스트럿-타이 모델에 의한 콘크리트 T형 교각 코핑부의 설계

Design of RC T-type Pier Coping Using Strut-and-Tie Model

  • 정광회 (한국건설기술연구원) ;
  • 심별 (연세대학교 토목공학과) ;
  • 송하원 (연세대학교 토목공학과) ;
  • 변근주 (연세대학교 토목공학과)
  • 발행 : 2000.10.01

초록

In this study, effective compressive strength and nodal zone of Strut-and-Tie Model are studied to propose a new design method for RC T-type pier coping for prevention of sudden brittle failure. The coping which transmits loads of bridge to pier should be properly designed to retain ductile behavior. In order to carry out this proper design using STM, tie must yield before concrete fails, and a stress at strut should not exceed a certain effective stress. Therefore, reasonable determination of the effective compressive strength of strut by considering stress states at the nodal zone exactly is very important. Since conventional STM is applied under assumption that all nodes are under hydrostatic stress state, actual non-hydrostatic stress state in nodal zone caused by geometrical characteristics, loading conditions, support conditions of structures can not be considered properly. In order to apply STM for design of RC T-type pier coping, the non-hydrostatic stress state of nodal zone is considered and effective compressive strength is proposed. Then, a new design method of RC T-type pier coping which applies the principle of superposition to obtain optimum ductile behavior is rationally designed.

키워드