사각통 드로잉시 테일러드 블랭크의 용접선이동 및 성형성에 관한 연구

A Study on the Weldline Movement and Formability of Tailored Blanks in Square Cup Drawing

Weldline movement of tailored blanks originates from two sources, primary and secondary. Primary movement occurs by geometrical reason, that is, just scratched lines on the no-weld blanks move during drawing to be fitted to geometrical change. Secondary movement is induced by the characteristics of tailored blanks itself. The primary movement was mainly dependent on the weldline location and not affected by the type of material. The secondary movement caused by laser welding and/or small strength difference in this study was not dominant compared with primary movement. The formability of tailored blanks always inferior to those of original blanks. This is due to the existence of hardened weld bead. The closer a weldline is to punch corner where drawing is most active, the worse its formability becomes. This is because the weldline prohibits the drawing process. It was confirmed by measuring diagonal length at the blank corner. The mode of fracture was changed form wall break to draw break when the weldling was close to the punch corner.