고경(咬合高涇) 및 의치표면(義齒表面) 활택도(滑澤度)의 변화(變化)에 관(關)한 연구(硏究)
-
Kim, Uoong-Chul
(Dept. of Dental Laboratory Technology, Junior College of Public Health and Medical Technology, Korea University) ;
- Chung, In-Sung (Dept. of Dental Laboratory Technology, Junior College of Public Health and Medical Technology, Korea University)
- Published : 1981.02.01
Abstract
A comparative study was conducted to evaluate the relationship of investing medium to the amount of vertical occlusal changes and to the differences of surface smoothness during denture construction. Three groups of 20 dentures, 30 sets of upper and lower were fabricated of conventional heatcuring acrylic denture base resin, using silicone-gypsum molding techniques, with or without covering the occlusal surfaces of the teeth by artificial stone and all-gypsum molding techniques. The distance between the two reference points indented by 1/2 round bur on the upper and lower frontal surfaces of each articulator were measured and recorded before processing and again after processing and remounting of each denture on the articulator. The differences between the two recordings indicated the amount of vertical opening during denture processing. The difference of surface smoothness were investigated and determined by 3 observers continual comparing of the two randomly selected dentures with each other, which were seperately selected as pairs from the different two groups of 20. The results obtained were as follows: 1. During resin processing no statistically significant differences of the amount of vertical occlusal changes were detected between any of the two groups of two silicone-gypsum and one allgypsum molding techniques, although the amount of vertical opening was somewhat increased when silicone-gypsum molding technique was used. 2. Surface smoothness of the processed denture was makedly by increased when silicone-gypsum molding technique was used.
Keywords