Optimum selection of machining parameters of Wire Electrical Discharge Machining using Taguchi method

다구찌 실험계획법을 이용한 와이어 방전가공의 최적 가공조건 선정

  • Published : 2002.10.01

Abstract

The machining parameters for the wire electrical discharge machining(WEDM), including no load voltage, pulse-on time, pulse-off time, wire tension, water flow rata offset etc. should be chosen properly so that a better performance can be obtained An optimum selection of machining parameters relies heavily on the operators technologies and experience. This study presents a method by means of Taguchi method to select optimal machining parameter combination for an cutting speed or surface roughness. Experimental results demonstrate that the machining models are appropriate and the derived machining parameters satisfy the real requirements in notice.

Keywords