The effect of permanent magnet in MAP of magnesium alloy for external case of notebook compute
노트북 케이스용 마그네슘의 자기연마가공에서 영구자석의 효과
-
Kim, Sang-Oh
(Department of Mechanical Engineering, Pukyong National University) ;
-
Gang, Dea-Min
(Department of Mechanical Engineering, Pukyong National University) ;
- Kwak, Jae-Seob (Department of Mechanical Engineering, Pukyong National University) ;
-
Jung, Young-Deug
(Department of Mechanical Engineering, Pukyong National University)
- Published : 2008.06.24
Abstract
In previous study, it showed that the MAP was greatly effective polishing process for magnesium plate. But it had lower efficiency than magnetic materials such as SM45C. It was very difficult to cut non-magnetic materials using the MAP process because the process was fundamentally possible by help of a magnetic force. This study aimed to verify analytically formation of the magnetic field in a case of the non-magnetic materials especially focused on magnesium plate. So, In this study, the magnetic density flux was predicted using simulation program. As a result, the magnetic density flux was lower at the center of pole on inductor than outside. It had same result on the experimental verification. And magnetic force was lower according to increase of working gap. So, to improve the magnetic force, permanent magnet was installed under the workpiece. In that case, the magnetic density flux not only at center but also at outside of pole was increased. Therefore, the efficiency of magnetic abrasive polishing was also increased. A design of experimental method was adopted for assessment of parameters' effect on the MAP results of magnesium plate for improving the magnetic force.